Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Spectral Properties of Thioflavin T and Its Complexes with Amyloid Fibrils

Comparative analysis of the absorption and fluorescence spectra and fluorescence excitation spectra of thioflavin T (ThT) in various solvents and in the composition of amyloid fibrils has shown that ThT, when excited in the region of the long-wavelength absorption band, fluoresces in the spectral region with a maximum at 478–484 nm. The appearance in aqueous and alcohol solutions of a fluorescence band with a maximum near 440 nm has been attributed to the presence in the composition of the ThT preparations of an impurity with an absorption band in the 340–350-nm range. The literature data showing that in glycerol ThT has a wide fluorescence spectrum with two maxima are due to the artifact connected with the use of a high concentration of the dye. It has been suggested that the cause of the low quantum yield of ThT aqueous and alcohol solutions is the breakage of the system of conjugated bonds due to the reorientation of the benzothiozole and benzaminic rings of ThT in the excited state with respect to one another. The main factor determining the high quantum yield of fluorescence of ThT incorporated in fibrils is the steric restriction of the rotation of the rings about one another under these conditions. The suggestions made have been verified by the quantum-chemical calculation of the ThT molecule geometry in the ground and excited states.     

Algorithmic Complexity of a Problem of Idempotent Convex Geometry

Properties of the idempotently convex hull of a two-point set in a free semimodule over the idempotent semiring R _{max min} and in a free semimodule over a linearly ordered idempotent semifield are studied. Construction algorithms for this hull are proposed.     

Critical stretch for formation of a cylindrical void in a compressible hyperelastic material

Formation of a cylindrical void in an infinitely long compressible hyperelastic cylinder under axial and radial stretches is examined. The cavitation phenomenon is viewed here as a bifurcation of a solution with a cavity from the homogeneously deformed configuration, taking place when the applied radial stretch reaches a certain critical value. This amounts to modeling the underlying phenomenon as a kind of elastic instability. A formulation of shooting-method type is presented to derive an equation which gives the critical radial stretch for a prescribed axial stretch. For a special class of hyperelastic solids, called modified Blatz-Ko material, the obtained equation leads to an explicit expression for the critical stretches and stresses. Some analytical as well as numerical calculations are carried out to explicitly obtain the critical values for cavitation. The results are summarized in the form of cavitation curves in the two-dimensional space of axial and radial stretches or stresses. Influence of the axial stretch on the critical radial stretch is discussed. Throughout the paper, the corresponding results for a spherically symmetric void formation are referred to when appropriate and compared with the cylindrical case of the present interest. It is then indicated that in the state of equitriaxial stretch, cavitation into a cylindrical shape is likely to occur at lower stretch than into a spherical one.     

Natural convections in conjugated single and double enclosures

The natural convection in single and double conjugated enclosures are numerically investigated. The single and double enclosures are formed by low conductance walls with finite thickness. The outside vertical surfaces of the conducting walls are of the third kind of boundary condition while the top and bottom outside surfaces are adiabatic. The problem studied is characterized by a dominant horizontal temperature gradient and the thermal boundary conditions at the cavity surfaces can not be specified in priori. Numerical results reveal the characteristics in such kind of enclosures and show the importance of the thermal boundary conditions on the natural convection in enclosures. It is also found that the natural convections in the conjugated double enclosures are basically the same, with a major difference in their fluid temperature levels.     

The probability of generating a soluble subgroup of a finite group

It is proved that for finite groups G, the probability thattwo randomly chosen elements of G generate a soluble subgrouptends to zero as the index of the largest soluble normal subgroupof G tends to infinity.     

Parallel processing of remotely sensed data: Application to the ATSR-2 instrument

Massively parallel computational paradigms can mitigate many issues associated with the analysis of large and complex remotely sensed data sets. Recently, the Beowulf cluster has emerged as the most attractive, massively parallel architecture due to its low cost and high performance. Whereas most Beowulf designs have emphasized numerical modeling applications, the Parallel Image Processing Environment (PIPE) specifically addresses the unique requirements of remote sensing applications. Automated, parallelization of user-defined analyses is fully supported. A neural network application, applied to Along Track Scanning Radiometer-2 (ATSR-2) data shows the advantages and performance characteristics of PIPE.     

Polarization dynamics of longitudinally monomode bipolarized microchip solid-state lasers

This paper is devoted to the polarization dynamics of a longitudinally monomode bipolarized Nd:YAG laser: the low-frequency polarization dynamics of a microchip laser is studied experimentally and theoretically. The intensities and the relaxation oscillation spectrum of orthogonally polarized modes versus the direction of pump polarization is observed. A phase-sensitive model of a longitudinally monomode bipolarized solid-state laser with linear polarized diode laser pump is developed to account for the experimental observations.     

Production of high purity proteins by elution of individual fractions from two-dimensional gels.

Results are presented on the production of purified myocardial proteins from two-dimensional (2-D) gels. Proteins were fixed in a native condition using potassium acetate and then eluted into an aqueous solution. Homogeneous tropomyosin and myosin light chain fractions and a number of nonidentified myocardial proteins present on 2-D gels were obtained.