Heavy metal analysis of rainwaters: A comparison of TXRF and ASV analytical capabilities

The aim of this work consisted on the implementation of sufficiently accurate and sensitive analytical procedure for the analysis of metal concentration in rainwater. Different sample preparation procedures were tested to achieve the required concentration prior to direct total reflection X-ray fluorescence (TXRF) analysis. TXRF and anodic stripping voltammetry (ASV) were compared in regard to achieved detection limits, precision and accuracy.     

Use of chelating resins and inductively coupled plasma mass spectrometry for simultaneous determination of trace and major elements in small volumes of saline water samples

For some saline environments (e.g. deeply percolating groundwater, interstitial water in marine sediments, water sample collected after several steps of fractionation) the volume of water sample available is limited. A technique is presented which enables simultaneous determination of major and trace elements after preconcentration of only 60 mL sample on chelating resins. Chelex-100 and Chelamine were used for the preconcentration of trace elements (Cd, Cu, Pb, Zn, Sc) and rare earth elements (La, Ce, Nd, Yb) from saline water before their measurement by inductively coupled plasma mass spectrometry. Retention of the major elements (Na, Ca, Mg) by the Chelamine resin was lower than by Chelex; this enabled their direct measurement in the solution after passage through the resin column. For trace metal recoveries both resins yield the same mass balance. Only Chelex resin enabled the quantitative recovery of rare earth elements. The major elements, trace metals and rare earth elements cannot be measured after passage through one resin only. The protocol proposes the initial use of Chelamine for measurement of trace and major elements and then passage the same sample through the Chelex resin for determination of the rare earth elements. The detection limit ranged from 1 to 12 pg mL(-1). At concentrations of 1 ng mL(-1) of trace metals and REE spiked in coastal water the precision for 10 replicates was in the range of 0.3-3.4% (RSD). The accuracy of the method was demonstrated by analyzing two standard reference waters, SLRS-3 and CASS-3.     

Determination of anionic trace impurities in glycerol by capillary isotachophoresis with enlarged sample load

Glycerol of different quality classifications served as a model for a neutral excess component in the isotachophoretic determination of low-molecular-mass anionic trace impurities. Potential anionic contaminants such as nitrate, sulphate, chlorate, nitrite, oxalate, fluoride formate and phosphate were analysed up to an analyte-to-excess ratio of 1:4·10⁷, thus providing the possibility of checking the sample for the mentioned analytes in the order of 2.5·10⁻⁶–9.5·10⁻⁶%. Because we used a column-coupling isotachophoretic instrument the electrolyte system consisted of two different leading electrolytes, one for the pre-separation (10 mmol/l HCl, β-alanine, pH 3.2) in the first capillary and one for the final separation (5 mmol/l HCl, 1,3-bis[tris(hydroxymethyl)methylamino]propane, β-alanine, pH 3.6) in the second capillary. The terminating electrolyte was citric acid. Due to an increased injection volume of 300 μl, limits of detection (LODs) in the nanomolar range were realised by conductivity detection. The developed method allows simultaneous analysis without sample preparation and/or preconcentration within 25 min and is for that reason suitable for in-place process control.     

Use of non-segmented flow,post-columns reaction detection with miniaturized HPLC systems

Summary The use of non-segmented flow, post-column reaction detection is evaluated for use with miniaturized HPLC. Non-segmented open-tubular reactors with internal diameters 0.1 mm to 0.25 mm and packed-bed reactors with internal diameters of 1 mm, filled with 5 and 10 m particles are evaluated theoretically and experimentally with respect to band broadening and pressure drop characteristics. An integrated system consisting of miniaturized HPLC (1 mm i. d.) columns and compatible hardware is described. An example of the separation of catecholamines is given.     

Use of x-ray microtomography to visualise dynamic adsorption of organic vapour and water vapour on activated carbon

X-ray microtomography coupled with image analysis was used to quantify the adsorption of vapours on activated carbon beds. This technique was tested using three different challenges: CCl₄, water vapour and a mixture of water- and organic vapour. It is shown that the used technique allows determining the adsorption front progress in the case of organic vapour and mixture of water and organic vapour whereas the existence of this front was not so obvious in the case of water vapour. Experimental results obtained for organic vapours were interpreted on the basis of the Wheeler-Jonas equation: a good agreement was found between experimental and theoretical breakthrough times.     

Cascade alkenyl amination/Heck reaction promoted by a bifunctional palladium catalyst: a novel one-pot synthesis of indoles from o-haloanilines and alkenyl halides

A novel approach for the synthesis of the important indole ring is described. Indoles are obtained from o-bromoanilines and alkenyl halides in a Pd-catalyzed cascade process that involves an alkenyl amination followed by an intramolecular Heck reaction. The overall process represents the first example of the participation of alkenyl amination reactions in Pd-catalyzed cascade reactions. Initially, the relative reactivity of aryl and alkenyl bromides and chlorides towards Pd-catalyzed amination was investigated. Competition experiments were carried out in the presence of primary and secondary amines, and these revealed the reactivity order alkenyl bromides > aryl bromides > alkenyl chlorides > aryl chlorides, as well as very high chemoselectivity; the more reactive halide was always favored. Thereafter, optimized reaction conditions for the sequential alkenyl amination/Heck cyclization to give indoles were investigated with the model reaction of o-bromoaniline with alpha-bromostyrene. An extensive screening of ligands, bases, and reaction conditions revealed that the [Pd2(dba)3]/DavePhos, NaOtBu, toluene combination at 100 degrees C were the optimized reaction conditions to carry out the cascade process (dba=dibenzylideneacetone, DavePhos=2-dicyclohexylphosphino-2'-N,N-dimethylaminobiphenyl). The reaction proceeds with aryl, alkyl, and functionalized substitutents in both starting reactants. The cyclization was also studied with N-substituted o-bromoanilines (which would give rise to N-substituted indoles); however, in this case, indole formation occurred only with 1-substituted-2-bromoalkenes. Finally, the application of this methodology to o-chloroanilines required further optimization. Although the catalyst based on DavePhos failed to promote the cascade process, a catalytic combination based on [Pd2(dba)3]/X-Phos promoted the formation of the indole ring also from the less reactive chloroanilines.     

Study of Langmuir and Langmuir-Blodgett films of odorant-binding protein/amphiphile for odorant biosensors

To make ultrathin films for the fabrication of artificial olfactory systems, odorant biosensors, we have investigated mixed Langmuir and Langmuir-Blodgett films of odorant-binding protein/amphiphile. Under optimized experimental conditions (phosphate buffer solution, pH 7.5, OBP-1F concentration of 4 mg L(-1), target pressure 35 mN m(-1)), the mixed monolayer at the air/water interface is very stable and has been efficiently transferred onto gold supports, which were previously functionalized by self-assembled monolayers (SAMs) with 1-octadecanethiol (ODT). Atomic force microscopy and electrochemical impedance spectroscopy were used to characterize mixed Langmuir-Blodgett (LB) films before and after contact with a specific odorant molecule, isoamyl acetate. AFM phase images show a higher contrast after contact with the odorant molecule due to the new structure of the OBP-1F/ODA LB film. Non-Faradaic electrochemical spectroscopy (EIS) is used to quantify the effect of the odorant based on the electrical properties of the OBP-1F/ODA LB film, as its resistance strongly decreases from 1.18 MOmega (before contact) to 25 kOmega (after contact).     

Influence of the Excited States of Atomic Nitrogen N(<Superscript>2</Superscript>D) and N(<Superscript>2</Superscript>P) on the Transport Properties of Nitrogen. Part I: Atomic Nitrogen Properties

In this paper, calculated values of the viscosity and thermal conductivity of atomic nitrogen, taking into account three species (the ground and two excited states), are presented. The calculations, which assume that the temperature dependent probability of occupation of the states is given by the Boltzmann factor, are performed for atmospheric-pressure in the temperature range from 1,000 to 20,000 K. Six collision integrals are used in calculating the transport coefficients and we have introduced new averaged collision integrals where the weight associated at each interacting species pair is the probable collision frequency. The influence of the collision integral values and energy transfer between two different species is studied. These results are compared which those of published theoretical studies.     

Hydrogen–hydrogen bonding in biphenyl revisited

The evidence for the stabilizing nature of the H–H bonding in planar biphenyl is succinctly reviewed. The stabilizing nature of the H–H bonding is revealed through a comparison of the atomic energy of every atom in planar biphenyl with the same atom in the twisted equilibrium structure. It is shown that the barrier to rotation via the planar transition state is the net resultant of a stabilisation of the four ortho-hydrogen atoms (by 8 kcal/mol each), a stabilisation of the two para-carbon atoms (by 3 kcal/mol each) and by the dominant destabilisation of the two carbon atoms joining the two rings—the two junction carbon atoms—(by 22 kcal/mol each). The energetic stabilisation of the four ortho-hydrogen atoms is further shown to be in large proportion due to the formation of the hydrogen–hydrogen interatomic surface. Furthermore, neither the “bond order” between the two junction carbon atoms nor the total electron delocalisation between the two rings exhibit a significant change in going from the planar to the twisted equilibrium geometry. These findings are in contrast with the classical view of a balance between “steric non-bonded repulsion” and better electron delocalisation as a function of the twist dihedral angle. Similar conclusions have been recently reached by Pacios and Gómez through a study of the electrostatic potential at the position of the hydrogen nuclei. We dedicate this article to Professor TM Krygowski on the occasion of his 70th birthday wishing him a long and productive life.     

Use of a new type of 8-hydroxyquinoline-5-sulphonic acid cellulose (sulphoxine cellulose) for the preconcentration of trace metals from highly mineralised water prior their GFAAS determination

Sulphoxine cellulose microcolumn was used in an FI-GFAAS system for the preconcentration of trace metals, Cd, Co, Ni, Pb and V from water and from highly mineralised water and also in the presence of complexing agent, e.g. citrate. The recovery was quantitative at pH 5 for all of the elements from NIST 1643c trace elements in water SRM and from highly mineralised water samples. No significant difference was found in the sorption of V(IV) and V(V) during preconcentration. The preparation of the 8-hydroxyquinoline-5-sulphonic acid cellulose (sulphoxine-cellulose) by Mannich reaction from aminoethyl cellulose or via chlorodeoxy and ethylenediamine cellulose is also described.