(Pr0.9La0.1)2(Ni0.74Cu0.21Ga0.05)O4+δ-Ce0.9Gd0.1O2-δ复合阴极的制备及电化学性质

采用EDTA-柠檬酸盐法制备了（Pr_0.9La_0.1）₂（Ni_0.74Cu_0.21Ga_0.05）O_4+δ（PLNCG）,并与Ce_0.9Gd_0.1O_2-δ（CGO）形成复合阴极PLNCG-CGO。XRD和SEM分析结果表明PLNCG与CGO在1 000℃具有较好的化学相容性。电化学阻抗测试结果表明PLNCG-30% CGO复合阴极在700℃的极化电阻为0.092 Ω·cm²;过电位为39.3 mV时,电流密度达到113.3 mA·cm^-2。氧分压分析表明电极反应的速率控制步骤为电荷转移过程。阳极支撑单电池（Ni-CGO/CGO/PLNCG-30% CGO）在700℃的最大输出功率密度达到569 mW·cm^-2,开路电压（OCV）为0.76 V。综上结果预示PLNCG-30% CGO复合阴极是一种有发展前景的电极材料。     

离子色谱法测定甲醇和噻吩中硫、氯含量

建立了测定工业用甲醇和噻吩中硫、氯含量的离子色谱检测方法。样品经(700±25)℃灼烧后,残留物用蒸馏水洗涤,利用离子色谱仪进行分析。甲醇和噻吩中硫、氯检测结果的相对标准偏差为1.04%~1.26%,加标回收率为99.2%~101.2%。该方法操作简单,精密度和准确度高,可用于大部分可燃性有机化合物中硫、氯含量的检测。     

Synthesis, Crystal Structure and Magnetic Property of a New Two-Dimensional Polymers with 4-Connected sql Topology

A new polymer [Mn₃(OAc)₆(H₂O)₁₂] _n (1) based on trinuclear manganese clusters has been synthesized under hydrothermal condition and structurally characterized by single-crystal X-ray diffraction analysis. The compound crystallizes in monoclinic system, space group P2₁/c, with a = 10.401(5), b = 17.527(7), c = 9.073(4) Å, α = 90, β = 110.943(7), γ = 90°, V = 1544.8(12) Å³, Z = 2. Compound 1 is a two-dimensional (2D) structure with 4-connected sql topology, and is further extended to a 3D supramolecular framework by hydrogen bonds. Variable temperature magnetic susceptibility measurements indicate antiferromagnetic couplings between Mn²⁺ ions. Furthermore, elemental analyses and powder X-ray diffraction properties of 1 are also investigated.     

Amperometric detection of nitrite based on Dawson-type vanodotungstophosphate and carbon nanotubes

A nitrite sensor based on Dawson vanodotungstophosphates α₂-K₇P₂VW₁₇O₆₂·18H₂O (P₂W₁₇V) and carbon nanotubes (CNTs) was prepared by electrostatic layer-by-layer self-assembly technique. The sensor {PEI/PSS/[PDDA/P₂W₁₇V-CNTs]_n} was characterized by UV–vis spectroscopy, atomic force microscopy (AFM), scanning electron microscopy (SEM) and X-ray photoelectron spectra (XPS). The electron transfer and sensing ability of this sensor were explored using cyclic voltammetry (CV) and electrochemical impedance spectra (EIS) technology. The results show that the incorporation of CNTs and P₂W₁₇V into the composite film endowed the modified electrode with fast transfer rate and high electrocatalytic activity towards oxidation of nitrite. This nitrite sensor with 10 bilayers has a broad linear range of 5 × 10⁻⁸ to 2.13 × 10⁻³ M, a low detection limit of 0.0367 μM (S N⁻¹ = 3), a high sensitivity of 0.35 mA mM⁻¹ NO₂⁻, an excellent anti-interference property in the presence of other potential interfering species and a good stable. It was successfully employed for determination of nitrite in real towards.     

Synthesis and comparative study of the heterocyclic rings on liquid crystalline properties of 2,5-aryl-1,3,4-oxa(thia)diazole derivatives containing furan and thiophene units

A series of heterocyclic liquid crystalline compounds containing 1,3,4-oxadiazole/thiadiazole, furan and thiophene units were synthesised and characterised by means of electrospray ionisation-mass spectrometry (ESI-MS), high-resolution mass spectroscopy (HRMS), ¹H nuclear magnetic resonance (NMR) and ¹³C NMR. The thermal behaviours were investigated by differential scanning calorimetry (DSC) and polarised optical microscopy (POM). The effect of the 1,3,4-oxadiazole, 1,3,4-thiadiazole, furan, thiophene and benzene rings on the liquid crystalline properties was discussed briefly in context with the geometrical and electronic factors. The results showed that the tendency to form mesophases follows the sequence: 1,4-disustituted benzene >2,5-disubstituted thiophene >2,5-disustituted furan and 1,3,4-thiadiazole >1,3,4-oxadiazole.     

Synthesis and liquid crystalline properties of substituted 2,5‐diaryl 1,3,4‐oxadiazole derivatives without flexible chains

A series of new compounds based on aromatically 2,5‐disubstituted 1,3,4‐oxadiazoles without flexible chains, formulated as p‐R–C₆H₄–(OC₂N₂)–(p‐C₆H₄)₂–R′ with (i) R = CH₃O, R′ = CH₃O, CH₃S, F, H (Ia–Id), (ii) R = CH₃S, R′ = CH₃O, CH₃S, F, H (IIa–IId) and (iii) R = F, R′ = CH₃O, CH₃S, F, H (IIIa–IIId) (p‐C₆H₄ and OC₂N₂ represent a p‐phenylene spacer and a 1,3,4‐oxadiazole ring, respectively), were synthesised and characterised by ¹H and ¹³C NMR, MS and HRMS techniques. Mesomorphic properties were investigated using differential scanning calorimetry and polarizing optical microscopy. All of the target compounds (except Id, IId, IIIc and IIId) exhibited an enantiotropic nematic mesophase with high melting temperatures. The liquid crystalline properties of these compounds were influenced greatly by polarity, steric factors and positions of the terminal groups. The effect of the terminal groups on the liquid crystal properties is discussed.     

Determination of synthetic musks in the sediment of the Taihu lake by using accelerated solvent extraction (ASE) and GC/MS

Synthetic musks, substitutes for natural musks, are widely distributed in environment. They have been detected in water, sludge, fish, shrimp, mussels and other aquatic animals, and even in human's adipose tissue, blood and breast milk. In this study, a new extraction procedure, based on the accelerated solvent extraction (ASE) and in cell clean-up technique was developed and successfully coupled with gas chromatography-mass spectrometry (GC/MS) for the analysis of musks in sediment samples. With this method, the limits of detection as low as 0.03–0.05?ng?g^?1 and the recovery rate of 86.0%–104% are achieved. When compared with soxhlet extraction (SE) and ultrasonic extraction (USE), ASE not only has the best extraction efficiency but also has advantage in extraction time and solvent consumption. Eight synthetic musks, including six polycyclic musks (Tonalide (AHTN), Galaxolide (HHCB), Phantolide (AHDI), Traseolide (ATII), Cashmeran (DPMI) and Celestolide (ADBI)) and two nitro musks (musk xylene (MX) and musk ketone (MK)), were evaluated in sediment samples collected from 15 selected locations of the Taihu lake, one of the largest freshwater lakes in China. The contents of synthetic musks in sediment samples range from 0.336 to 3.10?ng?g^?1 for HHCB, 0.184 to 1.21?ng?g^?1 for AHTN, below detection limit (BDL) to 0.349?ng?g^?1 for MX, and BDL to 0.0786?ng?g^?1 for MK. The contents of DPMI, ADBI, AHMI and ATII are below detection limit in all samples. The results reflect current status of fragrance compound pollution in this area, and provide basic data for environmental policy making.     

Evaluation of measurement uncertainty in EA–IRMS: for determination of δ 13C value and C-4 plant sugar content in adulterated honey

In this study, the method for determining the stable carbon isotope ratio value was validated. Measurement uncertainty of stable carbon isotope ratio value of whole honey and its extracted protein derived from repeatability, reference gas, reference standards and calibration curve was calculated by applying the “bottom-up” approach according to Eurachem/CITAC guide. The expanded uncertainties for all results ranged from 0.14 to 0.19 ‰, with most of them between 0.15 and 0.16 ‰ (the coverage factor k = 2, the level of confidence p is approximately 95 %). The percentage contribution of each source to the relative combined uncertainty was calculated. The data indicated that calibration curves have more contribution to the relative combined uncertainty than repeatability and reference standards. On the other hand, the measurement uncertainty of C-4 sugar content in honey was estimated. Based on these results, 58 honey samples, such as acacia, chaste, Northeast China black bee, flowers and jujube honey, have been gathered to determine the C-4 plant sugar content adulteration in honey by elemental analyzer with an isotope ratio mass spectrometer. It can be found that all honey samples were not adulterated by C-4 plant sugar.     

Dopamine derivatives from the insect Polyrhachis dives as inhibitors of ROCK1/2 and stimulators of neural stem cell proliferation

Polyrhachis dives is consumed as an insect food in some regions of China. In this study, new dopamine derivatives, (+)-polyrhadopamine A (1a) and (−)-polyrhadopamine A (1b), (+)-polyrhadopamine B (2a) and (−)-polyrhadopamine B (2b), and polyrhadopamines C–E (3–5), were isolated from this species. The structures and stereochemistry of these substances were assigned by using spectroscopic and computational methods. Compounds 1a, 1b, 2a, and 2b are dimeric N-acetyldopamine derivatives, 3 is a dopamine analog containing an unusual sulfone group, and 4 and 5 possess a rare benzo[d]thiazole moiety. The functions of these substances as ROCK1/2 inhibitors, neural stem cell (NSCs) proliferation stimulators, immunosuppressive, and anti-inflammatory agents were determined.     

A green strategy for lithium isotopes separation by using mesoporous silica materials doped with ionic liquids and benzo-15-crown-5

Three new mesoporous silica materials IL15SGs (HF15SG, TF15SG and DF15SG) doped with benzo-15-crown-5 and imidazolium based ionic liquids (C₈mim⁺PF₆ ^?, C₈mim⁺BF₄ ^? or C₈mim⁺NTf ₂ ^? ) have been prepared by a simple approach to separating lithium isotopes. The formed mesoporous structures of silica gels have been confirmed by transmission electron microscopy image and N₂ gas adsorption–desorption isotherm. Imidazolium ionic liquids acted as templates to prepare mesoporous materials, additives to stabilize extractant within silica gel, and synergetic agents to separate the lithium isotopes. Factors such as lithium salt concentration, initial pH, counter anion of lithium salt, extraction time, and temperature on the lithium isotopes separation were examined. Under optimized conditions, the extraction efficiency of HF15SG, TF15SG and DF15SG were found to be 11.43, 10.59 and 13.07 %, respectively. The heavier isotope ⁷Li was concentrated in the solution phase while the lighter isotope ⁶Li was enriched in the gel phase. The solid–liquid extraction maximum single-stage isotopes separation factor of ⁶Li–⁷Li in the solid–liquid extraction was up to 1.046 ± 0.002. X-ray crystal structure analysis indicated that the lithium salt was extracted into the solid phase with crown ether forming [(Li_0.5)₂(B15)₂(H₂O)]⁺ complexes. IL15SGs were also easily regenerated by stripping with 20 mmol L^?1 HCl and reused in the consecutive removal of lithium ion in five cycles.