A study of structural, compositional and optical properties of spray-deposited non-stoichiometric (Zn,Fe)S thin films

Non-stoichiometric ternary chalcogenides (Zn,Fe)S were prepared in the film form by pyrolytic spray deposition technique, using air/nitrogen as the carrier gas. The precursor solution comprised of ZnCl₂, FeCl₂ and thiourea. The depositions were carried out under optimum conditions of experimental parameters viz. carrier gas (air/nitrogen) flow rate, concentration of precursor constituents, nozzle substrate distance and temperature of quartz substrate. The deposited thin films were later sintered in argon at 1073 K for 120 min.The structural, compositional and optical properties of the sintered thin films were studied. X-ray diffraction studies of the thin films indicated the presence of (Zn,Fe)S solid solution with prominent cubic sphalerite phase while surface morphology as determined by scanning electron microscopy (SEM) revealed a granular structure.The chemical composition of the resulting thin films as analyzed by energy dispersive X-ray analysis (EDAX) reflected the composition of the precursor solutions from which the depositions were carried out with Fe at% values ranging from 0.4 up to 33.SEM micrographs of thin films reveal that the grain sizes of the thin films prepared using air as carrier gas and N₂ as carrier gas are in the vicinity of 300 and 150 nm, respectively.The diffuse transmittance measurements for thin films, as a function of wavelength reveal the dependence of direct optical band gap on Fe content and type of phase.     

Electrical properties and Schottky diodes using N-N′diphenyl-1-4phenylenediamine

Thin films of, N-N′diphenyl 1-4phenylene-diamineane are prepared using vacuum sublimation technique. The electrical conductivity from room temperature down to 127 K is studied. It is found that the conduction of charge carriers obeys T^−1/2 dependence on temperature. The average hopping distance, hopping energy, density of states and their variation due to post-deposition heat treatment are studied. Schottky diodes are fabricated with gold as ohmic contact and aluminium as Schottky contact. From the observed current voltage characteristics the saturation current density, diode ideality factor and the barrier height are determined. Their variation with air annealing is also investigated.     

Study of thermal currents in powder β-spodumene ceramics doped with Cuo, FeO and TiO2

Ternary-phase ceramic system of Li₂O Al₂O₃ 4SiO₂ doped with CuO, FeO and TiO₂ has been prepared and subjected to dc electrical conductivity and thermally stimulated depolarization current (TSDC) measurements as a function of temperature (30-250 °C) and field strength. The electrical conductivity results are explained by assuming both ionic and electronic conduction mechanisms coexist with different contributions over the whole temperature range of experiments. TSDC spectra have been found to be characterized by a broad intense relaxation peak, which can be attributed to an ionic charge polarization. The broad relaxation transitions are apparently a result of the nonuniform nature of this process. Activation energies are calculated for both dc electrical conductivity and TSDC according to Arrhenius equation and initial rise method, respectively.     

Maximizing a Linear Fractional Function on a Pareto Efficient Frontier

We consider the problem of maximizing a linear fractional function on the Pareto efficient frontier of two other linear fractional functions. We present a finite pivoting-type algorithm that solves the maximization problem while computing simultaneously the efficient frontier. Application to multistage efficiency analysis is discussed. An example demonstrating the computational procedure is included.     

A study of formation of solid ionic conductors in the mixed system (CdI2)b[(Ag2O)·(CrO3)]100-b (20≤b≤80)

Using Wagner's polarization technique and EMF method the joinic and silver ionic transport number measurements of various compositions of the mixed system CdI₂-Ag₂O-CrO₃ have been made. The presence of AgI in these materials has been inferred from the typical β → α phase transition of AgI, which is characterized by an endothermic peak at around 420 K in the DSC traces of these specimens. While the structural analysis performed by means of powder X-ray diffraction has revealed the formation of ionic phases involving polycrystalline compounds, the Fourier transform infrared (FTIR) spectroscopic results have indicated the presence of ionic species thus confirming the ionic nature of the products. The complex impedance studies carried out in the frequency range 20 Hz - 1 MHz and over the temperature range 294 – 442 K have revealed that the best conducting composition, namely 55%(CdI₂) – 45%(Ag₂O·CrO₃), would exhibit a silver ionic conductivity of 1.3×10⁻⁵Scm⁻¹ at 294 K.     

Probe measurements in a discharge with liquid nonmetallic electrodes in air at atmospheric pressure

Discharges with liquid nonmetallic electrodes of much interest for applications are investigated. It is found that a dc discharge between two streams of tap water in air at atmospheric pressure is stable at a currentof 40≤I≤100 mA. The discharge exists in the diffuse (volume) form with a relatively low current density (∼0.2 A/cm²) and a high (above one kilovolt) voltage drop across the air gap (∼1 cm) between the water electrodes. The current density and voltage depend only slightly on the discharge current. Probe measurements show that three regions can be distinguished in the discharge: two electrode regions (1–2 mm in length) and a discharge column with a constant electric field of ≈0.8 kV/cm (i.e., E/N≈20 Td, because the gas in the discharge is heated up to 1500–2000 K). The average electric field strength near the electrodes is E≈2–3×10³ V/cm (E/N≈60–80 Td). The charged particle density in the column is n ∼ 10¹² cm⁻³. The probe measurements of n agree with the previous microwave absorption measurements. The water vapor concentration in the column is also estimated from probe measurements.     

Calculations of the Pressure of Polymorphic Transformation in Small Alkali-Halide Crystals

The present paper analyzes the properties of structural phase transitions under the extremal conditions of high pressures. In the context of the theory of density functional (TDF), the pressures of the B1–B2 transitions are calculated for small alkali-halide crystals as functions of the crystal size. The size effect of the B1–B2 transition – an increase in the transition pressure with the decreasing crystal grain radius – has been established for all investigated halides except lithium fluoride for which the dependence is reverse.     

Application of pressure sensitive paint measurement to a low-solidity cascade diffuser of a transonic centrifugal compressor

A pressure sensitive paint (PSP) measurement has been known as a pressure field measurement technique based on the oxygen quenching phenomenon of luminescence of specific luminophores. A PSP measurement was applied for pressure field measurement in a low-solidity circular cascade diffuser of a single-stage transonic centrifugal compressor with 5 in pressure ratio for HFC134a gas. The oxygen concentration was about 500 ppm. Ru (bath-phen) was adsorbed on a silica-gel thinlayer chromatography sheet, and the sheet was pasted onto the side-wall between the cascade vanes. A drastic change in luminescent intensity was recognized during a surge condition. Also the pressure variations based on luminescent intensity agreed well with the pressure fluctuations measured using a semiconductor pressure sensor with high-frequency-response. It was shown that a PSP measurement worked well to investigate the unsteady pressure fields in a circular cascade diffuser of a transonic centrifugal compressor. Moreover, the time response of PSP becomes clear as a problem to be overcome for the present.     

Effect of gamma irradiation on photoconversion characteristics of metal/gallium arsenide barrier structures with textured interface

The effect of ⁶⁰Co gamma irradiation at doses of 10³-2×10⁵ Gy on the photoconversion and dark I-V characteristics of Au/GaAs surface-barrier solar cells (SCs) is studied. The morphology of the interface microrelief is varied to reach the highest photoconversion efficiency. Of the two types of microrelief morphology (dendritic and quasi-grating) obtained by the chemical anisotropic etching of n-(100)GaAs, the latter is more promising, particularly for SCs designed for space application, since the associated SCs offer higher efficiency and radiation resistance.     

On the Determination of the Absolute Intensities of Vibrational-Rotational Lines of XY3 Molecules with C 3v Symmetry

Analytical formulas are derived that describe the dependences of the transition probabilities in vibrational-rotational spectra of XY₃-type molecules with C _3v symmetry on the rotational quantum numbers.