宜产葛根中微量元素含量的测定

原子吸收分光光度法测定了宜昌地区产葛根中的Cu．Fe．Zn、Mn、Mo．Mg、Se等6种微量元素。为葛根的药效进一步研究和综合开发利用提供了新的科学依据。     

Strong visible PL from the nc-Si thin film by Ni silicide mediated crystallization

We studied the growth of nanocrystalline silicon (nc-Si) thin film exhibiting a strong room temperature photoluminescence (PL) at 1.81–2.003 eV. The amorphous silicon was crystallized by Ni silicide mediated crystallization (Ni SMC) and then Secco-etched to exhibit the PL. The PL peak energy and intensity increase with increasing the metal density on the a-Si because of the reduction in the grain size down to 2 nm. The photoluminescence energy and peak intensity depend strongly on the Secco etch time because the grain size is reduced by etching the grain boundaries.     

On the characterization of continuum structure functions

A continuum structure function is a non-decreasing mapping from the unit hypercube to the unit interval. Within the class of continuum structure functions, new axiomatic characterizations of the Natvig and the Barlow-Wu subclass are obtained.     

Correlation between Al2O3 particles and interface of Al-Al2O3 coatings by cold spray

Al-Al₂O₃ composite coatings with different Al₂O₃ particle shapes were prepared on Si and Al substrate by cold spray. The powder compositions of metal (Al) and ceramic (Al₂O₃) having different sizes and agglomerations were varied into ratios of 10:1 wt% and 1:1 wt%. Al₂O₃ particles were successfully incorporated into the soft metal matrix of Al. It was found that crater formation between the coatings and substrate, which is typical characteristic signature of cold spray could be affected by initial starting Al₂O₃ particles. In addition, when the large hard particles of fused Al₂O₃ were employed, the deep and big craters were generated at the interface between coatings and hard substrates. In the case of pure soft metal coating such as Al on hard substrate, it is very hard to get proper adhesion due to lack of crater formation. Therefore, the composite coating would have certain advantages.     

CO（ a）+ NO（X）传能体系中的新传能通道

在相对碰撞平动能为 0 .0 5eV的分子束实验条件下 ,研究了亚稳态CO(a) +NO(X)的E E传能通道 .通过测量和分析交碰区的传能发射光谱 ,在 780和 860nm处观测到了NO(b -a)跃迁Ogawa带的△v =+ 4和△v =+ 3序的发射光谱 .从而首次在实验上直接证实了传能过程中第四通道的存在 (CO (a) +NO(X)→CO (X) +NO(b) ) .这一通道的发现解释了前人测量到的在CO(a)与NO(X)碰撞传能过程中CO(a)的猝灭速率远大于NO(A ,B)生成速率的实验结果 ,并进一步证实了这一“经典”E E传能体系为电子交换机理的传能观点     

A spring-embedding approach for the facility layout problem

The facility layout problem is concerned with finding the most efficient arrangement of a given number of departments with unequal area requirements within a facility. The facility layout problem is a hard problem, and therefore, exact solution methods are only feasible for small or greatly restricted problems. In this paper, we propose a spring-embedding approach that unlike previous approaches results in a model that is convex. Numerical results demonstrating the potential of our model and the efficiency of our solution procedure are presented.     

The Characteristic of Threading Dislocation in Different Structures GaN Films Grown by MOCVD

Three mechanisms to reduce threading dislocations(TDs) in GaN films as the epitaxial films grow thicker are suggested by SEM and TEM     

Experimental Evaluation of Strain Shielding in Distal Femur in Revision TKA

Theoretical concerns about the use of cemented and press-fit stems in revision total knee arthroplasty (TKA) include stress shielding with adverse effects on prosthesis fixation. Radiological studies have showed distal femoral bone resorption after revision TKA. The revision with use of stems can place abnormal stresses. These stresses can promote the effect of bone stress shielding and may contribute to bone loss. Experimental quantification of strain shielding in the distal synthetic femur following TKA is the main purpose of the present study. Three different constructs of TKA were assessed. The first construct included a stemless femoral component. The other two included a press-fit and a cemented femoral stem. Cortical bone strains were measured experimentally with tri-axial strain gauges in synthetic femurs before and after in-vitro knee surgery. The difference between principal strains of implanted and intact femur was calculated for each strain gauge position. This study indicates that the use of stems in distal femur changes the distribution and magnitude of bone strains. The press-fit stem provoked relevant bone area (stem length) subjected to strain shielding and also originated the highest reduction of strains in the distal region, which can potentially induce bone resorption. The stemless implanted femur produced minor bone strain changes relatively to the intact femur. The use of distal femur stems increases initial stability in the bone, but the observed reduction of strains in this region, relative to the intact femur, provokes strain shielding that can induce bone resorption and may compromise the long term implant stability.     

Photonic crystals--a step towards integrated circuits for photonics.

The field of photonic crystals has, over the past few years, received dramatically increased attention. Photonic crystals are artificially engineered structures that exhibit a periodic variation in one, two, or three dimensions of the dielectric constant, with a period of the order of the pertinent light wavelength. Such structures in three dimensions should exhibit properties similar to solid-state electronic crystals, such as bandgaps, in other words wavelength regions where light cannot propagate in any direction. By introducing defects into the periodic arrangement, the photonic crystals exhibit properties analogous to those of solid-state crystals. The basic feature of a photonic bandgap was indeed experimentally demonstrated in the beginning of the 1990s, and sparked a large interest in, and in many ways revitalized, photonics research. There are several reasons for this attention. One is that photonic crystals, in their own right, offer a proliferation of challenging research tasks, involving a multitude of disciplines, such as electromagnetic theory, nanofabrication, semi-conductor technology, materials science, biotechnology, to name a few. Another reason is given by the somewhat more down-to-earth expectations that photonics crystals will create unique opportunities for novel devices and applications, and contribute to solving some of the issues that have plagued photonics such as large physical sizes, comparatively low functionality, and high costs. Herein, we will treat some basics of photonic crystal structures and discuss the state-of-the-art in fabrication as well give some examples of devices with unique properties, due to the use of photonic crystals. We will also point out some of the problems that still remain to be solved, and give a view on where photonic crystals currently stand.     

A New Bibenzyl Glycoside from Dendrobium moniliforme

A new bibenzyl glycoside has been isolated from the stems of Dendrobium moniliforme (L.) Sw.(Orchidaceas).Its structure has been identified on the basis of spectroscopic and chemical methods.