Dimethylformamide as a carbon monoxide source in fast palladium-catalyzed aminocarbonylations of aryl bromides

Dimethylformamide (DMF) acts as an efficient source of carbon monoxide and dimethylamine in the palladium-catalyzed aminocarbonylation (Heck carbonylation) of p-tolyl bromide to provide the dimethylamide. Addition of amines to the reaction mixture in excess delivers the corresponding aryl amides in good yields. The amines employed, benzylamine, morpholine, and aniline, all constitute good reaction partners. The reaction proceeds smoothly with bromobenzene and more electron-rich aryl bromides, but electron-deficient aryl bromides fail to undergo aminocarbonylation. The reactions are conducted at 180-190 degrees C for 15-20 min with microwave heating in a reaction mixture containing imidazole and potassium tert-butoxide: the latter is required to promote decomposition of the DMF solvent at a suitable rate. The beneficial effects of controlled microwave irradiation as an energy source for the rapid heating of the carbonylation reaction mixture are demonstrated. The carbonylation procedure reported herein, which relies on the in situ generation of carbon monoxide, serves as a convenient alternative to other carbonylation methods and is particularly applicable to small-scale reactions where short reaction times are desired and the direct use of carbon monoxide gas is impractical.     

An insight into the aromaticity of fullerene anions: experimental evidence for diamagnetic ring currents in the five-membered rings of C(60)(6-) and C(70)(6-)

Reduction of the two "closed" [6,6] methanofullerenes, [6,6]C(61)H(2) (1) and [6,6]C(71)H(2) (5), to the corresponding hexaanions with lithium metal causes the bridgehead-bridgehead bonds to open, at least partially, and this change gives rise to diamagnetic ring currents in the resulting homoconjugated six-membered rings (6-MRs). These new ring currents shield the overlying hydrogen atoms on the methylene bridge and induce upfield shifts of 1.60 and 0.11 ppm in their (1)H NMR resonances, respectively. Analogous reduction of the already "open" [5,6]methanofullerenes, [5,6]C(61)H(2) (2) and [5,6]C(71)H(2) (3 and 4), only slightly enhances the shielding of the hydrogen atoms over the homoconjugated 6-MRs (upfield shifts of 0.13, 0.68, and 0.14 ppm, respectively) but leads to exceptionally strong diamagnetic ring currents in the homoconjugated five- membered rings (5-MRs), as evidenced by dramatic shielding of the hydrogen atoms situated over them (upfield shift of 5.01, 6.78, and 1.63 ppm, respectively). The strongest shielding is seen for the hydrogen atom sitting over the 5-MR at the pole of C(71)H(2)(6)(-) (delta = -0.255 ppm) indicating that the excess charge density is concentrated at the poles.     

Radical promoted Wagner-Meerwein-type rearrangement of epoxides in camphoric systems using a Ti(III) radical source

[Chemical reaction: see text] A radical based Wagner-Meerwein-type rearrangement has been observed in camphoric systems. The radical was generated from the epoxide using Cp2TiCl as the radical source. The radical initiator Cp2TiCl was prepared in situ from commercially available Cp2TiCl2 and Zn dust in THF under argon.     

The fate of sulfur-bound hydrogen on formation of self-assembled thiol monolayers on gold: (1)H NMR spectroscopic evidence from solutions of gold clusters

It is demonstrated that thiols can adsorb to gold without losing hydrogen. Dodecyl sulfide-capped gold clusters have been prepared and subjected to ligand exchange reactions in perdeuterated benzene by addition of dodecanethiol and subsequently dodecyl disulfide. It is shown by 1H NMR spectroscopy that dodecanethiol molecules are readily taken up as ligands producing characteristic broad signals corresponding to the alpha-methylene and S-H protons, with chemical shifts close to those found for thiol in solution; these signals are absent in spectra of thiolate-capped clusters. Addition of excess disulfide to such clusters capped with both dialkyl sulfides and thiols leads to the appearance of sharp signals for free dialkyl sulfide and intact thiol. Amounts of thiols up to 50% of the ligand shell are, however, taken up by the clusters under rapid and irreversible loss of hydrogen.     

Determination of tungsten in rocks and minerals by chelate extraction and atomic-absorption spectrometry

An atomic-absorption method for determination of tungsten in rocks and minerals is proposed. The method involves sample decomposition by acid digestion or by pyrosulphate fusion, followed by chelate extraction of tungsten by N-benzoylphenylhydroxylamine in toluene. Atomic-absorption measurements are made on the organic phase aspirated into a nitrous oxide-acetylene flame. Quantitative extraction with efficient separation from other elements is achieved in a single extraction from strong acid media. The method is rapid and reliable in terms of precision and accuracy and is applicable to rocks and minerals containing tungsten in the range from 100 ppm to 15%.     

Rotational spectrum, potential energy surface, and bound states of the weakly bound complex He-N2O

Pure rotational transitions of the weakly bound complex He-N(2)O and three minor isotopomers (He-(14)N(15)NO, He-(15)N(14)NO, and He-(15)N(15)NO) were measured in the frequency region from 6 to 20 GHz. Predictions for the microwave transition frequencies were based on the infrared work by Tang and McKellar [J. Chem. Phys. 117, 2586 (2002)]. In the case of (14)N containing isotopomers, nuclear quadrupole hyperfine structure of the rotational transitions was observed and analyzed. The resulting spectroscopic parameters were used to determine geometrical and dynamical information about the complex. An ab initio potential energy surface was calculated at the coupled cluster level of theory with single and double excitations and perturbative inclusion of triple excitations. This surface was constructed using the augmented correlation consistent polarized valence triple zeta basis set for all atoms with the inclusion of bond functions for the van der Waals bond. Bound state calculations were done to determine the energies of low-lying rovibrational levels that are supported by the potential energy surface. The resulting transition energies agree with the experimental values to 1% or better.     

Synthesis of a tetraazacyclotetradecadiene and a pentaazacyclotetradecatriene

Useful procedures for preparing a novel tetraazacyclotetradecadiene and a pentaazacyclotetradecatriene are reported. J. Heterocyclic Chem., 14, 1097 (1977)     

o-hydroxylmethylphenylchalcogens: synthesis, intramolecular nonbonded chalcogen...OH interactions, and glutathione peroxidase-like activity

[Structure: see text]. The synthesis and characterization of a series of organochalcogen (Se, Te) compounds derived from benzyl alcohol 13 are described. The synthesis of the key precursor dichalcogenides 15, 22, and 29 was achieved by the ortho-lithiation route. Selenide 18 was obtained by the reaction of the dilithiated derivative 14 with Se(dtc)2. Oxidation of 15 and 22 with H2O2 afforded the corresponding cyclic ester derivatives 17 and 24, respectively. Oxidation of selenide 18 with H2O2 affords the spirocyclic compound 19. The presence of intramolecular interactions in dichalcogenides 15 and 22 has been proven by single-crystal X-ray studies. The cyclic compounds 17 and 19 have also been characterized by single-crystal X-ray studies. GP(X)-like antioxidant activity of selenium compounds has been evaluated by the coupled bioassay method. Density functional theory calculations at the mPW1PW91 level on ditelluride 22 have identified a fairly strong nonbonding interaction between the hydroxy oxygen and tellurium atom. The second-order perturbation energy obtained through NBO analysis conveys the involvement of n(O) --> sigma(Te-Te) orbital overlap in nonbonding interaction. Post wave function analysis with the Atoms in Molecules (AIM) method identified distinct bond critical point in 15 and 22 and also indicated that the nonbonding interaction is predominantly covalent. Comparison between diselenide 15 and ditelluride 22 using the extent of orbital interaction as well as the value of electron density at the bond critical points unequivocally established that a ditelluride could be a better acceptor in nonbonding interaction, when the hydroxy group acts as the donor.     

Grafting of monosaccharide derivatives to cellulose acetate

Grafting of 1,2-O-isopropylidene-α-D -xylofuranose to commercial cellulose diacetate has been accomplished by using a boron trifluoride catalyst. The reaction proceeds quickly at 25 and 40°C, resulting in degrees of molar substitution (MS) of 0.37 and 0.34, respectively. If monomer and catalyst are added over an extended period of time to maintain low concentrations, MS values as high as 0.89 and 0.85 are obtained at 25 and 40°C, respectively. Major side reactions are depolymerization of the cellulose acetate backbone and grafted D -xylose and the homopolymerization of the monomer. These side reactions may be minimized by conducting the reaction at 40°C for a short time or by adding monomer and catalyst over an extended period of time. Grafting has also been accomplished by using D -xylose derivatives with various reactive groups at the anomeric carbon atom. The grafted material of MS greater than 0.7 is insoluble in acetone and after deacetylation is soluble in water under alkaline, neutral and acidic conditions. Oxalic acid hydrolysis of the deacetylated material indicates that most of the grafted D -xylose units are in the furanose form. Methylation and hydrolysis of the methylated material shows that 75% of the D -xylose residues are terminal units and indicates the presence of many singly grafted D -xylose residues and a few di-and trisaccharide grafts.     

Spectrophotometric determination of platinum with substituted pyrimidine-2-thiol

The yellow complex of Pt(IV) with 1-pyridyl-4,4,6-trimethyl-1H,4H-pyrimidine-2-thiol (PyTPT) which has maximum absorbance at 430 nm, is studied for the spectrophotometric determination of the metal. Molar absorptivity is 5000 liters mol^?1 cm^?1 and Sandell's sensitivity is 0.039 μg/cm². The determination of Pt(IV) (2.8–8.4 ppm) in the presence of diverse ions is described.