Sets of tiles with a prescribed number of tilings

Summary For every k2 and r1 there exists a set of k prototiles that admits exactly r distinct tilings. All the tilings obtained are periodic.     

Two-photon absorption in quadrupolar pi-conjugated molecules: influence of the nature of the conjugated bridge and the donor-acceptor separation

Quadrupolar-type substitution of pi-conjugated chromophores with donor and acceptor groups has been shown to increase their two-photon absorption (TPA) response by up to two orders of magnitude. Here, we apply highly correlated quantum-chemical calculations to evaluate the impact of the nature of conjugated bridge and the charge-transfer distance on that enhancement. We compare chromophores with phenylenevinylene-, thienylenevinylene-, polyene-, and indenofluorene-type backbones substituted by dimethylamino and cyano groups. In all compounds, we find a strongly TPA-active A(g) state (either 2A(g) or 3A(g)) in the low-energy region, as well as a higher lying TPA-active state (mA(g)) at close to twice the energy of the lowest lying one-photon allowed state; the smaller energy detuning in the mA(g) states results in very large TPA cross sections delta. We also investigate the influence of the degree of ground-state polarization on TPA. Independent of the nature of the backbone and the donor-acceptor separation, delta displays the same qualitative evolution with a maximum before the cyanine-like limit; the highest TPA cross sections are calculated for distirylbenzene- and polyene-based systems.     

The thermally stable silylene Si[(NCH2Bu)2C6H4-1,2]: reaction with pyridine and quinoline

Two equivalents of the thermally stable silylene Si[(NCH₂Bu^t)₂C₆H₄-1,2] (1) react with pyridine to yield the 1-aza-2,3-disilacyclobutane derivative (2), which is labile and slowly rearranges via a 1,3-H shift to the 2-pyridyldisilane (3). A similar reaction of 1 with quinoline gives 1-aza-2,3-disilacyclobutane derivative (4), which is stable. The X-ray structures of 2 and 3 are discussed.     

Comparative studies of static dipole polarizabilities of ionic crystals on the basis of different self-consistent potentials

The static dipole polarizabilities, ^D , have been studied for the ions O^2–, F^–, Na⁺, Mg²⁺, Cl^–, K⁺ and Ca²⁺ in the crystals NaF, KF, NaCl, KC1, MgO and CaO. The starting zero-order wave functions have been generated using various exchange- and exchange-correlation potentials in order to study the effect of these potentials on ^D . The direct contribution to the dipole polarizability, _o ^D , has been determined by the uncoupled Hartree-Fock method. Self-consistency effects have been included by the geometric approximation. The crystal potential is incorporated using the Watson sphere model. Good agreement between theoretical and experimental results are found for those self-consistent potentials which exclude self-interaction.     

1,4-Addition of benzene to a dihydrocyclopent[a]indene diradical: synthesis and DFT study

Photochemical cyclization of compound 1, a homoenediyne (-CCC=CCH2CC-) bearing two ethynylanthracene chromophores, yields two isomeric dihydrocyclopent[a]indene ring systems, spiro-fused to the 9-position of a 9,10-dihydroanthracene moiety. Evidence of a photochemically initiated diradical cyclization pathway is proposed on the basis of (i) hydrogen abstraction from reaction with 1,4-cyclohexadiene (1,4-CHD) and (ii) the observation of 1,4-addition of benzene (solvent). The reaction was further analyzed by a complete density functional theory (DFT) study, using an unrestricted approach (UBLYP) with a 6-31G* basis set for the open-shell triplet states of the reactants, products, and diradical intermediates to model the photochemical nature of observed transformation. A mechanism detailing the observed cyclization/addition reaction is proposed.     

High mobility of dithiophene-tetrathiafulvalene single-crystal organic field effect transistors

Single-crystal field effect transistors of the organic semiconductor dithiophene-tetrathiafulvalene (DT-TTF) were prepared by drop casting. Long, thin crystals connected two microfabricated gold electrodes, and a silicon substrate was used as a back gate. The highest hole mobility observed was 1.4 cm2/Vs, which is the highest reported for an organic semiconductor not based on pentacene. A high ON/OFF ratio of at least 7 x 105 was obtained for this device.     

Analysis of blackbody-like radiation from laser-heated gas-phase tungsten nanoparticles

Thermal (blackbody-like) radiation that originated from laser-heated tungsten nanoparticles was measured using optical emission spectroscopy. The nanoparticles were generated via ArF excimer laser-assisted photolytic decomposition of WF6/H2/Ar gas mixtures, and the laser heating was applied parallel to the deposition. The temperature of the nanoparticles was determined, and its dependence on time, with respect to the 15-ns laser pulse (full width at half-maximum, fwhm) and laser fluence (phi), has been presented. At phi > 90 mJ/cm2, the particles reached the melting point (shortly after the laser pulse). Dominant cooling mechanisms, such as evaporation (above approximately 3000 K) and a combination of heat transfer by the ambient gas and radiative cooling (below approximately 3000 K), were observed for the nanoparticles, which were approximately 10 nm in diameter. The degree of inelasticity for the (predominantly) argon-gas collisions and the total emissivity of the particles (in the 2500-3000 K temperature region) could also be derived. The measured cooling rate and temperature data indicate that, depending on experimental parameters, evaporation and surface reactions can have a definite effect on the growth of particles.     

Liquid–solid disk extraction followed by supercritical fluid elution and gas chromatography of phenols from water

A method combining the techniques of liquid – solid disk extraction (LSDE) and supercritical fluid elution (SFE) has been developed for the phenols regulated by the Clean Water Act. LSDE uses a disk or membrane made of polytetrafluoroethylene (PTFE) fibrils impregnated with small particles, e.g. styrene divinylbenzene (SDB) resin, to extract phenols from water. After disk extraction the retained analytes are eluted from the disk using SFE. SFE is used as an alternative to liquid solvent elution with an organic solvent. Analytes are separated, identified, and quantified using gas chromatography – ion trap detector mass spectrometry (GC-ITDMS). The method is capable of sub parts per billion detection limits, and precision of 5–28% RSD. Evaluation of various disks or membranes, such as C₁₈-silica disks, SDB disks, and ion exchange membranes, has also been performed for the extraction of phenols from water. The results obtained from the in-situ aqueous acetylation of phenols and extraction of their acetates are quantitative. The utilization of LSDE and SFE techniques has proven to be a more effective approach than liquid – liquid extraction in minimizing air pollution and solvent waste.     

Polyol-Metall-Komplexe. 27. Bis-diolato-antimonate(III) mit Guanosin als Diol

Polyol Metal Complexes. 27. Bis-Diolato Antimonates(III ) with Guanosine as the Diol The complex anions of K₃[Sb^III(Guo1,2′,3′H_?3)₂] · 10 H₂O ( 1 ) and [Co(NH₃)₆][Sb^III(Guo1,2′,3′H_?3)₂] · 9 H₂O ( 2 ) are four-coordinate homoleptic bis(diolato)antimonate(III ) species. The guanosine trianions act as carbohydrate ligands through their cis-furanoidic ribosyl moiety, thus forming no nucleobase–metal bonds.