Lead ion selective PVC membrane electrode based on 5,5'-dithiobis-(2-nitrobenzoic acid)

A PVC membrane electrode for lead ions based on 5,5′-dithiobis-(2-nitrobenzoic acid) as membrane carrier was prepared. The electrode exhibits a Nernstian response for Pb²⁺ over a wide concentration range (1.0×10⁻²–4.0×10⁻⁶ M). It has a relatively fast response time and can be used for at least 3 months without any divergence in potentials. The proposed electrode revealed good selectivities for Pb²⁺ over a wide variety of other metal ions and could be used in a pH range of 2.0–7.0. It was used as an indicator electrode in potentiometric titration of lead ions and in direct determination of lead in water samples.     

Synthesis of 1-oxa-2-silacyclopentane derivatives via intramolecular nucleophilic attack at silicon

Metalation of (HSiMe₂)₃CH with lithium diisopropylamide (LDA) in THF gives (HSiMe₂)₃CLi, which reacts with ethylene oxide, propylene oxide, 1,2-epoxy butane, 1,2-epoxy pentane, 1,2-epoxy hexane, and epichlorohydrin to give the corresponding 1-oxa-2-silacyclopentane derivatives. Then, glycidylmethacrylate (GM) random copolymers with styrene (St) (in a 1:1 and 1:3 mol ratio) were synthesized by solution free radical polymerization at 70(±1) °C using α,α′-azobis(isobutyronitrile) (AIBN) as an initiator. Both types of copolymers were treated with (HSiMe₂)₃CLi to give new modified copolymers. The reaction of (HSiMe₂)₃CLi with epoxides on the side chains of the copolymers does not lead to intramolecular nucleophilic attack contrary to simple epoxides. All the products have been characterized by spectroscopic techniques.     

Acetylenchemie 12. Mitt.: Weitere studien über die phasentransfer-katalysierte umsetzung des 9(10H)-acridinons mil alkinylhalogeniden

By the phase transfer catalyzed reaction of 9(10H)-acridinone with 1-bromo-2-propyne, 10-(2-propynyl)-9(10H)-acridinone is synthesized. As prototropic rearrangement products of this 10-(1,2-propadienyl)-9(10H)-acridinone and 10-(1-propynyl)-9(10H)-acridinone are obtained, Under the given conditins 1-bromo-2butyne leads to 10-(2-butynyl)-9(10H)-acridinone and 2-chloro-3-butyne leads to 10-(1-methyl-1,2-propddienyl)-9(10H)-acridinone, 10-(1-methyl-2-propynyl)-9(10H)-acridinone, 9-(1-methyl-2-propynyloxy)acridine and 10-[1-methyl-3-(3,4-dimethylphenyl-2-propynyl)]-9(10H)-acridinone. The formation of the products is experimentally confirmed and with published work compared.     

Simultaneous Kinetic‐Spectrophotometric Determination of Hydrazine and its Derivatives by Partial Least Squares and Principle Component Regression Methods

Simultaneous kinetic‐spectrophotometric determination of a ternary mixture of hydrazine (HZ) and its derivatives by principal component regression (PCR) and partial least squares (PLS) calibration is described. The methods were based on the difference observed in the reduction rate of iron(III) with HZ, thiosemicarbazide (TSCZ) and phenylhydrazine (PHZ) in the presence of 2,2′‐bipyridine (Bpy). The colored complex of [Fe(Bpy)₃]²⁺ was formed in sodium dodecyl sulfate (SDS) as micellar media, and then monitored at 520 nm. The results showed that simultaneous determination of HZ, TSCZ and PHZ could be performed in their concentration ranges of 1.0–70.0, 0.2–6.0 and 0.1–10.0 μg mL^?1, respectively. The root mean squares errors of prediction (RMSEP) of HZ, TSCZ and PHZ were 0.719, 0.164 and 0.105 (for PLS) 0.788, 0.166 and 0.993 (for PCR), respectively. Both methods (PCR and PLS) were validated using a set of synthetic sample mixtures and then applied for simultaneous determination of HZ, TSCZ and PHZ in water samples.     

A Lead‐Selective Membrane Electrode Based Upon a Phosphorylated Hexahomotrioxacalix[3]Arene

Solvent extraction of a mixture of Pb^II, Mn^II, Fe^III, Co^II, Ni^II and Cd^II in aqueous perchlorate medium by a phosphorylated hexahomotrioxacalix[3]arene (calix‐3) in dichloromethane shows a significant selectivity towards lead ions. The ligand can also be incorporated into a membrane to provide a new lead ion‐selective electrode (Pb^II‐ISE). A plasticized PVC membrane containing 30% PVC, 53.5% ortho‐nitrophenyloctylether (NPOE), 4.5% sodium tetraphenylborate (NaTPB) and 12% ionophore was directly coated on a graphite rod. This sensor gave a good Nernstian response of 29.7 ± 0.7 mV decade^?1 over a concentration range of 1 × 10^?8 – 1 × 10^?4 M of lead ions, independent of pH in the range 3‐7, with a detection limit of 0.4 × 10^?8 M. The dynamic response time of the electrode to achieve a steady potential was very fast and found to be less than 7 s. The selectivity relative to Ag⁺, NH₄⁺, Li⁺, Na⁺, K⁺, Ca²⁺, Sr²⁺, Ba²⁺, Mn²⁺, Fe²⁺, Co²⁺, Ni²⁺, Cu²⁺, Zn²⁺, Cd²⁺, Fe³⁺, La³⁺, Sm³⁺, Dy³⁺, Er³⁺, Y³⁺ and Th⁴⁺ was examined. The electrode exhibits adequate stability with good reproducibility (with a slope of 29.6 ± 1.5 mV for 8 weeks). The characteristics of the sensor are compared with those of a tetraphosphorylated calix[4]arene (calix‐4) based Pb^II‐ISE, reported recently. The electrode was successfully used as an indicator electrode for a potentiometric titration of a lead solution using a standard solution of EDTA. The applicability of the sensor for lead ion measurements in various synthetic samples was also investigated.     

One-pot three-component reaction of isocyanides, dialkyl acetylenedicarboxylates and phthalhydrazide: synthesis of highly functionalized 1H-pyrazolo[1,2-b]phthalazine-5,10-diones

Protonation of the highly reactive 1:1 intermediate produced in the reaction between alkyl isocyanides and electron-deficient acetylenic esters with phthalhydrazide, leads to a vinylisonitrilium cation, which undergoes an addition reaction with the conjugate base of the phthalhydrazide to produce dialkyl 3-(alkylamino)-5,10-dioxo-5,10-dihydro-1H-pyrazolo[1,2-b]phthalazine-1,2-dicarboxylates in fairly good yields at room temperature.     

Modification of carbon ceramic electrode prepared with sol-gel technique by a thin film of chlorogenic acid: application to amperometric detection of NADH

The carbon ceramic electrode prepared with sol-gel technique is modified by a thin film of chlorogenic acid (CGA). By immersing the carbon ceramic electrode in aqueous solution of chlorogenic acid at less than 2 s a thin film of chlorogenic acid adsorbed strongly and irreversibly on the surface of electrode. The cyclic voltammetry of the resulting modified CCE prepared at optimum conditions shows a well-defined stable reversible redox couple due to hydroquinone/quinone system in both acidic and basic solutions. The modified electrode showed excellent electrocatalytic activity toward NADH oxidation and it also showed a high analytical performance for amperometric detection of NADH. The catalytic rate constant of the modified carbon ceramic electrode for the oxidation of NADH is determined by cyclic voltammetry measurement. Under the optimised conditions the calibration curve is linear in the concentration range 1-120 μm. The detection limit (S/N = 3) and sensitivity are 0.2 μM and 25 nA μM⁻¹.The results of six successive measurement-regeneration cycles show relative standard deviations of 2.5% for electrolyte solution containing 1 mM NADH, indicating that the electrode renewal gives a good reproducible and antifouling surface. The advantages of this amperometric detector are: high sensitivity, excellent catalytic activity, short response time t < 2 s, remarkable long-term stability, simplicity of preparation at short time and good reproducibility.     

Synthesis and structural characterization of trivalent amino acid derived chiral phosphorus compounds

Reaction of the N-toluenesulfonyl derivatives of (S)-alanine, phenylalanine, and valine (4-6) with PhPCl(2) gave in high yield the 4-methyl, benzyl, and isopropyl derivatives (7-9) of 2-phenyl-1-p-toluenesulfonyl-1,3,2-oxazaphospholidin-5-one. The ratios of the (2S,4S)/(2R,4S) diastereomers (cis/trans isomers) were 1:1, 2:1, and 10:1 for the methyl, benzyl, and isopropyl derivatives 7a,b, 8a,b, and 9a,b, respectively. For 7a,b, both isomers could be crystallized, but for the others only the major isomers were isolable. The X-ray crystal structure of 9a shows that the isopropyl and phenyl groups are mutually cis and that the tolyl moiety is oriented s-trans to both the isopropyl and phenyl groups. Reaction of 6 with Cl(2)PCH(2)CH(2)PCl(2) (10) gave a 56:38:7 mixture of the cis/cis, cis/trans, and trans/trans diphosphorus heterocycles 11a-c. The major isomer could be crystallized and isolated free of the other diastereomers. Reaction of 6 with EtPCl(2) gave a 6:1 mixture of cis/trans isomers of the ethyl-substituted heterocycles 12a,b as an inseparable oil but allowed confirmation of the structure of 11a. Slow epimerization at phosphorus may occur by inversion but more likely by ring opening/closure, since 7b, 9a, and 11a give rise upon standing in solution to mixtures containing starting material and 7a, 9b, and 11b, respectively, along with the free amino acid derivatives 4 and 6. The NMR spectra, and in particular the coupling constants between the alpha-hydrogen atom of the amino acid moiety and phosphorus, were used to establish the identities of the cis and trans isomers. Reaction of 9a with (THF)W(CO)(5) gave the phosphorus-ligated adduct (9a)W(CO)(5) (13), and the IR spectrum of this complex shows that 9a is a strongly electron-withdrawing ligand. The geometry of the sulfonamide moiety is discussed in detail, as are the (1)H NMR coupling constants. The data are consistent with the presence of little steric interaction between the cis isopropyl and phosphorus substituent in 9a, 11a, and 12a and orientation of the tolyl moiety s-cis to the isopropyl group in 9b, 12b, and 13.     

Headspace solvent microextraction A new method applied to the preconcentration of 2-butoxyethanol from aqueous solutions into a single microdrop

A new procedure and experimental setup for the headspace solvent microextraction of volatile organic materials from aqueous sample solutions is described. The extraction occurs by suspending a 3-μl drop of the solvent from the tip of a microsyringe to the headspace of a stirred aqueous sample solution for a preset extraction time. The temperature of the microdrop and the bulk of sample solution should be kept constant at optimized values. The sample analyses were carried out by gas chromatography. The procedure was successfully applied to the extraction and determination of 2-butoxyethanol from content of some color samples used for painting the outer coverage of some machines such as coolers, refrigerator, cloths machine, etc. Parameters such as extraction time, nature of extraction solvent, size of microdrop, sample volume, stirring rate, ionic strength and pH of sample solution were studied and optimized, and the method performance was evaluated.     

Al Electrode Modified by Au Atoms as a Novel Electrode for Electrocatalytic Oxidation of Thiosulfate

An aluminum electrode modified with gold atoms was introduced as a novel electrode. Gold atoms were deposited both chemically and electrochemically onto the aluminum electrode to make an aluminum/gold (Al/Au) modified electrode (ME). The experimental results showed that the Al/Au modified electrode prepared by chemical deposition, exhibits much more current than the electrochemical deposition method. The electrochemical behavior of the Al/Au modified electrode was studied by cyclic voltammometry. This modified electrode showed two pairs of peaks, a₁c₁ and a₂c₂, with surface‐confined characteristics in a 0.5 M phosphate buffer. The dependence of E_pa of the second peak (a₂c₂) on pH shows a Nernestian behavior with a slope of 55 mV per unit pH. The effect of different supporting electrolytes, solution's pH and different scan rates on electrochemical behavior of Al/Au modified electrode was studied. Au deposited electrochemically on a Pt electrode (Pt/Au) was also used as another modified electrode. A comparative study of electrochemical behavior of bare Al, Pt/Au and Al/Au modified electrodes showed that both Pt/Au and Al/Au electrodes have the ability of electrocatalytic oxidation of S₂O₃^2?, but the electrocatalytic oxidation on the latter was better than the former. The kinetics of the catalytic reaction was investigated by using cyclic voltammetry and chronoamperometry techniques. The average value of the rate constant for the catalytic reaction and the diffusion coefficient were evaluated by means of chronoamperometry technique.