Co(II)5(OH)6(SO4)2(H2O)4: the first ferromagnet based on a layered cobalt-hydroxide pillared by inorganic...OSO3-Co(H2O)4-O3SO..

The synthetic mineral Co(II)5(OH)6(SO4)2(H2O)4 (1), obtained by hydrothermal reaction of CoSO4.7H2O and NaOH at 165 degrees C and consisting of brucite-like Co4(OH)6O2 layers pillared by OSO3-Co(H2O)4-O3SO, is a ferromagnet (T(Curie)= 12 K, Hc= 580 Oe).     

Effect of electric field strength and exposure time on epoxy and high density polyethylene measured by positron annihilation lifetime

Using the positron annihilation lifetime technique, the annihilation parameters have been measured for epoxy and high density polyethylene (HDPE) as a function of AC electric field strength and the exposure time. The lifetime spectra have been resolved into three components, the longest component (I₃₃) is attributed to the pick-off annihilation of o-Ps in the amorphous regions. The intermediate one (I₂₂) is due to the annihilation of free positrons, while the shorter component (I₁₁) stems from self annihilation of p-Ps. In HDPE, the o-Ps parameters ₃ andI ₃ are measured as a function of electric field strengths in the range from 10 to 100 kV/cm exposed for 24 hours. A decrease inI ₃ of 8% is observed from zero to 50 kV/cm followed by an increase of the same order from 50 to 100 kV/cm. By investigating the effect of the exposure time from 2 to 24 hours at 16 and 50 kV/cm, the effect is confirmed and is attributed to the inhibition of o-Ps formation at lower field strength. In epoxy, the effect or exposure time onI ₃ at 166 and 133 kV/cm shows a similar behavior as in HDPE. At 133 kV/cmI ₃ decreases by only 2.5%. On the other hand, the changes in ₃ occur at short exposure times. Again at large times the saturation is obtained. These effects are attributed to the expansion of free volume (increase of ₃) competing at longer exposure times with other phenomena, such as liberation of free radicals, which reduce the o-Ps intensityI ₃ through the conversion to p-Ps. The reactions between o-Ps and free radicals might also lead to free positrons, which could explain the increase ofI ₂ and the decrease of ₃ at longer exposure times.     

Amplified cathodic electrochemiluminescence of luminol based on zinc oxide nanoparticle modified Ni-foam electrode for ultrasensitive detection of amoxicillin

Journal of Solid State Electrochemistry - Here is reported a new feasible and facile method for the determination of amoxicillin by the electrochemiluminescence (ECL) method. The ECL signal was...     

Development and Optimization of Ciprofloxacin HCl-Loaded Chitosan Nanoparticles Using Box–Behnken Experimental Design

Various chitosan (CS)-based nanoparticles (CS-NPs) of ciprofloxacin hydrochloride (CHCl) have been investigated for therapeutic delivery and to enhance antimicrobial efficacy. However, the Box–Behnken design (BBD)-supported statistical optimization of NPs of CHCl has not been performed in the literature. As a result, the goal of this study was to look into the key interactions and quadratic impacts of formulation variables on the performance of CHCl-CS-NPs in a systematic way. To optimize CHCl-loaded CS-NPs generated by the ionic gelation process, the response surface methodology (RSM) was used. The BBD was used with three factors on three levels and three replicas at the central point. Tripolyphosphate, CS concentrations, and ultrasonication energy were chosen as independent variables after preliminary screening. Particle size (PS), polydispersity index (PDI), zeta potential (ZP), encapsulation efficiency (EE), and in vitro release were the dependent factors (responses). Prepared NPs were found in the PS range of 198–304 nm with a ZP of 27–42 mV. EE and drug release were in the range of 23–45% and 36–61%, respectively. All of the responses were optimized at the same time using a desirability function based on Design Expert^® modeling and a desirability factor of 95%. The minimum inhibitory concentration (MIC) of the improved formula against two bacterial strains, Pseudomonas aeruginosa and Staphylococcus aureus, was determined. The MIC of the optimized NPs was found to be decreased 4-fold compared with pure CHCl. The predicted and observed values for the optimized formulation were nearly identical. The BBD aided in a better understanding of the intrinsic relationship between formulation variables and responses, as well as the optimization of CHCl-loaded CS-NPs in a time- and labor-efficient manner.     

CuO–Fe2O3 nanoparticles embedded onto reduced graphene oxide nanosheets: a high-performance nanocomposite anode for Li-ion battery

Journal of Solid State Electrochemistry - The development of safe, fast charging, and long-lasting Li-ion batteries has been taking major steps forward through novel combinations of nanomaterials....     

Comparative electrochemical study of new self-assembled monolayers of 2-{[(Z)-1-(3-furyl)methylidene]amino}-1-benzenethiol and 2-{[(2-sulfanylphenyl)imino]methyl}phenol for determination of dopamine in the presence of high concentration of ascorbic acid and uric acid

The comparative electrochemical behavior of self-assembled monolayers of two Schiff's bases, 2-{[(Z)-1-(3-furyl)methylidene]amino}-1-benzenethiol (FMAB) and 2-{[(2-sulfanylphenyl)imino]methyl}phenol (SIMP) on a bare gold electrode (Au FMAB SAM-modified electrode and Au SIMP SAM-modified electrode, respectively), was investigated by means of cyclic voltammetry and electrochemical impedance spectroscopy in a 0.1 mol L(-1) KCl solution that contains 5.0 × 10(-3) mol L(-1) [Fe(CN)(6)](3-/4-). The results revealed that the modified electrodes showed an electrocatalytic activity toward the anodic oxidation of dopamine by a marked enhancement in the current response and lower overpotential (60 and 90 mV for the Au FMAB and Au SIMP SAM-modified electrodes, respectively) in phosphate buffer solution at pH 6.0. The Au SIMP SAM-modified electrode was applied successfully to the determination of dopamine in the presence of a high concentration of ascorbic acid. Selective detection was realized in total elimination of ascorbic acid response-a method different from the ones based on the potential separations. The detection limit of dopamine was 5.0 × 10(-8) mol L(-1) in a linear range from 1.0 × 10(-6) to 1.2 × 10(-4) mol L(-1) in the presence of 1.0 × 10(-3) mol L(-1) ascorbic acid. The interference studies also showed that the Au SIMP SAM-modified electrode exhibited good selectivity in the presence of a large excess of uric acid and could be employed for the determination of dopamine in pharmaceutical formulations, plasma samples and human urine with adequate selectivity and precision.     

Interaction of glucose oxidase with alkyl-substituted sepharose 4B

Glucose oxidase (GOD) is often used in immobilized forms for determination of glucose. To examine the possibility of its adsorption by hydrophobic interactions, palmityl-substituted Sepharose 4B (Sepharoselipid) was employed as an adsorptive matrix. Various conditions were used in tests to improve the limited immobilization of the enzyme observed under normal (native) conditions, including use of high concentrations of denaturing agents. Of the denaturants used, only the cationic detergent dodecyl trimethyl ammonium bromide was effective in denaturing the protein and exposing its hydrophobic sites for interaction with alkyl residues on the support. This, followed by the process of renaturation, provided catalytically active immobilized preparations. The apoenzyme, prepared by treatment of the holoenzyme with acidified (NH4)2SO4 or thermal denaturation, was totally immobilized on the support. Furthermore, it was shown that either flavin adenine dinucleotide (FAD) or the alkyl residues, not both, may interact with the nucleotide site at any given time. Results are discussed in terms of high rigidity of GOD molecule and limited exposure of hydrophobic sites in its native structure. The observations are in accord with suggestions in the literature that the FAD pocket is a very narrow channel of hydrophobic properties, adapted to accept its natural coenzyme.     

A new strategy for simultaneous determination of cysteamine in the presence of high concentration of tryptophan using vinylferrocene-modified multiwall carbon nanotubes paste electrode

The electro-oxidation of cysteamine (CA) and tryptophan (TP) were studied by vinylferrocene-modified carbon nanotubes paste electrode using cyclic voltammetry, chronoamperometry, electrochemical impedance spectroscopy, and square wave voltammetry. This modified electrode exhibits persistent electron-mediating behavior followed by well-separated oxidation peaks towards CA and TP with decreasing their overpotentials. For the mixture containing CA and TP, the peaks potential well separated from each other. Using the modified electrode, the kinetics of CA electrooxidation was considerably enhanced by lowering the anodic overpotential through a catalytic fashion. Using square wave voltammetry, simultaneous determination of AC and TP has been explored at the modified electrode. Their square wave voltammetrics peaks current increased linearly with their concentration at the ranges of 0.09–500 and 5.0–1,000?μM, respectively with the detection limits of 0.05 and 1.0?μM, respectively. The modified electrode was successfully used for the determination of the analytes in real samples with satisfactory results.     

Hydroxyapatite Wrapped Multiwalled Carbon Nanotubes/Ionic Liquid Composite Electrode: A High Performance Sensor for Trace Determination of Lead Ions

A nanocomposite consisting of multiwalled carbon nanotubes wrapped with hydroxyapatite (HA/MWCNTs) was used in the construction of a new composite paste electrode using an ionic liquid as the binder. The stable surface in aqueous solutions as well as the high sorptive behaviors towards heavy metal ions and the favorable charge transfer make the electrode highly efficient especially for stripping or adsorptive analysis. The analysis of Pb²⁺ as a model of heavy metal ions has been performed. Good sensitivity, detection limit, selectivity and reproducibility were obtained for the suggested sensor. The linear range of the electrode response covered four orders of magnitude (1 nM–10 µM), in two linear ranges. The obtained detection limit for Pb²⁺ was 2×10^?11 M.