Studies on the preparation and characterization of monodisperse polystyrene latices V.: The preparation of cationic latices

Summary Methods are described for the preparation of monodisperse polystyrene latices using as initiators, 2-azo-bis-(2-methylpropamidinium) dichloride and 2-azo-bis-(2-isopropyliminazolium) dichloride. The preparations were carried out in the absence of any added surface active agents. The effect on particle size of varying initiator concentration, monomer concentration, temperature and ionic strength was examined and the conditions defined for preparing monodisperse latices, with particles in the size range 0.2 to 1m. Electrophoretic measurements confirmed that the latex particles were cationic. The evidence obtained suggested that the charged sites on the particle surface were amidinium groupings. The latices were not stable at pH values greater than 11 and prolonged heating at 90° also caused coagulation.

---

Zusammenfassung Es wurden Methoden zur Darstellung monodisperser Polystyrol-Latices unter Verwendung von 2-azo-bis-(2-methylpropamidinium)-dichlorid und 2-azo-bis-(2-isopropyliminazolium)-dichlorid als Initiator beschrieben. Die Darstellung erfolgte in Abwesenheit von grenzflächenaktiven Verbindungen. Der Einfluß unterschiedlicher Initiator- und Monomerkonzentrationen, der Temperatur und der lonenstärke auf die Teilchengröße wurde untersucht und die Bedingungen festgelegt, unter denen monodisperse Latices mit Teilchen im Größenbereich von 0,2-1m erhalten werden. Elektrophoretische Messungen bestätigten, daß die Latexteilchen kationisch sind. Die Ladungen auf der Teilchenoberfläche sind Amidiniumgruppen. Die Latices waren bei pH-Werten über 11 nicht stabil; längeres Erhitzen auf 90° führte ebenfalls zur Koagulation.

---

---

With 6 figures and 9 tables     

Chiral Phosphino‐ and (Phosphinooxy)‐Substituted N‐Heterocyclic Carbene Ligands and Their Application in Iridium‐Catalyzed Asymmetric Hydrogenation

Enantiomerically pure iridium complexes with phosphino‐ and (phosphinooxy)‐substituted N‐heterocyclic carbene (NHC) ligands were synthesized. Investigation of their electronic properties showed a similar trans influence of the phosphino (or phosphinooxy) and the NHC units. The complexes were tested in iridium‐catalyzed hydrogenation. While low conversions were observed with unfunctionalized olefins, the catalysts proved to be suitable for hydrogenation of the α,β‐unsaturated ester 20 , allylic alcohol 21 , and imine 22 . The enantioselectivities were, however, moderate.     

Integrated microfabricated systems including a purification module and an on-chip nano electrospray ionization interface for biological analysis

We report here on an integrated microfabricated device dedicated to the preparation of biological samples prior to their on-line analysis by electrospray ionization-mass spectrometry (ESI-MS). This microfluidic device is fabricated using the negative photoresist SU-8 by microtechnology techniques. The device includes a chromatographic module plus an ESI interface for MS. The chromatographic module is dedicated to sample purification and is based on a polymer monolithic phase which includes hydrophobic moieties. The ESI interface is integrated onto the chip and is based on a capillary slot. We present here the integration of these different modules onto a single system that is fabricated via a SU-8-based microtechnology route. We present also their testing for the purification of peptide samples. This started with a partial integration step with the combination of at least two of the modules (microsystem + monolith; microsystem + nib) and their test before the fabrication and testing of fully integrated microsystems.     

Ab initio MO-SCF calculation on a model of anomalous water

Ab initio calculations are carried out on the planar hexamer model of anomalous water using a variety of basis sets. The results are compared to results of similar calculations on free water and water in the ice I-like puckered ring configurations.

---

Zusammenfassung Es werden ab initio-Rechnungen für das planare Hexamer-Modell von anomalem Wasser unter Verwendung mehrerer BasissÄtze durchgeführt. Die Ergebnisse werden mit Resultaten Ähnlicher Rechnungen über freies Wasser und Wasser in der I-Eis Ähnlichen Konfiguration verzerrter Ringe verglichen.

---

Résumé Calculs ab initio sur le modèle hexamérique plan de l'eau anormale en utilisant différentes bases. Les résultats sont comparés à ceux de calculs similaires sur l'eau libre et sur l'eau dans une configuration cyclique compacte analogue à celle de la glace I.

     

Interaction of dextran sulfates with positively and negatively charged silver bromide hydrosols

Summary The effects of dextran sulfates of different molecular weights and charge densities on the stability of positively and negatively charged silver bromide solsin statu nascendi have been studied by means of light scattering.The plots of scattering intensities of a positively charged sol against the concentration of the added dextran sulfates show one pronounced maximum, the position which is independent on the molecular weight of the polyelectrolyte used. The maximum shifts to lower polyion concentrations with dilution of the sol.The effect of polyanions on the stability of silver bromide sols of the same sign of charge were investigated as a function of molecular weight of the polymers, the sol concentration, the charge and the concentration of counterions, and the addition of methanol. Destabilization only occurred if sufficient amount of indifferent electrolyte was present in the system. However, the concentration of counterions necessary to produce a flocculation maximum was lower in the presence of the polyelectrolytes than in their absence. The results obtained were compared with the data on sols containing nonionic dextrans reported earlier.

---

Zusammenfassung Der Einfluß der Dextransulfate von verschiedenen Molekulargewichten und Ladungsdichten auf die Stabilität der positiv und negativ geladenen Silberbromid-Solein statu nascendi wurden durch Lichtstreuung untersucht. Wenn die Intensitäten der Lichtstreuung eines positiv geladenen Silberbromid-Sols gegen die Konzentration der zugesetzten DextranSulfate aufgetragen werden, tritt ein ausgeprägtes Maximum auf, dessen Lage von dem Molekulargewicht des angewandten Polyelektrolyten unabhängig ist. Bei Verdünnung des Sols wird das Maximum zur niedrigeren Konzentration des Polyanions verschoben.Der Einfluß der Polyanionen auf die Stabilität der Silberbromid-Sole mit gleichem Ladungsvorzeichen wurde in Abhängigkeit von dem Molekulargewicht des zugesetzten Dextransulfats, der Solkonzentration, der Ladung und Konzentration der Gegenionen und dem Zusatz von Methylalkohol untersucht. Destabilisierung wird nur in Anwesenheit einer genügenden Menge von Neutralelektrolyten in den untersuchten Systemen beobachtet. Die Konzentration der Gegenionen, die ein Flockungsmaximum verursachen, ist immer niedriger als die kritische Koagulationsmenge derselben Ionen für das gleiche Sol in Abwesenheit von Makroionen. Die Resultate wurden mit den Wechselwirkungen der Silberbromid-Sole mit nichtionogenen Dextranen verglichen, und der Mechanismus der Flockung durch Polyelektrolyte wurde diskutiert.

---

---

5 figures and 1 table

---

Supported by the NSF Grant GP 42331 X.

---

A part of the Ph.D. Thesis by David Lindsay.     

Determination of total mercury in environmental and biological samples by flow injection cold vapour atomic absorption spectrometry

A simple and accurate method has been developed for the determination of total mercury in environmental and biological samples. The method utilises an off-line microwave digestion stage followed by analysis using a flow injection system with detection by cold vapour atomic absorption spectrometry.

The method has been validated using two certified reference materials (DORM-1 dogfish and MESS-2 estuarine sediment) and the results agreed well with the certified values. A detection limit of 0.2 ng g⁻¹ Hg was obtained and no significant interference was observed. The method was finally applied to the determination of mercury in river sediments and canned tuna fish, and gave results in the range 0.1–3.0 mg kg⁻¹.     

Synthetic,spectroscopic, and structural Studies on Lanthanide Complexes of Diphosphazane Dioxide Ligands

Lanthanide nitrate complexes of diphosphazane dioxides Ph₂P(O)N(Prⁱ)P(O)Ph₂ ( 1 ) and (PhO)₂P(O)N(Me)P(O)(OPh)₂ ( 2 ) have been synthesised and studied by conductometry, IR, multinuclear NMR spectroscopic methods and X-ray diffraction. Ligand 2 is accessible by two different methods, viz., by direct oxidation of the phosp(III)azane ligand or by starting from phosph(V)azane chloro precursor. The structure of 2 is confirmed by X-ray diffraction. Crystallographic data for 2 : Triclinic, Space group P1 , a = 10.078(1), b = 10.575(3), c = 12.364(4) Å, α = 75.70(2)°, α = 75.56(1)°, γ = 77.68(1)°, Z = 2, V = 1 220 ų; structure refined to R_F = 0.0459 on 3 495 data with F > 3σ(F). The diphosphazane dioxide ligand exhibits trans geometry in the solid state. The structure of a lanthanide complex, [Pr(NO₃)₃( 2 )₂] ( 14 ) is also determined by X-ray diffraction. Crystallographic data for 14 : Trigonal, Space group P3₂, a = b = 15.710(2), c = 40.067(2) Å, Z = 6, V = 8 564 ų; structure refined to R_F = 0.0430 on 8 077 data with F > 5σ(F). The two diphosphazane dioxide ligands and the nitrate groups are coordinated to praseodymium in a bidentate chelate fashion. The geometry around the ten coordinated metal is distorted bicapped square antiprism.     

An automated FTIR method for the routine quantitative determination of moisture in lubricants: An alternative to Karl Fischer titration

An accurate primary Fourier transform infrared (FTIR) method for the determination of moisture in mineral and ester based lubricants has been developed based on the extraction of moisture into dry acetonitrile. FTIR evaluation of acetonitrile extracts from new and used lubricants as well as common lubricant additives and contaminants which might co-extract indicated that phenolic constituents interfered significantly with moisture measurements. By measuring moisture at 3676 cm⁻¹ on the shoulder of the asymmetric OH stretching band, spectral interferences from extracted phenolic constituents were minimized. The spectra of calibration standards (0-2100 ppm), prepared by gravimetric addition of water to dry acetonitrile, were recorded in a 1000-μm CaF₂ transmission flow cell and produced linear standard curves having an S.D. of ∼±20 ppm. Lubricant sample preparation involved the vigorous shaking (20 min) of a 1:1.5 (w/v) mixture of lubricant and dry acetonitrile, centrifugation to separate the phases, acquisition of the FTIR spectrum of the upper acetonitrile layer, and subtraction of the spectrum of the dry acetonitrile used for extraction. A Continuous Oil Analyzer and Treatment (COAT^®) FTIR system was programmed to allow the automated analysis of acetonitrile extracts, and the methodology was validated by analyzing 58 new and used oils, independently analyzed by the Karl Fischer (KF) method. Linear regression of FTIR versus KF results for these oils produced a linear plot with a between-method S.D. of ±80 ppm. As implemented on the COAT^® system, this FTIR method is capable of analyzing 72 acetonitrile extracts/h and provides a high-speed alternative to the KF titrimetric procedures for the determination of water in lubricants.     

Inter- and intramolecular potential for the N-formylglycinamide-water system. A comparison between theoretical modeling and empirical force fields

An intramolecular NEMO potential is presented for the N-formylglycinamide molecule together with an intermolecular potential for the N-formylglycinamide-water system. The intramolecular N-formylglycinamide potential can be used as a building block for the backbone of polypeptides and proteins. Two intramolecular minima have been obtained. One, denoted as C5, is stabilized by a hydrogen bonded five member ring, and the other, denoted as C7, corresponds to a seven membered ring. The interaction between one water molecule and the N-formylglycinamide system is also studied and compared with Hartree-Fock SCF calculations and with the results obtained for some of the more commonly used force fields. The agreement between the NEMO and SCF energies for the complexes is in general superior to that of the other force fields. In the C7 region the surfaces obtained from the intramolecular part of the commonly used force fields are too flat compared to the NEMO potential and the ab initio calculations. We further analyze the possibility of using a charge distribution obtained from one conformation to describe the charge distribution of other conformations. We have found that the use of polarizabilities and generic dipoles can model most of the changes in charge density due to the different geometry of the new conformations, but that one can expect additional errors in the interaction energies that are of the order of 1 kcal/mol.     

Proton transfers in hydrogen bonded systems. Electron correlation effects in (H3NHOH2)+

The energetics of proton transfer between the N and O atoms of (H₃NHOH₂)⁺ are calculated via ab initio molecular orbital methods. A single-well potential is obtained at the equilibrium intermolecular separation Inclusion of electron correlation via the POL CI technique produces a less steep potential, reducing the energy barrier to proton transfer at greater NO distances.