离子束引起的在Al／Cr双层薄膜界面处的原子混合

用600keV的Kr~ 离子轰击Al/Cr双层薄膜样品进行界面原子反应及相互混合的研究。实验样品是在单晶硅上蒸镀约500nm厚的铝膜,相继再蒸上所需厚度的铬膜而制成的。轰击剂量为2.0×10~(15)-2.5×10~(16)Kr~ /cm~2。用2.0MeVa粒子对轰击前后的样品进行了卢瑟福背散射(RBS)分析,发现界面处有明显的原子混合存在;当轰击剂量≥1.0×10~(16)Kr~ /cm~2时,RBS谱出现有明显的坪台,经拟合计算和x射线衍射(XRD)测量证实确有化合物Al_(13)Cr_2存在;还分别得到了原子混合量及混合效率与轰击剂量的关系;最后对界面处的原子混合机制进行了讨论。     

Preparation of well-aligned carbon nanotubes by pyrolysis of phenolic resin in anodic alumina pores

Well-aligned carbon nanotubes (CNTs) of high quality were synthesized by pyrolysis of phenolic resin at 800 °C in anodic alumina oxide (AAO) pores under argon protection. The innocuous source materials and safe operational conditions permit this method to synthesize well-aligned CNTs in large-scale and low cost. The formation mechanism of the synthesized CNTs is also proposed in this work by a series of visual sketches and is proved with obvious evidence. Firstly, phenolic resin nanotubes form in the template pores through the evaporation of solvent. Heat treatment then transfers these tubes into CNTs.     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

Triterpenoid Constituents of Huperzia miyoshiana

Thirteen triterpenoids, including three new ones, miyoshianois A (1), B (2) and C (3), were isolated from Huperzia miyoshiana. The structures of these new compounds were established as 3-O-dihydroferuloyltohogenol (1), 16-oxo-3β,21β-dihydrox-y-serrat-14-en-24-ferulate (2) and 16-oxo-3a, 21β-dihydroxy-serrat-14-en-24-ferulate (3), respectively, on the basis of their spectroscopic analysis.     

Synthesis,X-Ray Structure and Characterization of a Triruthenium Cluster Complex Ru_3~Ⅲ(μ_3-O)(μ-CH_3COO)_6(py)_2Cl with Four Steps One-electron Redox Processes

Great attention is currently paid to the synthesis of polynuclear transition metal complexes as well as their photochemical, photophysical, and electrochemical properties. The design of multicomponent systems capable of performing useful light- and/or redox-induced function is of special interest1. The oxo-centered carboxylate-bridge trinuclear ruthenium clusters have been investigated extensively during recent decades because they have remarkable electron-transfer properties, intense visibl…     

Time-Resolved Femtosecond Degenerate Four-Wave Mixing in LiNbO3：Fe,Mg Crystal

Forward degenerate four-wave mixing （DFWM） processes are investigated with a femtosecond pulsed laser in lithium niobate crystal doubly-doped with magnesium and iron （LiNbO3：Fe, Mg）. The pulse energy dependence reveals a pure third-order nonlinear response, and the third-order nonlinear susceptibility x^（3） in the material is evaluated to be 4.96 × 10^-13 esu. The time-resolved DFWM process shows a response time of x^（3） shorter than 100fs, which is due to the nonresonant electronic nonlinearities. Our results indicate that LiNbO3 crystals have potentials for ultrafast real-time optical processing systems, which require a large and fast x^（3） optical nonlinearity.     

Endpoint estimates for certain commutators of fractional and singular integrals

In this paper, the authors obtain the endpoint estimates for a class of non-standard commutators with higher order remainders and their variants. Moreover, the authors show that these operators are actually not bounded in certain cases.

     

聚苯硫醚／石墨基双极板复合材料性能的研究

以聚苯硫醚树脂和人造石墨为原料一次模压成型制备双极板复合材料.研究了模压成型过程中加压时机、冷却方式及人造石墨原料对复合材料电导率和弯曲强度的影响.结果表明,制备聚苯硫醚/石墨基双极板材料宜选用石墨化程度较高且结构密实的石墨粉料;采用保温后加压及空气中冷却方式制备的复合材料的综合性能较优.