Symmetrical and Asymmetrical Bisphosphonate Esters. Synthesis, Selective Hydrolysis, and Isomerization

Two simple and efficient one-pot procedures for the synthesis of a series of α-branched N-heterocycle-substituted methane-1,1-bisphosphonates are outlined. In the first method, the parent halosubstrates were reacted with cyanomethylphosphonate followed by reaction with dialkyl phosphonates to give asymmetrical or symmetrical bisphosphonates (BPs). In the second approach, the same halocompounds were reacted with tetraethyl methyl-1,1-bisphosphonate to give the requisite BPs. Partial and complete hydrolysis of the prepared BPs were also investigated. The products contain functional groups advantageous for further synthetic modification as structural units for coupling with the drug.     

SIMPLE TECHNIQUES FOR DETERMINING THE SMALL-SIGNAL EQUIVALENT CIRCUIT OF MESFET’s

Simple techniques for determining the broadband small signal equivalent circuit (SSEC) of MESFETs are presented in this paper. The intrinsic elements are calculated using two-dimensional method from the Y parameters, which are obtained from the Fourier analysis of the device transient response to voltage-step perturbations at the drain and gate electrodes. Whereas, the parasitic external elements are determined by simple approximations used in transmission line modeling. In addition, a new technique is also proposed to determine the source and drain series resistances. A comparison of the SSEC of three different MESFETs technologies shows that the MESFETs on GaN and 4H-SiC are suitable for high power applications. The method used to determine the intrinsic elements is validated with simulated data obtained by Monte Carlo method.     

Transient creep during transformation in Cd-Zn alloys

Transient creep of Cd-2 wt. % Zn and Cd-17·4 wt. % Zn alloys has been studied under different constant stresses ranging from 6·4 MPa to 12·7 MPa near the transformation temperature. The results of both compositions showed two transient deformation regions, the low temperature region (below 483 K) and the high temperature region (above 483 K). From the transient creep described by the equation _tr=Bt ⁿ, where _tr andt are the transient creep strain and time. The parametersB andn were calculated. The parameterB was found to change with the applied stress from 0·3×10^–4 to 3×10^–4 and from 0·6×10^–4 to 18×10^–4 for Cd-2 wt. % Zn and Cd-17·4 wt. % Zn, respectively. The exponentn was found to change from 0·8 to 0·95 for both alloys. The parameterB was related to the steady state creep rate through the equation , the exponent was found to be 0·5 for Cd-2 wt. % Zn and 0·6 for the eutectic composition. The activation energies of transient creep in the vicinity of the transformation regions (above 483 K) were found to be 50·2 kJ/mole for Cd-2 wt. % Zn and 104·7 kJ/mole for the eutectic composition characterizing the mechanisms of grain boundary diffusion and volume diffusion in Cd, respectively.     

Spectrofluorimetric determination of guanethidine sulphate,guanfacine hydrochloride,guanoclor sulphate and guanoxan sulphate in tablets and biological fluids,using benzoin

A sensitive and rapid Spectrofluorimetric method for the determination of guanethidine sulphate, guanfacine hydrochloride, guanoclor sulphate and guanoxan sulphate in tablets and spiked human serum and urine samples is described. The method is based on the reaction of monosubstituted guanidino compounds in an aqueous potassium hydroxide solution with benzoin, in the presence of -mercaptoethanol and sodium sulphite. Highly fluorescent derivatives were obtained, with excitation and emission maximum wavelengths around 325 and 430 nm, respectively. In optimal reaction conditions, the linearity ranges were 0.04–0.28 g/ml, with relative standard deviations less than 2%. The method has been successfully applied to the determination of these drugs in tablets. The results are highly correlated with the B.P. method. Chloroform (or for guanoxan dichloromethane) was used to extract the drugs from serum and urine at basic pH, followed by the proposed fluorimetric method. The limit of detection is 0.02 g/ml for the selected drugs.     

Ungewöhnliche Bildung und Struktur eines O‐Sulfinato‐Zinkkomplexes

Unusual Formation and Structure of a O‐Sulfinato Zinc Complex Whereas the reaction between hydrotris[(N‐xylyl)‐thioimidazolyl]borato‐zinc perchlorate ([ L· Zn‐OClO₃]) and ethanethiolate under an inert atmosphere leads to the thiolate complex [ L· Zn‐SC₂H₅], the same reaction in air produces the sulfinato complex [ L· Zn‐O‐S(O)‐C₂H₅] ( 1 ). 1 is the first fully characterized sulfinato‐zinc complex. Its structure determination has confirmed the unusual coordination of the sulfinato ligand via one of its oxygen atoms.     

Loganin,loganic acid and periclymenoside,a new biosidic ester iridoid glucoside from Lonicera periclymenumL. (Caprifoliaceae)

Loganin ( 1 ), loganic acid ( 2 ), and periclymenoside ( 3 ) have been isolated from Lonicera periclymenum L . The structure of the new compound 3 and the identity of the others have been determined by chemical transformations and interpretation of the spectral data.     

Solvation numbers and hydration constant for thorium(IV) in ethanol-water medium

The solvation number and hydration constant of Th⁴⁺ in ethanol-water medium were determined at 25°C using UV-spectral and electrochemical measurements. A solvate formation equilibrium is demonstrated and characterized. Three molecules of ethanol (S) can bond to the metal cation with strengths comparable to that for H₂O to form ThS₃(H₂O) ₃ ⁴⁺ Formation of thorium monochelate with lawsone (2-hydroxy-1,4-naphthoquinone) eliminates bonding with alcohol molecules. The dissociation constant of the chelating agent_sK_a and the formation contant of the monochelated metal ion_sK _f ^* that are essentially independent of the solution composition are evaluated. Hydration titrations involving thorium-lawsone monochelate are performed and the data obtained from the changes of pH with solvent composition are analyzed. The solution independent constant,_sK _f ^* for thorium-lawsone complex formation in mixed aqueous ethanol is given by $$log_s K_f * = vpK_a + log_s K_h - log[LH] - vpH + 3logv$$ where vpK_a is the dissociation constant of the chelating agent LH in the solvent system of ν volume fraction of water and_sK_h is the solution-independent hydration constant of thorium (IV) in the solvent system. Log-values for the constants_sK_h,_sK _f ^* and_sK _a ^* are found to be 7.8±0.02, 11.38±0.04 and ?0.753, respectively.