Laser induced mixing in multilayered Ti/Ta thin film structures

The possibility of interlayer mixing in a Ti/Ta multilayer system, induced by laser irradiation, was the main purpose of these experiments. Ti/Ta multilayer system, consisting of ten alternating Ti and Ta thin films and covered by slightly thicker Ti layer, was deposited on Si (100) wafers to a total thickness of 205 nm. Laser irradiation was performed in air by picoseconds Nd:YAG laser pulses in defocused regime with fluences of 0.057 and 0.11 J cm^?2. Laser beam was scanned over the 5?×?5 mm surface area with different steps along y-axes. Structural and compositional characterisation was done by auger electron spectroscopy, X-ray photoelectron spectroscopy, atomic force microscopy, and scanning electron microscopy. Laser processing at lower fluence caused only oxidation of the top Ti layer, despite of the number of applied laser pulses. Interlayer mixing was not observed. Application of laser pulses at fluence of 0.11 J cm^?2 caused partial and/or complete ablation of deposited layers. In partially ablated regions considerable mixing between Ti and Ta films was registered.     

Analysis of fiber optic SPR sensor utilizing platinum based nanocomposites

SPR based fiber optic sensor using nanocomposite is presented. Nanocomposites comprising of Pt nanoparticles with various volume fractions embedded in dielectric matrices of TiO₂ and SnO₂ are considered. Sensitivity enhances with increase in thickness of nanocomposite and volume fraction of nanoparticles for both nanocomposites. Optimized thicknesses are obtained to be 40 and 50 nm for Pt–TiO₂ and Pt–SnO₂ nanocomposites respectively while optimized volume fraction is found to be 0.85 for both nanocomposites. 40 nm thick Pt–TiO₂ nanocomposite based sensor with 0.85 volume fraction possesses utmost sensitivity.     

Theoretical diagnostic and prediction of physical properties of quaternary InGaAsP compound using artificial neural networks optimized by the Levenberg Maquardt algorithm

The quaternaries \(In_{1 - x} Ga_{x} As_{y} P_{1 - y}\) are the main promising elements for the fabrication of optoelectronic devices. The adjustment of their physical parameters is assumed by the change of the molar fraction \(x\) and \(y\). These parameters can be affected by the variation of temperature and pressure. To make the theoretical diagnosis of these materials, it is fundamental to know the energy gap ‘\(\varvec{E}_{\varvec{g}}\)’ and the lattice parameter ‘\(a\)’, over a wide range of chemical compositions \(0 \le x \le 0.47\) and \(0 \le y \le 1\), at different temperatures and pressures. We show that by using the Artificial Neural Network method optimized by the Levenberg Maquardt algorithm ANN-LM, it is possible to obtain results very close to the experiment. The scatter plot and error calculation show that the ANN-LM model provides more accurate values of the lattice parameter than those calculated by Vegard’s law. On the other hand, the energy gap values \(Eg (x, y, T)\) estimated, using the ANN-LM model, proved to be close to the experimental values that those calculated by the empirical equations. In addition, the ANN-LM method allowed us to estimate with great accuracy the values of the energy gap at different temperatures and pressures \(Eg (P, T)\). Our work provides crucial information on the physical properties of the quaternary without the use of approximations, and without taking into account the hypothesis of a perfect agreement between \(InGaAsP\) and \(InP\) substrate.     

Conservation laws,modulation instability and solitons interactions for a nonlinear Schrödinger equation with the sextic operators in an optical fiber

Under investigation in this paper is a sextic nonlinear Schrödinger equation, which describes the pulses propagating along an optical fiber. Based on the symbolic computation, Lax pair and infinitely-many conservation laws are derived. Via the modiied Hirota method, bilinear forms and multi-soliton solutions are obtained. Propagation and interactions of the solitons are illustrated graphically: Initial position and velocity of the soliton are related to the coefficient of the sixth-order dispersion, while the amplitude of the soliton is not affected by it. Head-on, overtaking and oscillating interactions between the two solitons are displayed. Through the asymptotic analysis, interaction between the two solitons is proved to be elastic. Based on the linear stability analysis, the modulation instability condition for the soliton solutions is obtained.     

Improving quality of service in four-channel WDM ethernet passive optical network

Energy-efficiency and green communications have become dominant topics related to access network implementation, since their energy consumption is a major contributor of energy consumption within the Internet. In this paper we analyze an implementation of a new energy-efficient dynamic bandwidth algorithm in a four-channel Wavelength Division Multiplexing Ethernet Passive Optical Network (WDM EPON), in which wavelength assignments take place per service class and not per Optical Network Unit (ONU). The improved Dynamic Bandwidth Allocation (DBA) algorithm introduces independent bandwidth allocation for each wavelength, which results in efficient bandwidth management and utilization. The mathematical model for new DBA algorithm is described, as are changes to the Multi-Point Control Protocol (MPCP), necessary for its implementation. The obtained results show that the redefined DBA algorithm improves Key Performance Indicators (KPIs) and as a consequently enables delivery of enhanced services to end-users. Significant energy savings are achieved without Quality of Service (QoS) degradation, and without network or equipment architecture changes.     

Modeling the effects of interband and intraband transitions on phase and gain stabilities of quantum dot semiconductor optical amplifiers

In this paper, the effects of interband and intraband transitions on the gain and phase stabilities in quantum dot semiconductor optical amplifier (QD-SOA) are investigated both temporally and spectrally employing electrical and optical pumping schemes. For this purpose, the carrier rate equations in different energy states coupled to the traveling wave optical field equation have been numerically solved to derive the dynamical behavior of QD-SOA. Our results show that the gain and phase response can be stabled under optical pumping (OP) scheme because the role of the interband and intraband transitions on the dynamics of QD-SOA is reduced. This behavior leads to high-speed pattern effect-free cross-phase modulation (XPM) in QD-SOA. It is found that optically pumped QD-SOA can have high performance in phase based applications. Moreover, it is shown that under OP scheme although the QD-SOA has lower gain value and slower gain recovery time, the ultrafast cross-gain modulation (XGM) without pattern effect is possible and the phase is recovered within a shorter time compared to EP scheme. The behavior arises from the different capacity of the carrier reservoir for pumping schemes.     

Dispersion behavior of electromagnetic wave near the resonance in 1D magnetized ferrite photonic crystals

In the present article, we have analyzed the dispersion of electromagnetic wave in the one dimensional magnetized ferrite photonic crystals near the resonance in the permeability of the constituent materials for transverse magnetization in the transverse electric mode. The dispersion relation is obtained by transfer matrix method. It is observed that in the vicinity of resonant frequency, large numbers of oscillations occur in the normalized Bloch wave number. These oscillations in the Bloch wave number are strongly dependent on external magnetic fields, filling factor, and damping constant. The frequency regime of these oscillations is found to be shifted in higher frequency range with increase in the magnitude of the magnetic fields. With increase in the filling factor keeping length of periods fixed, number of oscillations is found to be increased. Near the resonance, effect of incident angle is negligible. It is demonstrated that these nearly equidistant oscillations occurring in the vicinity of resonance may be used for making filter in micro wave frequency range.     

Broadband LWIR and MWIR absorber by trapezoid multilayered grating and SiO<Subscript>2</Subscript> hybrid structures

A broadband metamaterial absorber with high absorption simultaneously in mid-wave infrared (MWIR) and long-wave infrared (LWIR) was proposed. In the MWIR, the absorption higher than 0.8 is from 4 to 6.3 µm, while the absorption in the LWIR is from 8.7 and 9.6 µm. The absorber is insensitive to the incident angle. The broadband absorption in the MWIR is due to the slow-light effect of the trapezoid multilayered grating structure. And the broadband absorption in the LWIR is due to the phonon polariton resonant of trapezoid SiO₂ layer. In the broadband high absorption region, the atmosphere is transparent, which may greatly promote the practical application of the absorber in double-color IR imaging, detecting, infrared stealth and thermal emitting.     

Quantum non-demolition phonon counter with a hybrid optomechnical system

A phonon counting scheme based on the control of polaritons in an optomechanical system is proposed. This approach permits us to measure the number of phonons in a quantum non-demolition (QND) manner for arbitrary modes not limited by the frequency matching condition as in usual photon-phonon scattering detections. The performance on phonon number transfer and quantum state transfer of the counter are analyzed and simulated numerically by taking into account all relevant sources of noise.