A comprehensive Monte Carlo simulation of styrene atom transfer radical polymerization

<正>An optimized and high-performance Monte Carlo simulation is developed to take thorough account of four different cases of termination in styrene ATRP.According to the simulation results,the bimolecular termination rate constant sharply drops throughout the polymerization when either chain-length dependency of termination rate constant,gel effect,or both together is applied to the simulation.In addition,as expected,the initiator is quickly decomposed at the early stages of the polymerization.The concentration of the catalyst in lower oxidation state decreases at first and then plateaus at higher conversion;furthermore,the steady concentration of M_t~nY/L in the polymerization is the highest when the chain-length-dependent diffusion-controlled termination rate constant is employed in the simulation.The rates of deactivation and chain end degradation reactions are also smaller in this case.Therefore,the fraction of dormant chains is higher throughout the reaction and consequently the portion of dead polymers decreases.Besides,molecular weight increases linearly with conversion;however,when neither gel effect nor chain-length dependency of termination rate constant is considered,the molecular weight deviates from linearity at the end of the reaction.The peak of chain length distribution shifts toward higher molecular weight too during the reaction.Finally,the molecular weight distribution broadens at higher conversion;however, the chain length distribution of polymers produced under conditions of applying chain-length-dependent diffusion-controlled termination rate constant is narrower.     

A convenient synthesis of 1,5-diarylpyrazoles from Baylis-Hillman adducts using HY-zeolite

<正>A facile and convenient protocol was developed for the synthesis of 1,5-diarylpyrazoles using Baylis-Hillman adducts in the presence of HY-zeolite as an efficient recyclable heterogeneous catalyst in reasonable reaction times(1.5-2.5 h) and high yields (78-90%).     

An efficient chemoselective synthesis of O-vinylaryl systems using acetylenic esters and dihydroxybenzenes in the presence of triphenylphosphine or alkyl isocyanides

<正>The addition of 2,4-dihydroxyaceto(and benzo)phenone to propiolic ester is catalyzed by triphenylphosphine or tert-butyl isocyanide to form O-vinyl aryl derivatives in fairly good yields.     

Mixed Ligand Palladium(Ⅱ) Complex with NS-Bidentate S-Allyldithiocarbazate Schiff Base: Synthesis, Spectral Char-acterization, Crystal Structure and Decoding Intermolecular Interactions with Hirshfeld Surface Analysis

A new mixed ligand palladium(II) complex with bidentate NS‐donor chelate, [PdCl(PPh₃)L] (L: S‐allyl β‐N‐(benzylidene)dithiocarbazate), has been prepared and characterized using single crystal X‐ray diffraction and spectroscopic (electronic, IR, ¹H NMR and ¹³C NMR) techniques. The shorter Pd? P bond distance, 2.255(7) Å, than the sum of the single bond radii for palladium and phosphorus (2.41 Å), showed partial double bond character. Visualizing and exploring the crystal structure using Hirshfeld surface analysis showed the presence of π··· π, N··· π, C? H··· π, Cl···H and weak C? H···S interactions as most important intermolecular interactions in the crystal lattice, which are responsible to extension of the supramolecular network of the compound and stabilization of the crystal structure.     

Monitoring of Anti Cancer Drug Letrozole by Fast Fourier Transform Continuous Cyclic Voltammetry at Gold Microelectrode

A continuous cyclic voltammetric study of letrozole at gold microelectrode was carried out. The drug in phosphate buffer (pH 2.0) is adsorbed at ?200 mV, giving rise to change in the current of well‐defined oxidation peak of gold in the flow injection system. The proposed detection method has some of advantages, the greatest of which are as follows: first, it is no more necessary to remove oxygen from the analyte solution and second, this is a very fast and appropriate technique for determination of the drug compound in a wide variety of chromatographic analysis methods. Signal‐to‐noise ratio has significantly increased by application of discrete Fast Fourier Transform (FFT) method, background subtraction and two‐dimensional integration of the electrode response over a selected potential range and time window. Also in this work some parameters such as sweep rate, eluent pH, and accumulation time and potential were optimized. The linear concentration range was of 1.0×10^?7?1.0×10^?10 mol/L (r=0.9975) with a limit of detection and quantitation 0.08 nmol/L and 0.15 nmol/L, respectively. The method has the requisite accuracy, sensitivity, precision and selectivity to assay letrozol in tablets. The influences of pH of eluent, accumulation potential, sweep rate, and accumulation time on the determination of the letrozol were considered.     

碱性介质中 (氢) 氧化铜修饰电极电催化氧化蔗糖

 A stable copper (hydr)oxide-modified electrode was prepared in 0.5 mol/L NaOH solution by cyclic voltammetry in the range of -250 to 1 000 mV. It can be used for electrochemical studies in the range of -250 to 1 000 mV without interfering peaks because there is no oxidation of copper. During an anodic potential sweep, the electro-oxidation of saccharose on Cu occurred by the formation of Cu^III and this reaction also occurred in the early stages of the reversed cycle until it is stopped by the negative potentials. A mechanism based on the electro-chemical generation of Cu^III active sites and their subsequent consumption by saccharose was proposed, and the rate law and kinetic parameters were obtained. The charge transfer resistance from theoretical and impedance studies was used to verify the mechanism. Under chronoamperometry regimes, the reaction followed Cottrellian behavior. The transfer of up to 21 electrons was observed in further investigations of the electro-oxidation of saccharose on a (hydr)oxide Cu rotating disk electrode.     

Determination of captopril in patient human urine using ferrocenemonocarboxylic acid modified carbon nanotubes paste electrode

<正>In this work,we describe a new strategy for the electrochemical determination of captopril(CA) using ferrocenemonocarboxylic acid as a mediator and multiwall carbon nanotubes as sensors in aqueous solution at pH 7.0.The diffusion coefficient(D),and the kinetic parameters such as electron transfer coefficient(α).and heterogeneous rate constant(k_h),for CA were also determined using electrochemical approaches.Under the optimized conditions,the electrocatalytic oxidation peak current of captopril showed two linear dynamic ranges with a detection limit of 0.3×10~(-6) mol L~(-1) captopril.The linear calibration range was 0.8×10~(-6) to 65×10~(-6) mol L~(-1) using cyclic voltammetry.Finally,this modified electrode was also examined as a selective,simple and precise new electrochemical sensor for the determination of captopril in real samples such as drug and patient human urine.     

One-pot, three-component reaction of isocyanides, dialkyl acetylenedicarboxylates, and non-cyclic anhydrides: synthesis of 2,5-diaminofuran derivatives and dialkyl (E)-2-[(N-acyl-N-alkylamino)carbonyl]-2-butenedioates

Abstract  

Isocyanides, dialkyl acetylenedicarboxylates, and non-cyclic anhydrides, for example acetic anhydride or benzoic anhydride, react in one-pot to afford 2,5-diaminofuran derivatives and dialkyl (E)-2-[(N-acyl-N-alkylamino)carbonyl]-2-butenedioates in fairly good yields at room temperature.     

Biotransformation of some monoterpenoid ketones by <Emphasis Type="Italic">Chlorella vulgaris</Emphasis> MCCS 012

Biotransformation of several monoterpene ketones, including carvone, pulegone, piperitone, menthone, and fenchone, was carried out by the locally isolated unicellular microalgae Chlorella vulgaris. The microalgal strain was isolated during a screening program from soil samples collected from paddy-fields of Fars Province, in the south of Iran. Chlorella vulgaris was cultured in 250 mL conical flasks, each containing 50 mL of BG-11 liquid medium and 20 μL levels of terpene substrates, incubated at a temperature of 28±2°C and illuminated continuously with fluorescent lamps with shaking at 80 rpm. The metabolites were identified by thin-layer chromatography and GC-MS. Chlorella vulgaris has the ability to reduce the C=C double bond of carvone to yield trans-dihydrocarvone and cis-dihydrocarvone. The cell line reduced menthone and pulegone to the same product and gave menthol. Study of Chlorella vulgaris with substrates of piperitone and fenchone showed no reaction in these substrates. Chlorella vulgaris MCCS 012 was assigned according to the 18S rRNA gene sequence. The DNA sequence of the 18S rRNA gene of Chlorella vulgaris MCCS 012 was recorded in the NCBI under the accession number EU374170.     

Electrocatalytic oxidation of nitrite at a terpyridine manganese(II) complex modified carbon past electrode

A carbon past electrode modified with [Mn(H₂O)(N₃)(NO₃)(pyterpy)], ( \textpyterpy = 4￠- ( 4 - \textpyridyl ) - 2,2￠:\text6￠,\text2￠￠- \textterpyridine ) \left( {{\text{pyterpy}} = 4\prime - \left( {4 - {\text{pyridyl}}} \right) - 2,2\prime:{\text{6}}\prime,{\text{2}}\prime\prime - {\text{terpyridine}}} \right) complex have been applied to the electrocatalytic oxidation of nitrite which reduced the overpotential by about 120 mV with obviously increasing the current response. Relative standard deviations for nitrite determination was less than 2.0%, and nitrite can be determined in the ranges of 5.00 × 10⁻⁶ to 1.55 × 10⁻² mol L⁻¹, with a detection limit of 8 × 10⁻⁷ mol L⁻¹. The treatment of the voltammetric data showed that it is a pure diffusion-controlled reaction, which involves one electron in the rate-determining step. The rate constant k′, transfer coefficient α for the catalytic reaction, and diffusion coefficient of nitrite in the solution, D, were found to be 1.4 × 10⁻², 0.56× 10⁻⁶, and 7.99 × 10⁻⁶ cm² s⁻¹, respectively. The mechanism for the interaction of nitrite with the Mn(II) complex modified carbon past electrode is proposed. This work provides a simple and easy approach to detection of nitrite ion. The modified electrode indicated reproducible behavior, anti-fouling properties, and stability during electrochemical experiments, making it particularly suitable for the analytical purposes.