强光电离团簇并行数值模拟

 为研究强激光电离氢原子团簇,在理论上采用1维氢原子团簇的经典粒子动力学模型,结合粒子对(PP)算法及粒子模拟（PIC）方法,采用自行搭建的9节点并行集群系统,利用消息传递接口（MPI)与OpenMP混合编程模型进行了并行数值模拟计算,获得了较为理想的计算加速比。并且引入了弛豫时间参数,有效地处理了粒子间的碰撞过程,在极大简化计算量的同时,保留了物理本质。所得模拟结果与已有的实验结果符合较好,表明该并行计算模型是稳定、可行的。     

Mn替代对Dy2AlFe16-xMnx化合物的结构和磁性的影响

通过X射线衍射及磁测量手段研究了Dy2AlFe16-xMnx化合物的结构和磁性.研究结果表明Dy2AlFe16-xMnx化合物具有六角相的Th2Ni17型结构.对x=1,2的样品采用X射线热膨胀测定法在104-647K的温度范围内测量了其热膨胀性质,发现这些化合物在低温下存在热膨胀反常现象,在居里点附近出现负膨胀性质.对自发磁致伸缩的研究结果表明Dy2AlFe16-xMnx化合物中存在着较强的各向异性的自发磁致伸缩,随着Mn含量的增加,其低温下的自发体磁致伸缩减弱.磁测量结果表明Mn的替代导致Dy2AlFe16-xMnx化合物的居里温度及自发磁化强度急剧下降.     

A Competitor-switched Electrochemical Sensor for Detection of DNA

A competitor‐switched electrochemical sensor based on a generic displacement strategy was designed for DNA detection. In this strategy, an unmodified single‐stranded DNA (cDNA) completely complementary to the target DNA served as the molecular recognition element, while a hairpin DNA (hDNA) labeled with a ferrocene (Fc) and a thiol group at its terminals served as both the competitor element and the probe. This electrochemical sensor was fabricated by self‐assembling a dsDNA onto a gold electrode surface. The dsDNA was pre‐formed through the hybridization of Fc‐labeled hDNA and cDNA with their part complementary sequences. Initially, the labeled ferrocene in the dsDNA was far from surface of the electrode, the electrochemical sensor exhibited a "switch‐off" mode due to unfavorable electron transfer of Fc label. However, in the presence of target DNA, cDNA was released from hDNA by target DNA, the hairpin‐open hDNA restored its original hairpin structure and the ferrocene approached onto the electrode surface, thus the electrochemical sensor exhibited a "switch‐on" mode accompanying with a change in the current response. The experimental results showed that as low as 4.4×10⁻¹⁰ mol/L target DNA could be distinguishingly detected, and this method had obvious advantages such as facile operation, low cost and reagentless procedure.     

Urothermal Synthesis,Crystal Structure,and Luminescent Property of a New Zn(Ⅱ) Coordination Polymer Constructed from TerephthalicAcid and 5-Methyl-1H-tetrazole Ligands

A new luminescent Zn(II) compound, [Zn(pbdc)0.5(mtz)(DMPU)]n(1, H2pbdc = terephthalic acid, Hmtz = 5-methyl-1H-tetrazole, DMPU = N,N'-dimethylpropyleneurea), has been urothermally synthesized and characterized by elemental analysis, IR, X-ray powder diffraction(PXRD) and single-crystal X-ray diffraction. The title compound crystallizes in orthorhombic Pbca space group with a = 17.2649(5), b = 10.4680(3), c = 17.4457(7) ?, V = 3152.94(18) ?3, C12H17N6O3Zn, Mr = 358.71, Z = 8, Dc = 1.511 g/cm3, F(000) = 1480, μ = 1.579 mm-1, the final R = 0.0379 and wR = 0.0971 for 2785 observed reflections(I 2?(I)). Single-crystal X-ray structural analysis reveals that compound 1 features a 2D undulated layer with a 3-connected hcb topology. Moreover, the luminescent properties of 1 have also been investigated in the solid-state at room temperature.     

低功率超声增强碘帕醇氯氧化的效果和路径

研究了低功率超声(US, <38 W)对NaClO氧化非离子型碘代X射线造影剂—碘帕醇(IPM)的增强作用及机理, 考察了NaClO添加浓度和超声功率的影响, 分析并计算了体系中的主要活性物种及其贡献. 采用高效液相色谱/串联质谱(HPLC/MS/MS)对降解产物进行分析, 推测IPM的降解路径. 结果表明, 低功率US显著增强了NaClO对IPM的氧化效果, 在25 ℃, pH=5.8, NaClO浓度为0.12 mmol/L条件下, 10 mg/L IPM在60 min的降解率达到85.8%. 其中NaClO氧化、 HO·和活性氯自由基(RCSs)是US/NaClO增强IPM降解的主要原因, 自由基分析计算它们的贡献率分别为15.82%, 4.65%和79.53%. NaClO浓度在0~0.24 mmol/L范围内, IPM的降解率随NaClO浓度升高而增加, 60 min后降解率由4.75%增加到91.12%; 超声功率为28.5 W, 降解率达到最高. 在 15~45 ℃温度范围内, IPM的降解过程符合表观一级反应动力学, 反应活化能(E_a)为59.03 kJ/mol. HPLC/MS/MS共检测出5种中间产物, 结合密度泛函理论(DFT)计算结果, 初步推测了IPM在US/NaClO体系中的降解途径和机理.     

中空介孔二氧化硅锚固聚偕胺肟吸附Cr(Ⅵ)

以硝酸铈铵为引发剂, 在自制的中空介孔二氧化硅(HMS)的空腔和通道内引发丙烯腈自由基聚合, 并将其氰基偕胺肟化, 用于制备具有吸附Cr(Ⅵ)的廉价有机无机复合吸附材料—中空介孔二氧化硅锚固聚偕胺肟. 通过傅里叶变换红外光谱(FTIR)、 扫描电子显微镜(SEM)及N₂吸附-脱附比表面分析对中空介孔二氧化硅锚固聚偕胺肟进行表征. 结果表明, 制备的中空微球直径约为400 nm, 其壁上孔径约为11.0 nm, 比表面积约为431 m²/g, 锚固聚偕胺肟后中空微球壁上孔道直径约为4.6 nm, 比表面积降低为347 m²/g. HMS锚固的聚偕胺肟对重铬酸钾溶液中铬的吸附量高达0.46 mmol/g, 吸附过程中伴随化学反应, 符合伪二级动力学模型, 可用作废水处理中重金属离子的高效廉价吸附材料.     

ICP-MS同时测定水产品中的铅、镉、汞和砷

以电感耦合等离子体-质谱法同时测定国家标准物质扇贝中4种元素,研究了此法测定水产品铅、镉、汞和砷,4种元素的校准曲线、检出限、精密度和准确度.ICP-MS测定4种元素均在扇贝样品标准值的允许误差范围之内,铅、镉、汞、砷检出限分别为0.06、0.01、0.26、0.20μg/kg.精密度都在10％以下,符合方法确认要求.     

[ONSO]型Salen化合物的合成、单晶结构及金属离子识别

一些重金属离子即使在较低浓度时也会对环境、生物体产生毒性,所以研究痕量金属离子识别具有重大意义。荧光传感器由于具有选择性好、灵敏度高、成本低、实时响应等优点, 得到了广泛关注。以2,4-二叔丁基苯酚,3,5-二叔丁基水杨醛和邻氨基苯硫酚为原料合成了类Salen配体L1, 并用1H NMR,13C NMR,IR,元素分析及X射线单晶衍射等手段对其进行了表征。并通过自由挥发法得到了配体L1的单晶结构,实验表明L1是三斜晶、P-1空间群的一个空穴平面[ONSO]四配位环境。通过荧光光谱考察了类Salen配体与金属离子(Li+,Na+,K+,Cd2+,Cs+,Co2+,Cu2+,Hg2+,Mn2+,Ni2+,Zn2+,Ag+)的识别与配位性能。光谱滴定分析表明L1与Zn2+以1∶1的化学计量数配位。另外,L1与Zn2+结合后荧光显著增强,荧光检测限达到5.01×10-5 mol·L-1,而上述提到的其他常见金属离子不引起荧光光谱变化。结果表明L1是一个对检测Zn2+的选择性高,灵敏度强的荧光增强型探针。     

Synthesis and Crystal Structure of a Co（II） Coordination Polymer Derived from a Flexible Bipyridyl Derivative Ligand

1 INTRODUCTION The infinite networks constructed from transition metal complexes have attracted considerable current interest in recent years. The motivation behind this activity has been stimulated by their potential appli- cations in selective inclusion of ions, molecular re- cognition, host-guest chemistry, ion exchange, cata- lysis, electrical conductivity, magnetism, optics and so on[1～4]. It is well known that the diversity in structures and topologies of supramolecules is attri- b…     

Synthesis of Polyethylene Containing Allene Groups: A Simple and Efficient Route to Functional Polyethylene

Allene groups are first employed as the reactive moiety in the simple and efficient synthesis of well‐defined functional polyethylene. By copolymerization of ethylene with allene group substituted norbornene, the allene group is successfully introduced into the polyethylene with a high content. The retained allene groups are demonstrated to be highly reactive in following photoinduced functionalized reactions and can be efficiently converted into the functional groups without the multi‐step, time consuming processes that have generally been required in previous reports, providing the side group‐functionalized polyethylene with a wide range of functional group content.