Application of 28Mg to the kinetic study of Mg uptake by rice plants

The time course of Mg uptake and release using intact rice plants and ²⁸Mg as a tracer is presented. Since there is no conventional Mg tracer available, ²⁸Mg was produced via ²⁷Al(α, 3p)²⁸Mg reaction using a cyclotron. Using the purified ²⁸Mg tracer, it was found that the uptake amount of ²⁸Mg by the rice plants increased linearly during 30 min of application. After ²⁸Mg treatment for 90 min, the roots were sequentially washed with iced solution for 120 min. Within about 10 min, almost all of the ²⁸Mg, that was thought to be weakly bound to the apoplast, was washed away.     

Polymer electrolyte membranes based on polystyrenes with phosphonic acid via long alkyl side chains

A series of polystyrenes with phosphonic acid ( 5 ) via long alkyl side chains (4, 6, and 8 methylene units) were prepared by the radical polymerization of the corresponding diethyl ω‐(4‐vinylphenoxy)alkylphosphonates, followed by the hydrolysis with trimethylsilyl bromide. The resulting phosphonated polystyrene membranes had a high oxidative stability against Fenton's reagent at room temperature. The membranes prepared from 5 exhibited a very low water uptake, similar to that of Nafion 117 over the wide range of 30 to 80% relative humidity (RH). The proton conductivities of these membranes are lower than that of Nafion 117 in the range of 30 to 90% RH, but comparable or higher than those of the reported phosphonated polymers with higher IEC values, such as the phosphonated poly(N‐phenylacrylamide) (PDPAA, IEC: 6.72 mequiv/g) and fluorinated polymers with pendant phosphonic acids (M47, IEC: 8.5 mequiv/g), at low RH conditions despite the much lower IEC values (3.0–3.8 mequiv/g) of these membranes. These results suggest that the flexible pendant side chains of 5 would contribute to the formation of hydrogen‐bonding networks by considering the very low water uptake of these polymers. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2012     

Detection of the optogalvanic effect in flames with a microwave resonant cavity

A new method for the detection of the optogalvanic (OG) effect in a flame has been developed. In the experimental scheme, the reflected microwave power is measured for the detection of the OG effect inside a microwave resonant cavity. In a preliminary experiment, the OG signal of sodium atom aspirated into a propane/O₂ flame was observed at a concentration below 10 ng/ml.