置换法测定气液平衡

本文工作在流通法的原理上提出一种不分析组成测定汽液平衡的新方法。它通过配置样品与汽液平衡测定仪汽相浓度区或液相浓度区的等体积置换,测定配样组成所对应的露点或泡点。置换法的基本原理双循环汽液平衡测定仪在达到操作稳态时,存在着三个浓度区间的划分以及相互之间的物料平衡关系。流通法的基本作法是,将平衡液相回流或平衡汽相回流引出,并以等流量的配制样品注入混合区。溶质量随时间的变化规律为,     

Swelling kinetics and release characteristic of crosslinked chitosan: Polyether polymer network (semi-IPN) hydrogels

The aqueous swelling kinetics of a series of crosslinked chitosan (cr-CS) with glutaraldehyde (GA) interpenetrating polyether hydrogels have been studied as functions of pH, the N-deacetylation degree of chitosan, the amount of crosslinking agent, the electrolyte composition in solution, temperature, and gel composition. Based on these results, the swelling mechanism of the hydrogels was discussed. The release profiles of chlorhexidini acetas from the semi-IPN were also investigated. © 1994 John Wiley & Sons, Inc.     

丙酮在XeCl准分子激光辐射下的多光子电离和碎裂研究

我们用扩散分子束多光子电离光谱技术研究了丙酮在XeCl准分子激光辐射下的多光子电离和碎裂行为。实验表明丙酮没有产生母体离子峰(m/e=58), 只给出m/e=43和15两个峰, 分别对应于丙酮光解所产生的两个碎片CH_3 CO和CH_3。其离子信号(1)分别与激光强度(Ⅰ)的3和3.6次方成正比。分析表明离子是由中性碎片电离产生的。     

About compensation effect by thermal decomposition of some catalyst precursors

Summary In order to obtain catalysts, the thermal decomposition of the precursors is a compulsory step. However, kinetic analysis of the decomposition data obtained under non-isothermal conditions lead very seldom to the intimate reaction mechanism. There is also a lack of information because in non-isothermal kinetics, the compensation effect, is rather a rule and unfortunately a source of debate. In order to discriminate between these processes, and the influence of conversion, respectively temperature on the reaction rate, the NPK (non-parametric kinetic - Sempere and Nomen) method was used. This method is based on the singular value decomposition algorithm (SVD) applied on the matrix of reaction rate at corresponding conversion and temperature. This method allows a less speculative determination of the conversion functions and of the kinetic parameters.     

Solid state a.c. conductivity and FT-IR spectral analyses for the conflicting effects of proton mobility and association in some azophenol derivatives of cyclic phosphazene

Variable strength H-bonding affects the mobility and so electric conduction of protons differently. Also, variable extent mesomerism modifies electric conduction with varying dielectric features. Both these molecular modifiers are properly cited using azophenol derivatives as model compounds for discussion of their consequences in the varying features of electric conduction. The electric permittivity shows low-frequency dispersion characteristic of ionic conduction over mobile charge carries; the mobility shifts at a critical temperature T _c, being structure dependent. The frequency-dependent Z′′-Z′ layout changes with temperature from linear at low temperatures to semicircular above T _c within a frame of temperature-sensitive dipole-ionic mediated conduction. The a.c. conductivity, σ_ac, increases with frequency and temperature and becomes frequency insensitive, like d.c. conductivity, σ_dc, above the T _c because of the escalating contribution from the d.c. conduction. The mesomeric structure seems to prompt a dipole-based electric conduction of high relaxation energy over the strongly associated phenolic protons that may be thermally activated above the T _c into a much lower relaxation energy protonic conduction of up to two orders higher conductivity. The protonic conduction emerges at a T _c that falls with a drop in the relaxation energy following a similar order of increasing proton mobility and mesomerism in the azophenol derivatives: azocatechol>azoquinol>azoresorcinol. On the molecular level, variable temperature infrared spectroscopy reveals higher proton mobility and mesomerism for the azocatechol derivative that demonstrates its higher protonic conductivity at lower T _c and relaxation energy, compared to the azoquinol and azoresorcinol derivatives. This is well verified in the light of conflicting intramolecular H-bonding that assists the proton mobility in azocatechol whereas it associates the protons in azoresorcinol more than in azoquinol. Electronic Publication     

Microwave-assisted extraction of zearalenone from wheat and corn

A microwave-assisted extraction (MAE) method has been developed for determination of zearalenone in wheat and corn by LC-MS with an atmospheric pressure chemical ionization interface (APCI). Matrix effects were minimized by use of matrix-matched standard curves for quantification of the analyte. The limit of quantification (LOQ) of the method was 30 ng g(-1) in wheat and 20 ng g(-1) in corn. The rapid LC-MS method enabled analysis of the extracts without clean-up, thereby reducing analyte losses, the time required for the analytical procedure, and costs. A factorial design approach was used to examine the effect on extraction efficiency of the main extraction conditions - time, temperature, and solvent. On the basis of results from statistical assessment extraction was performed with 1:1 (v/v) methanol-acetonitrile at 80 degrees C for 5 min. When these extraction conditions were applied to a wheat sample from a recently conducted international proficiency test, 92% (103 ng g(-1)) of the assigned zearalenone concentration (112 ng g(-1)) in the test material was obtained. This result was within the uncertainty (u) range of the assigned value of the test material (u=+/-15.8 ng g(-1), alpha=0.05) thereby demonstrating the accuracy of the method was sufficient. The precision of the whole method was also confirmed to be adequate, because the observed relative standard deviation (RSD) of 12% (n=10) also fulfils the quality criteria recommended by European guidelines for in-house method validation.     

Photodegradation of a 1,3,4-thiadiazole-urea herbicide. Isolation,characterization, X-ray crystal structure and synthesis of photoproducts

The photodegradation of 1,3-dimethyl-1-(2-(3-fluorobenzylthio)-1,3,4-thiadiazol-5-yl)urea as a thin film and in solution is described. The two photoproducts from thin-film photolysis were characterized by spectral and synthetic methods. The X-ray crystal structure of one of the photoproducts is also reported. The rearrangements were shown to involve an S-to-N benzyl migration, followed by a sulfur-oxygen substitution.     

Synthesis of 1,2,3,4,8,9,10,11-octahydro-[1,4] diazepino[6,5,4-jk ]earbazole and related compounds

1,2,3,4,8,9,10,11-Octahydro[1,4]diazepino[6,5,4-jk]earbazole (VIa) was synthesized from 2,3,4,5-tetrahydro-1H-benzodiazepine (la) via the route shown in Scheme 1. Other compounds which were prepared similarly are 3-acetyl-6-chloro-1,2,3,4,8,9,10,11-octahydro[1,4]diazepino-[6,5,4-jk]carbazole(Vb) and 3-methyl-1,2,3,4,8,9,10,11-octahydro[1,4]diazepino[6,5,4-jk]carb-azole (VIII). Chemical transformations which were carried out with VI and 3-acetyl-1,2,3,4,8,9, 10,11-octahydro[1,4]diazepino[6,5,4-jk]carbazole (Va) are also described.     

Mathematical studies of Kekulé structures

The perfect matching vector and forcing and the Kekulé-vector of cata-benzenoids are defined. Two theorems are given which set the sufficient and necessary conditions for HKZ-vector (Harary et al. J Math Chem 6:295, 1991) and Kekulé-vector in cata-benzenoids. Additional two theorems are obtained which give sharp bounds for the modules of HKZ- and Kekulé vectors. Dedicated to Professor Tadeusz Marek Krygowski on the happy occasion of his 70th birthday.     

Ordered porous films based on fluorinated polyimide derived from 2,2′-bis(3,4-dicarboxyphenyl) hexafluoropropane dianhydride and 3,3′-dimethyl-4,4′-diaminodiphenylmethane

One of fluorinated polyimides was synthesized from 2,2′-bis(3,4-dicarboxyphenyl) hexafluoropropane dianhydride (6FDA) and 3,3′-dimethyl-4,4′-diaminodiphenylmethane (DMMDA) by two-steps method, which had good solubility and hydrophilicity. 6FDA-DMMDA polyimide was dissolved in chloroform (CHCl₃) and cast on a glass substrate in a humid atmosphere. It was found that 6FDA-DMMDA/CHCl₃ solution was easy to form ordered porous structure at high concentration, and the reason was discussed in detail. In addition, the influences of solution concentration, the atmosphere humidity, were also tested.