Oils from Wild,Micropropagated Plants,Calli, and Suspended Cells ofEuphorbia characias L.

Applied Biochemistry and Biotechnology - Micropropagated Euphorbia characias plants gave higher yields of crude oil than did wild ones. Leaves of either wild and micropropagated plants contained...     

Chronocoulometric study of the electrochemistry of Prussian blue

During the electrochemical oxidation of Prussian blue (PB) to Prussian yellow (PY), an electrocatalytic oxygen production proceeds at the electrode when aqueous electrolyte solutions are used. The formed oxygen is scavenged by the PY, probably by absorption, and it is consumed during the electrochemical reduction of PY to PB by a heterogeneous chemical reaction of PB with oxygen to PY and hydrogen peroxide. Because of this catalytic regeneration of PY, it is impossible to determine the amount of low-spin iron by chronocoulometry using a potential program in which PB is first oxidized to PY and then the charge is measured to reduce PY to PB. The latter charge is biased by the electrocatalytic PY regeneration.     

New aspects of the electroadsorption of ethyl xanthate on copper electrodes

The interaction of the ethyl xanthate (EX) anion with a copper electrode in a borate buffer solution, pH 9.2, has been investigated by cyclic voltammetry (CV), electrochemical quartz crystal microbalance (EQCM), electrochemical impedance spectroscopy (EIS), and measurements of contact angle (CA) under controlled potential. The results obtained allow establishing that, in the potential range from -0.80 and -0.60 V, two parallel reactions were characterized. These reactions were the ethyl xanthate electroadsorption and the hydrogen evolution reaction (HER). This last reaction has not been described by previous authors. Besides, the EIS measurements show that the mechanism of the HER on copper electrodes is not affected by the presence of a ethyl xanthate species. The EQCM study shows that in the electrodesorption process the departure of each ethyl xanthate species from the copper electrode is accompanied with the simultaneous entry of four to five water molecules. This fact is in accordance with the number of copper atoms involved in the adsorption of one ethyl xanthate species.     

Electroreduction of Aryldiazonium Ion at the Polar and Non-Polar Faces of ZnO: Characterisation of the Grafted Films and Their Influence on Near-Surface Band Bending

ZnO is a strong candidate for transparent electronic devices due to its wide band gap and earth-abundance, yet its practical use is limited by its surface metallicity arising from a surface electron accumulation layer (SEAL). The SEAL forms by hydroxylation of the surface under normal atmospheric conditions, and is present at all crystal faces of ZnO, although with differing hydroxyl structures. Multilayer aryl films grafted from aryldiazonium salts have previously been shown to decrease the downward bending at O-polar ZnO thin films, with Zn−O−C bonds anchoring the aryl films to the substrate. Herein we show that the Zn-polar (0001), O-polar (000 ), and non-polar m-plane (10 0) faces of ZnO single crystals, can also be successfully electrografted with nitrophenyl (NP) films. In all cases, X-ray photoelectron spectroscopy (XPS) measurements reveal that the downward surface band bending decreases after modification. XPS provides strong evidence for Zn−O−C bonding at each face. Electrochemical reduction of NP films on O-polar ZnO single crystals converts the film to a mainly aminophenyl layer, although with negligible further change in band bending. This contrasts with the large upward shifts in band bending caused by X-ray induced reduction.     

A two-step conversion of alpha,beta-unsaturated ketones to their alpha-carbalkoxy or alpha-carbamoyl derivatives

Several enones are converted into their alpha-iodo derivatives in excellent yields and carbonylated with palladium catalysis in the presence of alcohol or amines to the alpha-carbonyl enones in satisfactory yields.     

Kinetic parameters of unsaturated polyester resin modified with poly(ε -caprolactone)

The mineral sabugalite (HAl)_0.5[(UO₂)₂(PO₄)]₂⋅8H₂O, has been studied using a combination of energy dispersive X-ray analysis, X-ray diffraction, dynamic and controlled rate thermal analysis techniques. X-ray diffraction shows that the starting material in the thermal decomposition is sabugalite and the product of the thermal treatment is a mixture of aluminium and uranyl phosphates. Four mass loss steps are observed for the dehydration of sabugalite at 48°C (temperature range 39 to 59°C), 84°C (temperature range 59 to 109°C), 127°C (temperature range 109 to 165°C) and around 270°C (temperature range 175 to 525°C) with mass losses of 2.8, 6.5, 2.3 and 4.4%, respectively, making a total mass loss of water of 16.0%. In the CRTA experiment mass loss stages were found at 60, 97, 140 and 270°C which correspond to four dehydration steps involving the loss of 2, 6, 6 and 2 moles of water. These mass losses result in the formation of four phases namely meta(I)sabugalite, meta(II)sabugalite, meta(III)sabugalite and finally uranyl phosphate and alumina phosphates. The use of a combination of dynamic and controlled rate thermal analysis techniques enabled a definitive study of the thermal decomposition of sabugalite. While the temperature ranges and the mass losses vary due to the different experimental conditions, the results of the CRTA analysis should be considered as standard data due to the quasi-equilibrium nature of the thermal decomposition process. The online version of the original article can be found at     

Development and validation of a glass-silicon microdroplet-based system to measure sulfite concentrations in beverages

Sulfite is often added to beverages as an antioxidant and antimicrobial agent. In fermented beverages, sulfite is also naturally produced by yeast cells. However, sulfite causes adverse health effects in asthmatic patients and accurate measurement of the sulfite concentration is therefore very important. Current sulfite analysis methods are time- and reagent-consuming and often require costly equipment. Here, we present a system allowing sensitive, ultralow-volume sulfite measurements based on a reusable glass-silicon microdroplet platform on which microdroplet generation, addition of enzymes through chemical-induced emulsion destabilization and pillar-induced droplet merging, emulsion restabilization, droplet incubation, and fluorescence measurements are integrated. In a first step, we developed and verified a fluorescence-based enzymatic assay for sulfite by measuring its analytical performance (LOD, LOQ, the dynamic working range, and the influence of salts, colorant, and sugars) and comparing fluorescent microplate readouts of fermentation samples with standard colorimetric measurements using the 5,5′-dithiobis-(2-nitrobenzoic acid) assay of the standard Gallery Plus Beermaster analysis platform. Next, samples were analyzed on the microdroplet platform, which also showed good correlation with the standard colorimetric analysis. Although the presented platform does not allow stable reinjection of droplets due to the presence of a tight array of micropillars at the fluidics entrances to prevent channel clogging by dust, removing the pillars, and integrating miniaturized pumps and optics in a future design would allow to use this platform for high-throughput, automated, and portable screening of microbes, plant, or mammalian cells.

ᅟ

     

Cure kinetics of epoxy resin and thermoplastic polymer

The cure kinetics and morphology of diglycidyl ether of bisphenol A (DGEBA) modified with polyvinyl acetate (PVAc) using diaminodiphenylmethane (DDM) as hardener were investigated through differential scanning calorimetry (DSC) and environmental scanning electron microscopy (ESEM). Isothermal curing measurements were carried out at 150, 120 and 80°C. The kinetic parameters were obtained using the general autocatalytic chemically controlled model. The comparison of the kinetic data indicates that the presence of PVAc does not change the autocatalytic nature of the cure reaction. Two T _g’s were observed in the fully cured samples of the modified systems. ESEM micrographies confirm the biphasic morphology.     

Interrelations between the parasitophorous vacuole of Toxoplasma gondii and host cell organelles.

Toxoplasma gondii, the causative agent of toxoplasmosis, is capable of actively penetrating and multiplying in any nucleated cell of warm-blooded animals. Its survival strategies include escape from fusion of the parasitophorous vacuole with host cell lysosomes and rearrangement of host cell organelles in relation to the parasitophorous vacuole. In this article we report the rearrangement of host cell organelles and elements of the cytoskeleton of LLCMK2 cells, a lineage derived from green monkey kidney epithelial cells, in response to infection by T. gondii tachyzoites. Transmission electron microscopy made on flat embedded monolayers cut horizontally to the apical side of the cells or field emission scanning electron microscopy of monolayers scraped with scotch tape before sputtering showed that association of mitochondria to the vacuole is much less frequent than previously described. On the other hand, all parasitophorous vacuoles were surrounded by elements of the endoplasmic reticulum. These data were complemented by observations by laser scanning microscopy using fluorescent probes from mitochondria and endoplasmic reticulum and reinforced by three-dimensional reconstruction from serial sections observed by transmission electron microscopy and labeling of mitochondria and endoplasmic reticulum by fluorescent probes.     

Palladium-catalyzed Heck reactions of styrene derivatives and 2-iodo-p-carborane

p-Carborane has been vinylated on the 2-B-atom in high yields using the Heck reaction. Thus, the reaction between 2-iodo-p-carborane and various styrenes [4-H-, 4-C(6)H(4)-, 4-Cl-, 4-Br-, 4-NO(2)-, 4-CH(3)O-, and 4-CH(3)-] resulted in the production of the corresponding trans-beta-(2-B-p-carboranyl)styrene in DMF solution when reacted in the presence of silver phosphate and the palladacycle Herrmann's catalyst.