Thermal analysis and X-ray studies of chiral ferroelectric liquid crystalline materials and their binary mixtures

Summary Thermal properties of a homologous series of ferroelectric liquid crystals S-(-)-[4-(2-n-alkoxy-propionyloxy)]biphenyl-4'-[n-alkoxy-(3,5-dimethyl)]benzoate have been investigated by polarizing optical microscopy and differential scanning calorimetry. The mesophases were identified and confirmed by X-ray too. Three binary mixtures were prepared from the individual homologues. In one of the mixtures (Mix1), the ferroelectric SmC* phase has broadened and became enantiotropic. This mesophase remained monotropic in the other two mixtures (Mix2, Mix3). The chiral nematic N* phase did not appear in Mix1, but remained monotropic for the other two mixtures. Two molecular parameters, the layer spacing and the average intermolecular distance have been calculated from the X-ray results for the homologues and their mixtures. An intercalated tail-to-tail packing of molecules was found both in the single compounds and their mixtures resulting in the layer spacing about half of the molecular length of the single compounds.     

Analytical Detectors Based on Microplasma Spectrometry

Miniaturizing all dimensions of apparatus, such as electronics and computers, is the current trend followed by scientists in various fields. The idea of Lab-on-a-Chip has significantly expanded and found its broad applications in analytical chemistry. Microplasmas can act as a sample excitation source and are the miniaturized versions of full-sized plasmas. These can be created in various forms, such as direct current, microwave induced, capacitively coupled and inductively coupled plasmas. Scaling down the size would reduce the amount of gases, liquids and consumables required, as well as the sample analysis time, which in turn would decrease the operating costs. Therefore, several research groups are involved in the development of microplasmas for utilisation in analytical instruments.     

Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication