稀土配位聚合物荧光探针的制备及其对痕量汞离子的检测

以稀土金属铽离子为发光中心离子,鸟苷酸(GMP)为配体制备得到了能够发射绿色荧光的稀土配位聚合物。并通过加入小牛胸腺DNA溶液进一步增强荧光强度,形成"turn-on"荧光类型的稀土配合物,利用汞离子与小牛胸腺DNA的结合以及与配体GMP的相互作用使荧光猝灭,形成"turn-on-off"类型稀土荧光探针,实现了汞离子的检测。Hg²⁺质量浓度在50～1 200μg·L^-1范围内与体系荧光强度变化程度呈线性关系(I₀-I)/I₀=0.000 2C+0.010 7,相关系数(r²)为0.991 5,检出限为1.5μg·L^-1,相对标准偏差(RSD)为2.3%。对河水中Hg²⁺进行加标回收检测,回收率为98.1%～99.8%,RSD为0.28%～1.9%。     

Quantum chemical calculations of hydration electrostatics and electrochemical oxidation potential of cyclic nitroxide radicals

1. Download high-res image (149KB)
2. Download full-size image

     

Oxidation and reductive bromination of Bis(4-tert-butylphenyl)aminoxyl

One-electron oxidation of bis(4-tert-butylphenyl)aminoxyl with antimony pentachloride and bromine leads to the formation of oxoammonium salts with anions SbCl ₆ ^? and Br ₃ ^? respectively. The salt with the Br ₃ ^? anion converted at heating into a mixture of bromodiphenylamines which formed also from the aminoxyl as a result of previously unknown reaction of three-electron reductive bromination. The mechanisms of these reactions were assumed.     

Microalgae separation by inertia-enhanced pinched flow fractionation

To improve the accuracy and efficiency of ships’ ballast water detection, the separation of microalgae according to size is significant. In this article, a method to separate microalgae based on inertia-enhanced pinched flow fractionation (iPFF) was reported. The method utilized the inertial lift force induced by flow to separate microalgae according to size continuously. The experimental results show that, as the Reynolds number increases, the separation effect becomes better at first, but then stays unchanged. The best separation effect can be obtained when the Reynolds number is 12.3. In addition, with the increase of the flow rate ratio between sheath fluid and microalgae mixture, the separation effect becomes better and the best separation effect can be obtained when the flow rate ratio reaches 10. In this case, the recovery rate of Tetraselmis sp. is about 90%, and the purity is about 86%; the recovery rate of Chlorella sp. is as high as 99%, and the purity is about 99%. After that, the separation effect keeps getting better but very slowly. In general, this study provides a simple method for the separation of microalgae with different sizes, and lays a foundation for the accurate detection of microalgae in the ballast water.     

Coulomb screening in graphene with topological defects

We analyze the screening of an external Coulomb charge in gapless graphene cone, which is taken as a prototype of a topological defect. In the subcritical regime, the induced charge is calculated using both the Green’s function and the Friedel sum rule. The dependence of the polarization charge on the Coulomb strength obtained from the Green’s function clearly shows the effect of the conical defect and indicates that the critical charge itself depends on the sample topology. Similar analysis using the Friedel sum rule indicates that the two results agree for low values of the Coulomb charge but differ for the higher strengths, especially in the presence of the conical defect. For a given subcritical charge, the transport cross-section has a higher value in the presence of the conical defect. In the supercritical regime we show that the coefficient of the power law tail of polarization charge density can be expressed as a summation of functions which vary log periodically with the distance from the Coulomb impurity. The period of variation depends on the conical defect. In the presence of the conical defect, the Fano resonances begin to appear in the transport cross-section for a lower value of the Coulomb charge. For both sub and supercritical regime we derive the dependence of LDOS on the conical defect. The effects of generalized boundary condition on the physical observables are also discussed.     

锌—柠檬酸氢二铵还原体系用于氢化偶氮苯的合成

采用锌-柠檬酸氢二铵溶液还原体系,以偶氮苯为原料合成出氢化偶氮苯.合成反应的最佳反应条件：当偶氮苯用量是0.625 mmol时,偶氮苯与锌的物质的量之比为1：5,0.2 g/mL柠檬酸氢二铵溶液用量5.0 mL,室温,时间约3 min,平均收率90.63％.     

Analysis and optimisation of grooved parallel slider bearings with cavitation

Meccanica - This paper introduces an analytical approach to optimize the textured bearing with cavitation to improve the load support. For this purpose, a grooved parallel slider bearing is...     

Experimental review of the ϒ(1S, 2S, 3S) physics at e+e− colliders and the LHC

The three lowest-lying \mathrm{\Upsilon } states, i.e., \mathrm{\Upsilon }(1S), \mathrm{\Upsilon }(2S), and \mathrm{\Upsilon }(3S), composed of bb¯ pairs and below the BB ¯ threshold, provide a good platform for the researches of hadronic physics and physics beyond the Standard Model. They can be produced directly in e⁺e⁻ colliding experiments, such as CLEO, Babar, and Belle, with low continuum backgrounds. In these experiments, many measurements of the exclusive \mathrm{\Upsilon }(1S) and \mathrm{\Upsilon }(2S) decays into light hadrons, which shed light on the “80% rule” for the Okubo–Zweig–Iizuka suppressed decays in the bottomonium sector, were carried out. Meanwhile, many studies of the charmonium and bottomonium productions in \mathrm{\Upsilon }(1S, 2S, 3S) decays were performed, to distinguish different Quantum Chromodynamics (QCD) models. Besides, exotic states and new physics were also extensively explored in \mathrm{\Upsilon }(1S, 2S, 3S) decays at CLEO, BaBar, and Belle. The \mathrm{\Upsilon }(1S, 2S, 3S) states can also be produced in pp collisions and in collisions involving heavy ions. The precision measurements of their cross sections and polarizations at the large hadron collider (LHC), especially in the CMS, ATLAS, and LHCb experiments, help to understandΥproduction mechanisms in pp collisions. The observation of the sequentialΥsuppression in heavy ion collisions at CMS, LHCb, and ALICE is of great importance for verifying the quark–gluon plasma predicted by QCD. In this article, we review the experimental results on \mathrm{\Upsilon }(1S, 2S, 3S) at e⁺e⁻ colliders and the LHC, and summarize their prospects at Belle II and the LHC.