Static and dynamic binding capacities of human immunoglobulin G on polymethacrylate based mixed-modal, thiophilic and hydrophobic cation exchangers

The aim of this study was to investigate functional increments of ion exchange type ligands, which may improve the performance of mixed-modal ligands for antibody capture out of feed solutions with pH above 6.0 and containing sodium chloride concentrations of 150 mM and higher. For this purpose several functional groups such as sulfonyl, sulfanyl, amide, methoxy, short alkyl and aromatic moieties were tested in combination with a strong sulfonic acid and/or a weak carboxylic acid group. Therefore a series of ligands were synthesized and subsequently coupled onto epoxide activated Fractogel^® EMD. In the first instance, all materials were tested by static binding capacity measurements (SBC) under test conditions, comprising a wide variety of different sodium chloride concentrations and differing pH values ranging from 4.5 to 7.5. From these preliminary experiment it was found that especially the aromatic groups improved the binding of human immunoglobulin G (h-IgG) under isotonic conditions, while other increments, e.g. thiophilic or amide groups, were not able to increase the capacity significantly. Taking the SBC results into account, the most promising materials were investigated under dynamic binding conditions (DBC) with a reduced selection of test conditions (pH 5.5, 6.5 and 7.4 at 75 and 150 mM NaCl). N-benzoyl-homocysteine (material J) and 3,5-dimethoxybenzoyl-homocysteine (material K) showed 100% DBCs of 37 mg/mL and 32 mg/mL in the presence of 75 mM NaCl and pH 6.5. Material L carrying mercaptobenzoic acid as a ligand and tested with the same solution provided a 100% DBC of 68 mg/mL. The influence of Pluronic F68 in a mock feed solution as well as in cell culture supernatant was investigated with the best performing bio-affinity type adsorbent, material L. For the real sample feed subsequent SDS-PAGE was conducted for the collected fractions.     

Nuclear magnetic relaxation in water revisited

In this study, we revisited nuclear magnetic relaxation of (1)H in water at very low Larmor frequencies that has been studied intensively in earlier years. We make use of the recently developed superconducting quantum interference device based ultra-low field NMR technique, which enables much easier access to the longitudinal spin-lattice relaxation time T(1) and the transversal spin-spin relaxation time T(2) below several kHz than traditional field cycling methods. Our data reproduce and complement the earlier results, in that they corroborate the finding of an exchange process with a correlation time of about 0.34 ms at room temperature which can be attributed to the migration of hydronium and hydroxyl ions in neutral water via hydrogen bridges. The corresponding relaxation process is driven by the interaction of the protons with (17)O and contributes to the T(1) and the T(2) relaxation rate by about 0.12 s(-1). In addition, we found evidence of a very slow exchange process at about 100 Hz that has hitherto not been reported.     

Tuning the hydrophobicity of mica surfaces by hyperthermal Ar ion irradiation

The hydrophobicity of surfaces has a strong influence on their interactions with biomolecules such as proteins. Therefore, for in vitro studies of bio-surface interactions model surfaces with tailored hydrophobicity are of utmost importance. Here, we present a method for tuning the hydrophobicity of atomically flat mica surfaces by hyperthermal Ar ion irradiation. Due to the sub-100 eV energies, only negligible roughening of the surface is observed at low ion fluences and also the chemical composition of the mica crystal remains almost undisturbed. However, the ion irradiation induces the preferential removal of the outermost layer of K(+) ions from the surface, leading to the exposure of the underlying aluminosilicate sheets which feature a large number of centers for C adsorption. The irradiated surface thus exhibits an enhanced chemical reactivity toward hydrocarbons, resulting in the adsorption of a thin hydrocarbon film from the environment. Aging these surfaces under ambient conditions leads to a continuous increase of their contact angle until a fully hydrophobic surface with a contact angle >80° is obtained after a period of about 3 months. This method thus enables the fabrication of ultrasmooth biological model surfaces with precisely tailored hydrophobicity.     

Ring-expanded bicyclic β-lactams: a structure-chiroptical properties relationship investigation by experiment and calculations

In the present work, the validity of the helicity rule relating the absolute configuration of the bridgehead carbon atom in bicyclic β-lactams to the sign of the 220 nm band observed in their electronic circular dichroism (ECD) spectra is examined for ring-expanded cephalosporin analogues. To this end, a series of model compounds with a seven-membered ring condensed with the β-lactam unit was synthesized. A key step of their synthesis was either the ring-closing metathesis (RCM) or the free radical cyclization leading to the seven-membered ring with an S, O, or C atom at the 6 position in the bicyclic skeleton. To investigate the scope and limitations of the simple, empirically established helicity rule, a combination of ECD spectroscopy, variable-temperature ECD measurements, X-ray analysis, and time-dependent density functional theory (TD-DFT) calculations was used. A comparison of the experimental ECD spectra with the spectra simulated by TD-DFT calculations gives a reasonable interpretation of the Cotton effects observed in the 240-215 nm spectral range. The results suggest that the helicity rule does not apply to the investigated compounds because of the planarity of their amide chromophore. Thus, these compounds do not constitute an exception to the rule that was established for bi- and polycyclic β-lactams with the nonplanar amide chromophore only.     

XUV free-electron laser desorption of NO from graphite (0001)

We report results of femtosecond laser induced desorption of NO from highly oriented pyrolytic graphite using XUV photon energies of hν = 38 eV and hν = 57 eV. Femtosecond pulses with a pulse energy of up to 40 μJ and about 30 fs duration generated at FLASH are applied. The desorbed molecules are detected with rovibrational state selectivity by (1 + 1) REMPI in the A(2)Σ(+) ← X(2)Π γ-bands around λ = 226 nm. A nonlinear desorption yield of neutral NO is observed with an exponent of m = 1.4 ± 0.2. At a fluence of about 4 mJ/cm(2) a desorption cross section of σ(1) = (1.1 ± 0.4) × 10(-17) cm(2) is observed, accompanied with a lower one of σ(2) = (2.6 ± 0.3) × 10(-19) cm(2) observable at higher total fluence. A nonthermal rovibrational population distribution is observed with an average rotational energy of = 38.6 meV (311 cm(-1)), a vibrational energy of = 136 meV (1097 cm(-1)) and an electronic energy of = 3.9 meV (31 cm(-1)).     

One-dimensional exciton diffusion in perylene bisimide aggregates

The dynamics and mobility of excitons in J-aggregates of perylene bisimides are investigated by transient absorption spectroscopy with a time resolution of 50 fs. The transient spectra are compatible with an exciton delocalization length of two monomers and indicate that vibrational and configurational relaxation processes are not relevant for the spectroscopic properties of the aggregates. Increasing the pump pulse energy and in that way the initial exciton density results in an accelerated signal decay and pronounced exciton-exciton annihilation dynamics. Modeling the data by assuming a diffusive exciton motion reveals that the excitons cannot migrate freely in all three directions of space but their mobility is restricted to one dimension. The observed anisotropy supports this picture and points against direct Fo?rster-transfer-mediated annihilation between the excitons. A diffusion constant of 1.29 nm(2)/ps is deduced from the fitting procedure that corresponds to a maximal exciton diffusion length of 96 nm for the measured exciton lifetime of 3.6 ns. The findings indicate that J-aggregates of perylene bisimides are promising building blocks to facilitate directed energy transport in optoelectronic organic devices or artificial light-harvesting systems.     

Toward optomechanics: maximizing the photodeformation of individual molecules

Designing soft organic materials able to directly convert light into macroscopic motion represents one of the grand challenges in modern chemistry. Optomechanical properties originate from the collection and amplification of many local deformation events in individual photoswitching entities due to their 3D organization. The basic concept of optomechanics is introduced, related recent achievements in the photoactuation of soft materials are highlighted, and a new approach, based on the optimization of the individual photoresponse at the single-molecule level, is outlined. Optomechanical systems constitute a fundamental approach to alternative utilization of solar energy and a platform for the development of future responsive soft materials and composites.     

Enantioselective formal hydration of α,β-unsaturated acceptors: asymmetric conjugate addition of silicon and boron nucleophiles

The direct enantioselective 1,4-addition of water to α,β-unsaturated acceptors is an open challenge in asymmetric catalysis. Enantioselective conjugate addition of either silicon or boron nucleophiles and subsequent enantiospecific oxidative degradation of the carbon-element bond represents, however, an attractive detour. A single extra step thereby enables an indirect enantiocontrolled construction of (in a broader sense) aldols from α,β-unsaturated carbonyl and carboxyl compounds. While that strategy had been obvious for a long time, it was recent stunning progress in transition metal-catalysed activation of interelement linkages that brought about the solution to that long-standing problem. A concise introduction of existing protocols for stereoselective 1,4-addition of oxygen nucleophiles is followed by a comprehensive summary of the recent rapid advances in transition metal-catalysed (and metal-free) asymmetric conjugate transfer of nucleophilic silicon and boron onto α,β-unsaturated acceptors.     

Application of a chiral metal-organic framework in enantioselective separation

A modular approach for the synthesis of highly ordered porous and chiral auxiliary (Evans auxiliary) decorated metal-organic frameworks is developed. Our synthesis strategy, which uses known porous structures as model materials for incorporation of chirality via linker modification, can provide access to a wide range of porous materials suitable for enantioselective separation and catalysis. Chiral analogues of UMCM-1 have been synthesized and investigated for the enantioseparation of chiral compounds in the liquid phase and first promising results are reported.