Application of microwave digestion to the preparation of sediment samples for arsenic speciation

Several extraction procedures are described allowing arsenic speciation in sediments. The extraction of organometallic compounds such as dimethylarsinic acid or monomethylarsonic acid is quite simple since these compounds are stable in the different extraction media (HCl/ HNO₃, H₃PO₄, ammonium oxalate) and are easily released independent of the extraction mode (magnetic stirring or microwave solubilization). Extraction yields are higher than 96% for these two arsenic forms. An HCl/HNO₃ microwave solubilization procedure allows the quantitative solubilization of mineral arsenic, but the differentiation between the two oxidation states is not possible owing to the oxidation of As(III) to As(V). Extractions with orthophosphoric acid or ammonium oxalate allow the solubilization of mineral arsenic with extraction yields ranging from 90 to 95% and the differentiation between As(III) and As(V). Nevertheless, the amount of As(III) is underestimated owing to its partial oxidation. The usefulness and advantages of microwave solubilization compared with conventional extraction procedures are discussed. Received: 17 May 1996 / Revised: 19 September 1996 / Accepted: 25 September 1996     

On the ordering in [(C2H5)4N]2CuCl4 crystal: an X-ray study and theoretical considerations

The crystal structure [(C₂H₅)₄N]₂CuCl₄ has been determined by X-ray diffraction at 243K. The room temperature phase (phase I) belongs to the space group P4₂/nm [1] whereas the low temperature phase (phase II) is orthorhombic and belongs to the space group Pnna. The phase transition at T_c=258K is of improper ferroelastic type and it is associated with the ordering of the CuCl₄ ^2? and a partial ordering of the [(C₂H₅)₄N]⁺ ions which are disordered in the high temperature tetragonal phase. At lower temperature, there occurs another instability which could correspond to a complete ordering in the crystal.     

Corner spontaneous magnetization

Details are given of a new method allowing an exact calculation of the spontaneous magnetization in the corner as well as along the edge at an arbitrary distance of the corner for a rectangular planar Ising ferromagnet.     

Rotational temperature and density measurements in a hypersonic flow by dual-line CARS

Rotational temperature and nitrogen number density are measured in the shock wave/boundary layer interaction region in the vicinity of a two-dimensional compression corner disposed in a low pressure, 55 K, Mach 10 hypersonic air flow. Spatially-resolved data are recorded using a nonlinear optical technique named dual-line coherent anti-Stokes Raman scattering (DLCARS). Averaged temperature and density profiles are compared with those predicted by a Navier-Stokes solver. Good agreement is found.     

Cems characterization of SnO2 films obtained by sputtering and sol-gel route

Conversion electron Mössbauer spectroscopy (CEMS) has been used to study tin oxide films prepared by sol-gel dipping and sputtering. The spectra of films prepared by sol-gel route result close to that of crystalline SnO₂ after heat treatment at a temperature as low as 150°C. The Mössbauer parameters of as sputter deposited films indicate that the structure of the deposited stannic oxide has an amorphous character more pronounced for thinner samples. The structure becomes predominantly that of crystalline SnO₂ by heating at 550°C for 30 min provided the film thickness is higher than 10 nm.     

Riccati-based preconditioner for computing invariant subspaces of large matrices

Summary. This paper introduces and analyzes the convergence properties of a method that computes an approximation to the invariant subspace associated with a group of eigenvalues of a large not necessarily diagonalizable matrix. The method belongs to the family of projection type methods. At each step, it refines the approximate invariant subspace using a linearized Riccati's equation which turns out to be the block analogue of the correction used in the Jacobi-Davidson method. The analysis conducted in this paper shows that the method converges at a rate quasi-quadratic provided that the approximate invariant subspace is close to the exact one. The implementation of the method based on multigrid techniques is also discussed and numerical experiments are reported. Received June 15, 2000 / Revised version received January 22, 2001 / Published online October 17, 2001     

The Dedekind-MacNeille completion as a reflector

We introduce a special type of order-preserving maps between quasiordered sets, the so-called cut-stable maps. These form the largest morphism class such that the corresponding category of quasiordered sets contains the category of complete lattices and complete homomorphisms as a full reflective subcategory, the reflector being given by the Dedekind-MacNeille completion (alias normal completion or completion by cuts). Suitable restriction of the object class leads to the category of separated quasiordered sets and its full reflective subcategory of completely distributive lattices. Similar reflections are obtained for continuous lattices, algebraic lattices, etc.     

Existence globale pour l'équation de Smoluchowski continue non homogène et comportement asymptotique des solutions

We prove global existence of solutions to the continuous nonhomogeneous Smoluchowski equation for coagulation rates satisfying a more general structure condition than the Galkin–Tupchiev monotony hypothesis considered in (Ph. Laurençot, S. Mischler, Arch. Rational Mech. Anal. 162 (1) (2002) 45–99). The Smoluchowski coagulation rate fulfils this condition as well as some rates which vanish on the diagonal. Under the condition of positivity of the coagulation rate outside of the diagonal we prove that solutions tend to 0 in the large time asymptotic. These results depend on a new estimate from below for the dissipation rate of the L^p-norm, p>1. To cite this article: S. Mischler, M. Rodriguez Ricard, C. R. Acad. Sci. Paris, Ser. I 336 (2003).