Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Reaction of Trimethylbenzene over Alumina-Pillared Montmorillonite

The reaction of trimethylbenzene (TMB) over alumina-pillared montmorillonite (Al-PM) had been investigated in a fixed-bed flow reactor at 300 °C and atmospheric pressure. Al-PM calcined in the range 300-500 °C exhibited decreased layer distance, surface area and acid amount. The strong acid sites of Al-PM calcined at 500 °C were greatly diminished according to measurements of ammonia temperature-programmed desorption. Under our conditions the reaction proceeded mainly via isomerization and disproportionation with little dealkylation. The conversion of reactant decreased in the order 1,2,3-TMB ≥ 1,2,4-TMB > 1,3,5-TMB and the selectivity of isomerization in the order 1,2,3-TMB > 1,3,5-TMB > 1,2,4-TMB, corresponding to the order of diminishing thermal instability. Both the catalytic activity and the selectivity ratio of disproportionation to isomerization decreased with increased calcined temperature and time-on-stream. o-Xylene content in the total xylene produced from 1,2,4-TMB or 1,2,3-TMB greatly exceeded the composition at thermodynamic equilibrium. These results arc consistent with the decrease of both the strong acid sites and the pore size of Al-PM which exhibits the restricted transition state selectivity.     

TheSemmler-Wolff aromatization andSchmidt reaction applied to some pyrido[2′,3′:3,4]pyrazolo[5,1-c][1,2,4]benzotriazines

Pyrido[2,3:3,4]pyrazolo[5,1-c][1,2,4]benzotriazin-4(1H)ones were transformed via their oximes in aSemmler-Wolff aromatization process in the tetracyclic heteroaromatic amines4 or bySchmidt reaction into a mixture of the same amine4 and a ring enlarged lactam3. Syntheses of some halo pyrazolo[3,4-b]pyridines and a photochemical transformation of 3-azidopyrazolo[3,4-b]pyridine are also described.

---

Über dieSemmler-Wolff- undSchmidt-Reaktion einiger Pyrido[2,3:3,4]pyrazolo[5,1-c][1,2,4]benzotriazine

Zusammenfassung Pyrido[23:3,4]pyrazolo[5,1-c][1,2,4]benzotriazin-4(1H)one werden über Oxime in einerSemmler-Wolff-Reaktion in die tetracyklischen aromatischen Amine4 umgewandelt. In einerSchmidt-Reaktion wurden dieselben Ketone in ein Gemisch aus Amin4 und Lactam3 übergeführt. Synthesen von halogensubstituierten Pyrazolo[3,4-b]pyridinen und photochemische Umwandlung von 3-Azidopyrazolo[3,4-b]pyridin werden beschrieben.

     

Self-assembly of rectangles and prisms via a molecular "clip"

Aromatic molecular "clips" bearing two symmetrically bound platinum moieties have been prepared. The molecular "clip" 4 readily self-assembled with linear linkers such as 4,4'-bipyridyl, 1,4-bis[2-(4-isocyano-3,5-diisopropylphenyl)ethynyl]benzene, and nicotinic acid to form molecular rectangles. The overall dimensions of the rectangle 7 were 7.3 Angstroms x 15.3 Angstroms. The molecular "clip" also self-assembled with tritopic pyridyl and isocyanide ligands to form trigonal prismatic frameworks. The characterization of the supramolecules by multinuclear NMR, electrospray mass spectrometry, and X-ray crystal structures is also reported.     

Synthesis of new tetrazene（N-N=N-N）-linked bi（1,2,4-triazole）

The reaction of 4-amino-1,2,4-triazole with sodium dichloroisocyanurate (SDCI) afforded new tetrazene(N-N=N-N)-linked bi(1.2,4-triazole) 2a in excellent yield.Increasing the molar ratio of SDCI to 4-amino-1,2,4-triazole,the chlorinated product 1,5,5′- trichloro-4,4′-azo-1,2,4-triazole (2b) was formed.These new compounds have been characterized by MS,~1H NMR,~(13)C NMR,and elemental analysis.     

A differential scanning calorimetry study on poly(ethylene terephthalate) isothermally crystallized at stepwise temperatures: multiple melting behavior re-investigated

The multiple melting behavior of poly(ethylene terephthalate) (PET) was investigated with differential scanning calorimetry (DSC) by examining PET samples having been subjected to special schemes of crystallization and annealing treatment at multiple descending temperatures. Upon such step-wise annealing in decreasing temperatures, the existence of doublet melting peaks in addition to a series of multiple minor peaks in the PET has been demonstrated using carefully designed thermal schemes. Using the Hoffman theory, multiple lamellae populations, might be suggested to be simultaneously present in the PET subjected to such thermal treatments. However, direct experimental evidence has yet to be provided. The low-temperature minor crystals simply melt during normal scanning without having time enough to reorganize into higher-melt crystals. Nevertheless, the effect of scanning on non-isothermal crystallization does exist but is primarily confined to the temperature range much below the main melting region where the crystallization of polymer chains can progress at a reasonable rate. At higher temperatures near the main melting region, annealing for extended times is required in order to result in relative changes of the melting endotherms of the upper and lower peaks in the main melting doublet. In all we have shown that interpretations of the multiple melting phenomenon in semicrystalline polymers can be better refined.     

生物,环境样品和食品中铅的痕量分析

主要根据近七年来发表的有关论文，综述了我国生物、环境样品和食品中铅和痕量分析技术进展，内容包括分子光谱、原子光谱、电化学和其他分析方法，以及联用技术和前处理等方面，收集文献３９３篇。     

Zur Polymorphie von SrTeO3

Beside the transition into a ferroelectric phase at 583 K, monoclinic SrTeO₃(I) at ?1260 K transforms slowly into a high-temperature form (SrTeO₃(II)) which after quenching undergoes rapid phase transitions at 648 and 733 K. X-Ray data of triclinic α-SrTeO₃(II) (room temperature), monoclinic β-SrTeO₃(II) (660 K), and monoclinic γ-SrTeO₃(II) (770 K) are presented.     

On-line nanoliter cycle sequencing reaction with capillary zone electrophoresis purification for DNA sequencing

An integrated system for DNA sequencing based on a nanoreactor for cycle-sequencing reaction coupled with on-line capillary zone electrophoresis (CZE) for purification and capillary gel electrophoresis (CGE) for separation is presented. Less than 100 nl of premixed reagent solution, which includes dye-labeled terminator pre-mix, bovine serum albumin and template, was hydrodynamically injected into a fused-silica capillary (75 microm I.D.) inside a laboratory-made microthermocycler for cycle sequencing reaction. In the same capillary, the reaction products were purified by CZE followed by on-line injection of the DNA fragments into another capillary for CGE. Over 540 base pairs (bp) of DNA can be separated and the bases called for single-standed DNA with 0.9% error rate. The total time was about 3.5 h, or a cycle time of 2 h with staggered operation. For double-stranded DNA, a longer reaction time was required and base calling up to 490 bp with 1.2% error rate was achieved. The whole system is readily adaptable to automated multiplex operation for DNA sequencing or polymerase chain reaction analysis.     

Determination of in vitro permeability of drug candidates through a caco-2 cell monolayer by liquid chromatography/tandem mass spectrometry

Studying the permeability of compounds across a Caco-2 cell monolayer is an established in vitro model to screen for oral absorption and to evaluate the mechanism of transport. This assay can also be used to evaluate compounds as potential P-glycoprotein substrates and/or inhibitors. The traditional methods of sample analysis (high-performance liquid chromatography (HPLC) with a UV or fluorescence detector) limit the throughput and sensitivity of this assay. Data are presented here describing the use of liquid chromatography/tandem mass spectrometry (LC/MS/MS) for the analysis of samples derived from the Caco-2 cell studies. During the analysis an automatic switching valve was used to divert the flow from the HPLC column to waste for the first minute, preventing the early eluting salts from entering and contaminating the LC/MS interface. This approach allows the rapid and accurate determination of drug transport across the Caco-2 cell monolayer. The high sensitivity and specificity of LC/MS/MS make this technique an ideal candidate for the low concentration and high throughput routine analysis of Caco-2 cell solutions, especially if multiple compounds are administered and analyzed simultaneously. Thus, the use of LC/MS/MS will increase the value of the Caco-2 cell assay as an in vitro screening tool.