Dispersion of nanospheres on large glass substrate by amorphous or polycrystalline silicon deposition for localized surface plasmon resonance

Nanosphere lithography is a cost-effective way to fabricate noble metal nanostructures for plasmonics. However, dispersing nanospheres on a large area of glass substrate is a difficulty encountered when transparent substrate is required in applications such as localized surface plasmon resonance or surface enhanced Raman spectroscopy. Because poly(diallyldimethyl ammonium chloride) (PDDA) on silicon surface introduces a force that can disperse nanospheres on silicon, in this article, we modify the glass surface through amorphous or polycrystalline silicon deposition and thus well disperse polystyrene or silica nanospheres over a glass area of more than 2 cm × 2 cm. Transmission loss of the glass substrate caused by amorphous or polycrystalline silicon deposition is analyzed with good agreement to experimental spectra, and localized surface plasmon resonance signals generated from the gold nanostructures fabricated on these substrates are measured and yield a sensitivity of 317 nm/RIU, which prove the feasibility and effectiveness of our method.     

飞秒激光烧蚀铝靶产生喷射物的超快脉冲数字全息诊断

采用脉冲数字显微全息技术,对50 fs单脉冲激光烧蚀铝靶过程中的物质喷射以及等离子体演化的动态过程进行了实验研究,获得了高时空分辨的动态数字全息图.由全息图观察到了热弹力波引起的二次喷射现象,并且报道了大延迟下喷射物质对400 nm探测光所引起的干涉条纹的反常移动现象.通过对全息图进行数字再现,得到了不同延迟下探测光穿过等离子体后的二维相位分布,并运用逆Abel变换算法获得了等离子体折射率以及等效电子密度的时空演化动态过程.根据实验以及计算所得到的有关于喷射物的光学性质,对喷射物的结构和成分进行了分析. 关键词： 脉冲数字全息 飞秒激光烧蚀 超快时间分辨 等离子体     

一种基于诱骗态的广域量子安全直接通信网络方案

提出了一种基于诱骗态的广域量子安全直接通信网络方案.在每一个局域网中设置一个服务器负责量子态的产生和测量,从而提高了通信距离;将诱骗态的思想引入量子安全直接通信,采用不同的强度发送光脉冲,能够克服光子数目分割攻击,从而提高通信的安全性;根据信道参量估计了不同通信距离的通过率,为信道编码提供了依据.对所提方案进行了安全性分析,结果表明此方案能够实现远距离量子安全直接通信.     

Comparison of Nd:YAG Ceramic Laser Pumped at 885nm and 808nm

Laser performance of 1064 nm domestic Nd：YAG ceramic lasers for 885 nm direct pumping and 808 nm traditional pumping are compared. Higher slope efficiency of 34% and maximum output power of 16.5 W are obtained for the 885nm pump with a 6ram length 1 at.% Nd：YAG ceramic. The advantages for 885nm direct pumping are discussed in detail. This pumping scheme for highly doping a Nd：YAG ceramic laser is considered as an available way to generate high power and good beam quality simultaneously.     

LD端面泵浦腔内倍频Yb:YAG绿光激光器

报道了一种激光二极管(LD)端面泵浦10at%掺杂Yb:YAG激光晶体(4×4×1mm)和Ⅰ类临界相位匹配LBO的腔内倍频全固态绿光激光器.为了克服"绿光问题",采用了两个激光二极管偏振耦合系统.在双路泵浦功率为1.2W时,获得最高功率为40mW525nm的连续基模激光输出.在腔内插入Cr4+:YAG饱和吸收体被动调Q,在泵浦功率为1.2W时,可以获得平均功率为5.2mW,脉冲重复频率为2.44kHz,脉冲宽度为51.5ns,峰值功率为41.7W的515nm脉冲激光输出.输出波长发生变化,而且515nm脉冲激光输出的阈值仅为728mW.     

SPME-GC-MS快速分析炼油厂废水中痕量VOCs

采用固相微萃取-气相色谱-质谱联用(SPME-GC-MS)对炼油厂废水中痕量挥发性有机化合物(VOCs)进行了定性分析,简化了预处理过程,总分析时间为1h左右.对比处理前后的废水样品的MS定性结果,为废水处理工艺的评价以及有机物降解机理提供了依据.     

Identification and elimination of inductively coupled plasma-induced defects in AlxGa1 - xN/GaN heterostructures

By using temperature-dependent Hall,variable-frequency capacitance-voltage and cathodoluminescence (CL) measurements,the identification of inductively coupled plasma (ICP)-induced defect states around the Al x Ga 1-x N/GaN heterointerface and their elimination by subsequent annealing in Al x Ga 1-x N/GaN heterostructures are systematically investigated.The energy levels of interface states with activation energies in a range from 0.211 to 0.253 eV below the conduction band of GaN are observed.The interface state density after the ICP-etching process is as high as 2.75×10 12 cm 2 ·eV 1.The ICP-induced interface states could be reduced by two orders of magnitude by subsequent annealing in N 2 ambient.The CL studies indicate that the ICP-induced defects should be Ga-vacancy related.     

神龙一号直线感应加速器X光转换靶破坏诊断

 利用能量约450 keV、焦斑直径1~4 mm的低能X光对神龙一号直线感应加速器束靶作用后钽靶的破坏进行诊断,利用增强型电荷耦合器件（ICCD）对诊断过程记录,得到束靶作用后数μs时间内钽靶材料密度的变化。结果表明：在束靶作用后约1 μs内靶材料密度基本没有变化,且该时间段内ICCD相机没有观察到有靶前钽靶材料的微粒喷射。     

TiN/TiB2异结构纳米多层膜的共格生长与力学性能

采用多靶磁控溅射法制备了一系列具有不同TiB₂调制层厚度的TiN/TiB_{2纳米多层膜.利用x射线衍射仪、高分辨电子显微镜和微力学探针研究了TiB2层厚变化对多层膜生长结构和力学性能的影响.结果表明，在fcc-TiN层(111)生长面的模板 作用下，原为非晶态的TiB2层在厚度小于2.9nm时形成hcp晶体态，并与fcc-TiN 形成共格外延生长；其界面共格关系为{111}TiN//{0001}TiB2，〈110〉TiN//〈1120〉TiB2.由于共格界面存在晶格失配 度，多层膜中形成拉、压交变的应力场，导致多层膜产生硬度和弹性模量升高的超硬效应， 最高硬度和弹性模量分别达到46.9GPa和465GPa.继续增加TiB2层的厚度，TiB2形成非晶态并破坏了与TiN层的共格外延生长，多层膜形成非晶TiN层和非晶TiB< sub>2层交替的调制结构，其硬度和弹性模量相应降低. 关键词： 2}纳米多层膜')" href="#">TiN/TiB₂纳米多层膜 共格生长 晶体化 力学性能     

涡旋柔性弹簧及组件性能实验研究

本文利用TSL系列弹簧刚度实验仪对用于斯特林制冷机中的单片柔性弹簧及柔性弹簧组件进行了实验研究。测试了四种不同尺寸弹簧刚度的动态特性,研究了单片弹簧的轴向刚度、径向刚度以及力矩特性,然后对柔性弹簧组件进行了实验研究,指出了不同组合方法下的刚度及弯矩特性,得到的数据可以作为斯特林制冷机设计的参考。