Understanding energetic disorder in electron-deficient-core-based non-fullerene solar cells

Recent advances in material design for organic solar cells(OSCs) are primarily focused on developing near-infrared nonfullerene acceptors, typically A-DA′D-A type acceptors(where A abbreviates an electron-withdrawing moiety and D, an electron-donor moiety), to achieve high external quantum efficiency while maintaining low voltage loss. However, the charge transport is still constrained by unfavorable molecular conformations, resulting in high energetic disorder and limiting the device performance. Here, a facile design strategy is reported by introducing the "wing"(alkyl chains) at the terminal of the DA′D central core of the A-DA′D-A type acceptor to achieve a favorable and ordered molecular orientation and therefore facilitate charge carrier transport. Benefitting from the reduced disorder, the electron mobilities could be significantly enhanced for the"wing"-containing molecules. By carefully changing the length of alkyl chains, the mobility of acceptor has been tuned to match with that of donor, leading to a minimized charge imbalance factor and a high fill factor(FF). We further provide useful design strategies for highly efficient OSCs with high FF.     

Unidirectional Single-Cycle and Sub-Cycle Pulses

Optics and Spectroscopy - We introduce a simple exact solution of the wave equation in free space. It describes unidirectional finite-energy single-cycle and sub-cycle pulses. Depending on the...     

Analytical Properties of Solid-substrate Electrospray Ionization Mass Spectrometry

Conventional electrospray ionization mass spectrometry (ESI-MS) uses a capillary for sample loading and ionization. Along with the development of ambient ionization techniques, ESI-MS using noncapillary emitters has attracted more interest in recent years. Following our recent report on ESI-MS using wooden tips (Anal. Chem. 83, 8201–8207 (2011)), the technique was further investigated and extended in this study. Our results revealed that the wooden tips could serve as a chromatographic column for separation of sample components. Sequential and exhaustive ionization was observed for proteins and salts on wooden tips with salts ionized sooner and proteins later. Nonconductive materials that contain microchannels/pores could be used as tips for ESI-MS analysis with sample solutions loaded to the sharp-ends only, since rapid diffusion of sample solutions by capillary action would enable the tips to become conductive. Tips of inert materials such as bamboo, fabrics, and sponge could be used for sample loading and ionization, while samples such as tissue, mushroom, and bone could form tips to induce ionization for direct analysis with application of a high voltage.

Anti-diffusion method for interface steepening in two-phase incompressible flow

In this paper, we present a method for obtaining sharp interfaces in two-phase incompressible flows by an anti-diffusion correction, that is applicable in a straight-forward fashion for the improvement of two-phase flow solution schemes typically employed in practical applications. The underlying discretization is based on the volume-of-fluid (VOF) interface-capturing method on unstructured meshes. The key idea is to steepen the interface, independently of the underlying volume-fraction transport equation, by solving a diffusion equation with reverse time, i.e. an anti-diffusion equation, after each advection time step of the volume fraction. As the solution of the anti-diffusion equation requires regularization, a limiter based on the directional derivative is developed for calculating the gradient of the volume fraction. This limiter ensures the boundedness of the volume fraction. In order to control the amount of anti-diffusion introduced by the correction algorithm we propose a suitable stopping criterion for interface steepening. The formulation of the limiter and the algorithm for solving the anti-diffusion equation are applicable to 3-dimensional unstructured meshes. Validation computations are performed for passive advection of an interface, for 2-dimensional and 3-dimensional rising-bubbles, and for a rising drop in a periodically constricted channel. The results demonstrate that sharp interfaces can be recovered reliably. They show that the accuracy is similar to or even better than that of level-set methods using comparable discretizations for the flow and the level-set evolution. Also, we observe a good agreement with experimental results for the rising drop where proper interface evolution requires accurate mass conservation.     

The adsorption of C6H5Cl on Si(111)7 × 7 studied by STM

The adsorption of chlorobenzene on Si(111)7 × 7 at room temperature was studied by scanning tunneling microscopy (STM). Selective chemisorption was observed at different adatom sites. It was found that the center adatoms were more reactive than the corner adatoms, and the faulted half of the unit cell was more reactive than the unfaulted. The mechanism is discussed in terms of the electronic and atomic structures in Si(111)7 × 7. Both preferences indicate that chlorobenzene was present initially in a mobile precursor state.     

M1 gamma strength for zirconium nuclei in the photoneutron channel

Photoneutron cross sections were measured for 91Zr, 92Zr, and 94Zr near the neutron separation energy with quasimonochromatic gamma rays. The data exhibit some extra components around the neutron threshold. A coherent analysis of the photoneutron data for 92Zr together with the neutron capture on 91Zr based on the microscopic Hartree-Fock-Bogoliubov plus quasiparticle random-phase approximation model for the E1 strength has revealed the presence of an M1 resonance at 9 MeV. The microscopic approach systematically shows the same M1 strength in the photoneutron cross section for 91Zr and 94Zr. The total M1 strength is about 75% larger than the strength predicted by the systematics, being qualitatively consistent with the giant M1 resonance observed in the inelastic proton scattering.     

Synthesis of Anthracene Derivatives with Azaacene-Containing Iptycene Wings and the Utilization as a Dopant for Solution-Processed Organic Light-Emitting Diodes

Substituted acene derivatives are regarded as promising materials for organic electronic devices such as organic light-emitting diodes (OLEDs). In particular, anthracene derivatives are known to exhibit good fluorescence property, with the air stability and solubility in common organic solvents expected to give advantages for solution-processed device fabrication. In this study, a series of bistriisopropylsilyl(TIPS)ethynyl anthracene derivatives with azaacene-containing iptycene wings have been synthesized by using condensation reactions. Effects of size of azaacenes on optical properties and packing structures were investigated. UV/Vis absorption and fluorescence spectra indicate that the π-elongation of iptycene units has small effects on the overall π-system, which is also supported by electrochemical measurements. Secondly, single-crystal X-ray analysis implies that the molecules likely have interactions with the iptycene units of adjacent molecules, while the iptycene wings and TIPSethynyl groups can prevent the central anthracene unit from undesirable non-radiative energy loss. Finally, the most emissive derivative was used as a dopant for solution-processed OLEDs, showing obvious electroluminescence with a luminance of over 920 cd m⁻².     

A Compact Representation for Modular Semilattices and Its Applications

Order - A modular semilattice is a semilattice generalization of a modular lattice. We establish a Birkhoff-type representation theorem for modular semilattices, which says that every modular...     

Ligand Control of Palladium-Catalyzed Site-Selective α- and γ-Arylation of α,β-Unsaturated Ketones with (Hetero)aryl Halides

This study describes the first palladium-catalyzed, site-selective α- and γ-arylation of α,β-unsaturated ketones with (hetero)aryl halides. A wide range of hetero(aryl)halides coupled with α,β-unsaturated ketones, and transformation into the arylated products proceeded with excellent to good yields. The site selectivity of the reaction is switchable by simply changing the phosphine ligand to access either α-arylated or γ-arylated products in good to excellent yields by using a low catalyst loading, and the method demonstrates good functional-group compatibility.     

LC–MS/MS analysis of puerarin and 18β-glycyrrhetinic acid in human plasma after oral administration of Samso-eum and its application to pharmacokinetic study

The aim of this study was to confirm pharmacokinetic screening of multiple components in healthy Korean subjects after oral administration of Samso-eum and perform quantitation of active components in the human plasma. Thirteen potential bioactive components [puerarin (PRR), daidzin, nodakenin, ginsenoside Rb1, 18β-glycyrrhetinic acid (18β-GTA), 6-shogaol, naringin, glycyrrhizin, hesperidin, platycodin D, naringenin, hesperetin, and 6-gingerol] were screened based on literature. The results showed that three analytes (daidzin, naringenin, and hesperetin) were detected in trace amounts. In addition, PRR and 18β-GTA were detected in human plasma after the oral administration of Samso-eum. In this study, a liquid chromatography–electrospray ionization-tandem mass spectrometry method was validated for the simultaneous determination of PRR and 18β-GTA in human plasma. This was the first study to evaluate pharmacokinetics of PRR and 18β-GTA after the usual oral dose of Samso-eum (30 g containing 102.48 mg PRR, 48.18 mg glycyrrhizin) in human subjects.