Preparation and properties of solvent-soluble bridged polybiphenylenes and related copolymers

A solvent-soluble polybiphenylene with a single hetero atom in the chain (a bridged polybiphenylene) was prepared according to the synthetic procedure for a solvent-soluble poly(4,4′-biphenylene). In addition, a related copolymer was similarly prepared by the addition of the MMA monomer in the reaction system. The thermal properties and viscosity behavior of each product were influenced by the hetero atom, especially by the introduction of MMA component in the chain. Each viscosity curve (η_sp/c vs. c) shows an anomalous peak at a specific concentration (0.3–0.002 g/100 ml DMF), depending upon the atomic group. The η_sp/c value for each homopolymer was not over 0.1 except in the neighborhood of the anomalous peak, while those for copolymers became 3–4 times larger than values for corresponding homopolymers. It is obvious that the viscosity of each copolymer increases due to an increase in flexibility due to introduction of the MMA units in the chain, since little difference in molecular weights is found between homopolymers (16,000–15,000) and copolymers (10,000–12,000).     

Theoretical studies on the photochemical reaction mechanisms of o-xylylene. Effects of phenyl group for electrocyclic reaction mechanism

The potential energy surfaces (PESs) of the electrocyclic reactions of o-xylylene at the ground and the lowest excited states are calculated by CASSCF molecular orbital and MRMP2 methods. The lowest excited state geometry of o-xylylene has C(2v) symmetry and is about 65 kcal mol(-1) in energy above the ground state. The PESs in the vicinity of the conical intersection are different from those of the electrocyclic reaction of cis-butadiene. In the vicinity of the conical intersection, the transition state at the ground state relating to methylene-cycloheptadienyl carbene is located. The transition state is only 4.3 kcal mol(-1) lower in energy than the conical intersection at the CASSCF(10,10)/6-31G(d) level and 0.5 kcal mol(-1) lower at the MRMP2/6-311+G(d,p) level. The transition state corresponding to benzocyclobutene does not locate in the vicinity of the conical intersection because of the resonance energy between benzene ring and methylene group.     

A novel attractive interaction in the Diels–Alder reaction of N-protected pyrroles with allene-1,3-dicarboxylates

The endo/exo selectivities of Diels–Alder reactions of N-protected pyrroles with allene-1,3-dicarboxylates were studied under Lewis acid assisted and thermal reaction conditions. A novel attractive effect between the N-protective carbonyl group of pyrrole and the ester group of allene-1,3-dicarboxylates operates to control the selectivity in the above Diels–Alder reaction. This new attractive effect to give the exo adduct is more effective than the Alder orbital effect.     

CO2-Induced Spin-State Switching at Room Temperature in a Monomeric Cobalt(II) Complex with the Porous Nature

CO₂-responsive spin-state conversion between high-spin (HS) and low-spin (LS) states at room temperature was achieved in a monomeric cobalt(II) complex. A neutral cobalt(II) complex, [Co^II(COO-terpy)₂]⋅4 H₂O ( 1⋅4 H₂O ), stably formed cavities generated via π–π stacking motifs and hydrogen bond networks, resulting in the accommodation of four water molecules. Crystalline 1⋅4 H₂O transformed to solvent-free 1 without loss of porosity by heating to 420 K. Compound 1 exhibited a selective CO₂ adsorption via a gate-open type of the structural modification. Furthermore, the HS/LS transition temperature (T_1/2) was able to be tuned by the CO₂ pressure over a wide temperature range. Unlike 1 exhibits the HS state at 290 K, the CO₂-accomodated form 1⊃CO₂ (P =110 kPa) was stabilized in the LS state at 290 K, probably caused by a chemical pressure effect by CO₂ accommodation, which provides reversible spin-state conversion by introducing/evacuating CO₂ gas into/from 1 .     

Criteria for pericyclic and pseudopericyclic character of electrocyclization of (Z)-1,2,4,6-heptatetraene and (2Z)-2,4,5-hexatriene-1-imine

The electrocyclic reaction mechanisms of (Z)-1,2,4,6-heptatetraene and (2Z)-2,4,5-hexatriene-1-imine were studied by ab initio MO methods. The activation energy barrier height of the electrocyclic reaction of (Z)-1,2,4,6-heptatetraene is extremely a low energy barrier of 8.58 kcal/mol by a MRMP method. The activation energy barrier height of the electrocyclic ring closure of the trans-type of (2Z)-2,4,5-hexatriene-1-imine is lower by 3.18 kcal/mol than that of (Z)-1,2,4,6-heptatetraene. These low energy barriers come from some orbital interactions relating to allene group. For the reaction of (Z)-1,2,4,6-heptatetraene, the interactions of the vertical and side π orbitals of the allene group with another terminal π orbital are important at the transition state. The interaction of the vertical π orbital of allene group with a lone pair orbital of N atom is dominant at the transition state of the reaction of the trans-type of (2Z)-2,4,5- hexatriene-1-imine. The electrocyclic mechanism of the cis-type of (2Z)-2,4,5-hexatriene-1-imine was also discussed. Contribution of the Mark S. Gordon 65th Birthday Festschrift issue.     

Improved performance in dye-sensitized solar cells employing TiO2 photoelectrodes coated with metal hydroxides

The performance of dye-sensitized solar cells (DSCs) was compared before and after processing the TiO(2) electrodes by minute-order electrochemical reactions with metal nitrates, where the metals were Mg, Zn, Al, and La, in 2-propanol. An overcoating of metal hydroxide was formed without the need for a sintering process, and magnesium hydroxide was found to give the largest improvement in photovoltage, fill factor, and eventually overall conversion efficiency of the DSCs. To analyze the nature of the improvement, the diffusion coefficient (D) and electron lifetime (tau) were determined. While little influence of overcoating on D was seen, a correlation between the increase in tau and V(oc) was observed for the metals examined here. The remarkable improvement in the electron lifetime of the DSCs suggests that an overcoating with magnesium hydroxide species function as the blocking layers at the fluorine-doped tin oxide and TiO(2) interfaces, thus contributing to the suppression of electron leakage, i.e., recombination processes between unidirectional transporting electrons and poly-iodides such as tri-iodide in the processed TiO(2) photoelectrode systems. The increase in V(oc) can be explained by the increased electron density caused by the increase in electron lifetime.     

Ion current generation in the field ion microscope: I. dynamic approach

The numbers of gas particles arriving at unit tip surface in unit time from a field free region are derived as functions of velocity components for a spherical tip. It is shown that a considerable fraction of the gas particles arrives at the tip having large tangential velocities. The simple model of collision of a particle with a metal surface is used and the trajectories and rebounds of particles are tracked. The principal method to calculate the total ion current is shown. The capture probability of particles by the dipole attraction potential is shown to increase when the tip temperature is lowered, the field strength is increased, the mass ratio of the gas atom to the metal atom increases and the gas temperature is lowered.