Ductile–brittle transitions in the fracture of plastically deforming,adhesively bonded structures. Part II: Numerical studies

To enable the effective and reliable use of structural adhesive bonding in automotive applications, the cohesive properties of a joint need to be determined over a wide range of loading rates. In this paper, a strategy for determining these properties has been described and used to analyze a set of experimental results presented in a companion paper. In the particular system studied, a crack growing in a toughened quasi-static mode could make a catastrophic transition to a brittle mode of fracture. The cohesive parameters for both the toughened and brittle modes of crack growth were determined by comparing numerical predictions from cohesive-zone simulations to the results of experimental tests performed using double-cantilever beam specimens and tensile tests. The cohesive parameters were found to be essentially rate-independent for the toughened mode, but the toughness dropped by a factor of four upon a transition to the brittle mode. The results of wedge tests were used as an independent verification of the cohesive parameters, and to verify that the quasi-static properties remained rate-independent to very high crack velocities corresponding to conditions of low-velocity impact. The effects of friction, and the use of the wedge test to determine cohesive parameters, were also explored.     

Electron-active cyclotron resonance in p-doped InMnAs in high magnetic fields

We present a theoretical and experimental study of electron-active cyclotron resonance in p-doped InMnAs in high magnetic fields. Results are based on an 8-band Pidgeon–Brown model generalized to include finite k_z effects and s(p)–d exchange interaction between itinerant carriers and Mn d-electrons. The e-active transitions in the valence band in p-doped samples take place due to the nature of multiple valence bands (heavy and light holes). We have calculated the absorption spectra in high magnetic fields and identified optical transitions which contribute to the cyclotron resonance for both e-active and h-active polarizations. Calculations show agreement with experimental results.     

电磁诱导透明和导致极慢光速的机制

根据有关文献 ,描述了电磁诱导透明和导致光速极慢的物理机制 ,并对实验结果也做了介绍     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

n维氢原子的散射态

研究了n维氢原子的散射态性质．给出了精确的按“k/2π标度”归一化的散射态的精确解波函数及相移表达式，讨论了相移的解析性质，获得了束缚-连续跃迁矩阵元的解析计算公式．普通氢原子(n=3)散射态的有关结果作为特例包含在本文的一般结论之中． 关键词： n维氢原子 散射态 精确解 相移 束缚-连续跃迁矩阵元     

Crystallographic report: Crystal structure of tetra(4‐methyl‐5‐imidazole‐carboxyaldehyde)zinc(II) diperchlorate

The central zinc(II) atom in the title complex is tetrahedrally coordinated by four nitrogen atoms derived from 4‐methyl‐5‐imidazolecarboxyaldehyde ligands with Zn? N in the range 2.007(3) to 2.026(4) Å. Copyright © 2003 John Wiley & Sons, Ltd.     

Cu-MgF2复合纳米金属陶瓷薄膜的电导特性研究

用射频磁控共溅射法制备了Cu体积分数分别为 10 % ,15 % ,2 0 %和 3 0 %的Cu MgF2 复合金属陶瓷薄膜 .用x射线衍射、x射线光电子能谱和变温四引线技术对薄膜的微结构、组分及电导特性进行了测试分析 .微结构分析表明 :制备的Cu MgF2 复合薄膜由fcc Cu晶态纳米微粒镶嵌于主要为非晶态的MgF2 陶瓷基体中构成 ,Cu晶粒的平均晶粒尺寸随组分增加从 11 9nm增至 17 8nm .5 0— 3 0 0K温度范围内的电导测试结果表明 :当Cu体积分数qM 由 15 %增加到 2 0 %时 ,Cu MgF2 复合薄膜的电阻减小了 8个量级 ,得出制备的复合薄膜渗透阈qCM 应处于 15 %和 2 0 %之间 .qM 在 10 %和 15 %之间的薄膜呈介质导电状态 ,而在 2 0 %和 3 0 %之间的薄膜则呈金属导电状态 .从理论上讨论了复合薄膜中杂质电导和本征电导的激活能及其对电导的贡献 ,并讨论了Cu MgF2 复合纳米金属陶瓷薄膜的渗透阈 ,得到了和实验一致的结果     

Photo-induced effect in the layered perovskite manganite La<Subscript>1.2</Subscript>Sr<Subscript>1.8</Subscript>Mn<Subscript>1.8</Subscript>Co<Subscript>0.2</Subscript>O<Subscript>7</Subscript>

It is helpful to study the photo-induced effect in the perovskite manganites not only for elucidating the mechanism of colossal magnetoresistance (CMR) effect but also for potential applications in technology. The laser-induced effect in the Co doping layered perovskite manganites La_1.2Sr_1.8Mn_1.8Co_0.2O₇, is studied in this paper and the obtained results are also compared with that gained in the Nd-doping manganites with cubic perovskite structure.     

Simultaneous determination of trace cadmium and mercury in Chinese herbal medicine by non-dispersive atomic fluorescence spectrometry using intermittent flow vapor generator.

A method was proposed for the simultaneous determination of trace cadmium and mercury by vapor generation non-dispersive atomic fluorescence spectrometry using an intermittent flow system. The effects of the parameters on the performance were studied systematically. The parameters such as acid concentration of the reaction medium, flow rate of the carrier gas and shield gas, the observation height and the atomizer temperature, etc. which affected the sensitivity, were optimized. Ascorbic acid, cobalt ion and thiourea were used as enhancement reagents or masking agents to enhance the generation efficiency of the volatile species of Cd and Hg. The mechanisms of their effects on vapor generation were investigated. In the presence of thiourea and ascorbic acid, the influences of some coexisting elements on the determination of cadmium and mercury were investigated. The detection limits (3sigma) were 0.010 microg l(-1) for Cd and 0.019 microg l(-1) for Hg, respectively. The relative standard deviations for Cd and Hg at 1.00 microg l(-1) were 2.6% and 0.97% (n = 11), respectively. The proposed method has been satisfactorily applied to the determination of trace cadmium and mercury in Chinese herbal medicine.