Electrocatalysis of oxygen reduction reaction on Nafion/platinum/gas diffusion layer electrode for PEM fuel cell

In this work a new membrane electrode based on Pt-coated Nafion membrane was fabricated. Chemical deposition process was used to coat platinum on Nafion 117 membrane and then Pt-coated Nafion membrane was hot pressed on gas diffusion layer (GDL) to make new membrane electrode. The electrochemical and chemical studies of the Pt-coated Nafions were investigated by electrochemical techniques, X-ray diffraction and scanning electron microscopy. The electrochemical results indicated that as the concentration of H₂PtCl₆ increased, the oxygen reduction reaction rate increased until the concentration was reached where the reduction reaction was limited by the problem of mass transport. The electrochemical results for oxygen reduction reaction showed that the new electrode which prepared by plating Nafion membrane with 0.06 M H₂PtCl₆ in electroless plating solution, has a higher performance than other electrodes. The XRD results showed that the average platinum particle size of the best sample was about 3 nm. The loading of platinum for this electrode was 0.153 mg cm⁻².     

Investigating the effect of operating parameters on the open circuit voltage of a passive DMFC

The variations of the open circuit voltages (OCVs) were studied in a passive air-breathing direct methanol fuel cell with an air-breathing cathode using Nafion 115 as the electrolyte membrane. The effects of some operating parameters such as cell temperature, cell orientation, and also methanol concentration on the OCV of fabricated fuel cell were investigated experimentally. The experimental results showed that the OCV values depend strongly on the cell orientation, cell temperature, and methanol concentration. The OCV values decrease with an increase in methanol concentration and cell temperature. Also, the OCV values in vertical orientation are lower than the OCV values in other orientations.     

Substituent effects in cooperativity of chalcogen bonds

In the present work, substituent effects on cooperativity of S···N chalcogen bonds are studied in XHS···NCHS···4-Z–Py (X = F, Cl; Z = H, F, OH, CH₃, NH₂, NO₂, and CN; and Py = pyridine) complexes using ab initio calculations. An increased attraction or a positive cooperativity is observed on introduction of a third molecule to the XHS···NCHS and NCHS···4-Z–Py binary systems. The shortening of each chalcogen bond distance in the ternary systems is dependent on the substituent Z and is increased in the order Z = NH₂ > OH > CH₃ > H > F > CN > NO₂. The electronic aspects of the complexes are analysed using molecular electrostatic potential, and the parameters derived from the atoms in molecules and natural bond orbital methodologies. According to interaction energy decomposition analysis, the electrostatic energies are important in the interaction energy of S···N bonds and may be regarded as being responsible for the stability of these complexes.     

The influence of hydrogen- and lithium-bonding on the cooperativity of chalcogen bonds: A comparative ab initio study

ABSTRACT

The aim of this study is to investigate the influence of a hydrogen- or lithium-bonding interaction on the cooperativity of chalcogen bonds in linear NCH···(OCX)_2–5 and NCLi···(OCX)_2-5 clusters (X?=?S, Se). The nature of interactions in the optimised structures is analysed by means of molecular electrostatic potential, quantum theory of atoms in molecules, natural bond orbital and electron density difference methods. According to our results, the formation of a lithium-bonding interaction in NCLi···(OCX)_2-5 clusters induces a large increase in the strength of X···O chalcogen bonds, and hence their cooperativity. This can be mainly rationalised in terms of the electrostatic nature of chalcogen bonds as well as the fundamental orbital interaction between the interacting OCX subunits. The results of this study provide a theoretical evidence for the tuning of chalcogen bonds cooperativity by a hydrogen- or lithium-bonding.     

Influence of Compatibilizer-Type and Processing Approach on the Dispersion of OMMT in High-Density Polyethylene Matrix

High-density polyethylene/organoclay nanocomposites were prepared via melt intercalation in an internal mixer using both a direct mixing and master batching method. Two types of maleic anhydride grafted polyethylene, high-density polyethylene grafted maleic anhydride, and linear low-density polyethylene grafted maleic anhydride, (HDPE-g-MA, LLDPE-g-MA) were used as compatibilizers to enhance the dispersibility of nanoclay in HDPE. Dispersion of organoclay in the nanocomposites was characterized by using X-ray diffraction (XRD), transmission electron microscopy (TEM), and rheological mechanical spectroscopy (RMS). Effects of clay content and degree of clay dispersion on the rheological and tensile properties were also investigated. Furthermore, the effect of order of mixing on the dispersion and distribution of the clay layers was studied. The obtained results showed that organoclay in the nanocomposites were dispersed homogeneously and exfoliated better when HDPE-g-MA and the direct mixing route were used. Although in the master batching method clay intercalated better, clay layers chiefly remain in compatibilizer rich areas. On the other hand, direct mixing was observed to lead to clay particles being dispersed in the HDPE matrix or at the interface of the matrix and compatibilizer and, consequently, better improvement in the tensile modulus was achieved. It was determined that the compatibilizer with the higher miscibility with the matrix was the key factor for achieving better exfoliation of clay sheets.     

Localization of elastic waves in heterogeneous media with off-diagonal disorder and long-range correlations

Using the Martin-Siggia-Rose method, we study propagation of acoustic waves in strongly heterogeneous media which are characterized by a broad distribution of the elastic constants. Gaussian-white distributed elastic constants, as well as those with long-range correlations with nondecaying power-law correlation functions, are considered. The study is motivated in part by a recent discovery that the elastic moduli of rock at large length scales may be characterized by long-range power-law correlation functions. Depending on the disorder, the renormalization group (RG) flows exhibit a transition to localized regime in any dimension. We have numerically checked the RG results using the transfer-matrix method and direct numerical simulations for one- and two-dimensional systems, respectively.     

Pyrophosphate Selective Recognition in Aqueous Solution Based on Fluorescence Enhancement of a New Aluminium Complex

A novel and simple fluorescence enhancement method for selective pyrophosphate(PPi) sensing was proposed based on a 1:1 metal complex formation between bis(8-hydroxy quinoline-5-solphonat) chloride aluminum(III) (Al(QS)₂Cl), (L) and PPi in aqueous solution. The linear response range covers a concentration range of 1.6 × 10⁻⁷ to 1.0 × 10⁻⁵ mol/L of PPi and the detection limit of 2.3 × 10⁻⁸ mol/L. The association constant of L-PPi complex was calculated 2.6 × 10⁵ L/mol. L was found to show selectively and sensitively fluorescence enhancement toward PPi over than I₃^-, NO₃^-, CN⁻, CO₃²⁻, Br⁻, Cl⁻, F⁻, H₂PO4⁻ and SO₄²⁻, which was attributed to higher stability of inorganic complex between pyrophosphate and L.     

Precision of degree of polarization estimation in the presence of additive Gaussian detector noise

We address the problem of degree of polarization (DOP) estimation in images limited by additive Gaussian detector noise. We derive and analyze the probability density function (PDF) of the pixelwise DOP estimate, which is shown to have significantly different statistical properties than when noise is Gamma distributed (speckle). We then determine the Cramer-Rao Lower Bound and the maximum likelihood estimator of the DOP. We deduce from this study practical solutions for characterizing and reducing the noise in these images.     

Dual-frequency single-axis laser using a lead lanthanum zirconate tantalate (PLZT) birefringent etalon for millimeter wave generation: beyond the standard limit of tunability

We demonstrate the generation of optically carried, broadly tunable, millimeter-wave signals with a dual-frequency single-axis Nd:YAG laser. A frequency difference as high as 127 GHz is reached thanks to an intracavity electro-optically tunable etalon made of lead zirconate tantalate (PLZT) ceramic. We show that the available frequency range is actually limited by the bandwidth of the amplification medium, namely, far beyond the usually accepted free spectral range value in the case of a single-axis laser. Both coarse discrete and fine continuous tunabilities are obtained with the same voltage-controlled device, opening the way to widely tunable low-phase-noise optically carried submillimeter or even terahertz sources.