Integral Newton-Type Polynomials with Continual Nodes

We construct an integral Newton-type interpolation polynomial with a continual set of nodes. This interpolant is unique and preserves an operator polynomial of the corresponding degree.     

Crack path instabilities in DCDC experiments in the low speed regime

We studied the low speed fracture regime (10⁻⁴-10⁻⁹ m s⁻¹) in different glassy materials (soda-lime glass, glass ceramics) with variable but controlled length scale of heterogeneity. The chosen mechanical system enabled us to work in pure mode I (tensile) and at a fixed load on double cleavage drilled compression specimen. The internal residual stresses of studied samples were carefully relaxed by appropriate thermal treatment. By means of optical and atomic force microscopy techniques fracture surfaces have been examined. We have shown for the first time that the crack front line underwent an out-of-plane oscillating behavior as a result of a reproducible sequence of instabilities. The wavelength of such a phenomenon is in the micrometer range and its amplitude in the nanometer range. These features were observed for different glassy materials providing that a typical length scale characterizing internal heterogeneities was lower than a threshold limit estimated to few nanometers. This effect is the first clear experimental evidence of crack path instabilities in the low speed regime in a uniaxial loading experiment. This phenomenon has been interpreted by referring to the stability criterion for a straight crack propagation as presented by Adda-Bedia et al. [Phys. Rev. Lett. 76 (1996) 1497].     

An Electroacoustic Investigation of Concentrated Aqueous Suspensions of Calcium Pyrophosphate

The zeta potential of concentrated suspensions of calcium pyrophosphate were investigated using electroacoustics. The particles were negatively charged over the entire pH range studied. It proved impossible to reduce the pH of the suspension below 1.8, but the iso electric point could be estimated to occur at approximately pH 1. Two commercially available dispersants (one cationic and one anionic) were then added in small increments to the suspension in order to follow the change in zeta potential as the dispersants adsorbed onto the particles. From the shape of the curve it was possible to estimate the optimum adsorbed amount of dispersant required to fully coat the particles. The cationic dispersant adsorbed strongly and the optimum dosage was estimated at 2.5 ml of active polymer/kg of powder. Anionic dispersants are known to adsorb onto negatively charged ceramic oxide particles, but the anionic dispersant used in this study did not adsorb onto the negatively charged calcium pyrophosphate particles.     

Finite element method in the solution of the Euler and Navier-Stokes equations for internal flow

Finite element solutions of the Euler and Navier-Stokes equations are presented, using a simple dissipation model. The discretization is based on the weak-Galerkin weighted residual method and equal interpolation functions for all the unknowns are permitted. The nonlinearity is iterated upon using a Newton method and at each iteration the linear algebraic system is solved by a direct solver with all unknowns fully coupled. Results are presented for two-dimensional transonic inviscid flows and two- and three-dimensional incompressible viscous flows. Convergence of the algorithm is shown to be quadratic, reaching machine accuracy in very few iterations. The inviscid results demonstrate the existence of nonunique numerical solutions to the steady Euler equations.     

Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

On 2-ciass field towers of some imaginary quadratic number fields

We construct an infinite family of imaginary quadratic number fields with 2-class groups of type (2, 2, 2) whose Hilbert 2-class fields are finite.     

Matrix effects in the determination of butyltin compounds in environmental samples by GC AA after hydride generation

Experiments for the determination of mono-, di and tri-butyltin (MBT, DBT and TBT) by hydride generation/gas chromatography/atomic absorption spectrometry in various matrices (sediment, suspended matter, mussel, algae and water) have revealed that poor butyltin recoveries are obtained in sediments displaying high sulphur and hydrocarbon contents; very poor recoveries were also observed for TBT in sediments with high chlorophyll pigment contents as well as in algal samples. It was however not clear whether the hydride generatin was inhibited by these infering compounds, as was previously assumed in the case of hydrocarbons, or whether interferences affected the atomization rate. Further studies were performed to solve this problem in order to validate this method in the case of analyses of, for example, oil-contaminated sediment and algae. This paper presents the results obtained. It is concluded here that the poor recoveries were due to an inhibition of hydride generation rather than to interference at the atomization stage.     

X-ray diffraction study of 'side-on fixed' homopolysiloxanes from nematic to smectic C phases

The X-ray patterns for the nematic phase in a series of side-on fixed polysiloxanes show different kinds of diffuse elements which imply complex short range ordering. A systematic structural study of the evolution of the patterns versus two molecular parameters, namely the spacer length and the length of the terminal aliphatic tails, suggests the possible occurrence of a smectic C phase for certain values of these parameters. Taking into account these tendencies, new synthesis led to a nematic-smectic C polymorphism observed for the first time in side-on fixed polysiloxanes.