Evidence of upward spread of suppression in DPOAE measurements

Measurements of DPOAE level in the presence of a suppressor were used to describe a pattern that is qualitatively similar to population studies in the auditory nerve and to behavioral studies of upward spread of masking. DPOAEs were measured in the presence of a suppressor (f3) fixed at either 2.1 or 4.2 kHz, and set to each of seven levels (L3) from 20 to 80 dB SPL. In the presence of a fixed f3 and L3 combination, f2 was varied from about 1 oct below to at least 1/2 oct above f3, while L2 was set to each of 6 values (20-70 dB SPL). L1 was set according to the equation L1 = 0.4L2 + 39 [Janssen et al., J. Acoust. Soc. Am. 103, 3418-3430 (1998)]. At each L2, L1 combination, DPOAE level was measured in a control condition in which no suppressor was presented. Data were converted into decrements (the amount of suppression, in dB) by subtracting the DPOAE level in the presence of each suppressor from the DPOAE level in the corresponding control condition. Plots of DPOAE decrements as a function of f2 showed maximum suppression when f2 approximately = f3. As L3 increased, the suppressive effect spread more towards higher f2 frequencies, with less spread towards lower frequencies relative to f3. DPOAE decrement versus L3 functions had steeper slopes when f2 > f3, compared to the slopes when f2 < f3. These data are consistent with other findings that have shown that response growth for a characteristic place (CP) or frequency (CF) depends on the relation between CP or CF and driver frequency, with steeper slopes when driver frequency is less than CF and shallower slopes when driver frequency is greater than CF. For a fixed amount of suppression (3 dB), L3 and L2 varied nearly linearly for conditions in which f3 approximately = f2, but grew more rapidly for conditions in which f3 < f2, reflecting the basal spread of excitation to the suppressor. The present data are similar in form to the results observed in population studies from the auditory nerve of lower animals and in behavioral masking studies in humans.     

Assessment of enzyme-linked immunosorbent assay for the determination of 2,4,5-TP in water and soil

A highly sensitive and specific indirect enzyme-linked immunosorbent assay is described for Silvex, 2-(2,4,5 trichlorophenoxy)propionic acid, (2,4,5-TP). One specific feature of the immunoassay is the use of simple chemical activation of chlorophenoxy acids to prepare both the immunizing and coating conjugates. The assay is based on the use of polyclonal antibodies raised against 2,4,5-TP, and a peroxidase-labeled secondary antibody for colorimetric detection. The effect of different chemical conditions (pH, and salt and detergent concentration) on immunoassay performance has been studied. Under the best conditions the least detectable dose and the sensitivity (IC(50)) for 2,4,5-TP were 0.05 micro g L(-1) and 0.80 micro g L(-1), respectively. The optimized immunoassay was also highly specific, showing little (6.9% for 2,4,5-T) or no cross-reactivity with other similar herbicides. The assay was used to determine 2,4,5-TP in water and soils. The excellent recoveries obtained (mean values ranging between 89% and 104%) make this immunoassay a suitable screening method for either environmental monitoring or laboratory quantification of 2,4,5-TP.     

Effects of trivalent phosphorus compounds on vinyl polymerization. III. Anionic polymerization of acrylonitrile with triethyl phosphite

The polymerization of acrylonitrile catalyzed by triethyl phosphite was studied. It was found that the order with respect to the monomer concentration varies from two to three, depending on the polymerization temperature. From the results obtained for the molecular weight of the polymer and the phosphorus content in the polymer, it was thought that the zwitterion formed by the addition of triethyl phosphite to acrylonitrile is responsible for the initiation of polymerization. The following equation was suggested for the rate of the polymerization:      

Discontinuous buffer systems operative at pH 2.5 - 11.0, 0 degrees C and 25 degrees C, available on the Internet

This communication is an announcement of the availability on the Internet of a computer output of discontinuous buffer systems operative at pH 2.5-11.0, 0 degrees C and 25 degrees C, generated by the theory and program of T. M. Jovin. The output and instructions for its use can be accessed under http://www.buffers.nichd.nih.gov.