On a Formula for the L2 Wasserstein Metric between Measures on Euclidean and Hilbert Spaces

For a separable metric space (X, d) L^p Wasserstein metrics between probability measures μ and v on X are defined by where the infimum is taken over all probability measures η on X × X with marginal distributions μ and v, respectively. After mentioning some basic properties of these metrics as well as explicit formulae for X = R a formula for the L² Wasserstein metric with X = Rⁿ will be cited from [5], [9], and [21] and proved for any two probability measures of a family of elliptically contoured distributions. Finally this result will be generalized for Gaussian measures to the case of a separable Hilbert space.     

Two-dimensional visualization of the flame front in an internal combustion engine by laser-induced fluorescence of OH radicals

Two-dimensional laser-induced fluorescence (2D-LIF) imaging of OH radicals, excited at 308 nm, has been employed to visualize the flame front in an internal combustion engine burning air/propane mixtures. Light sheet thicknesses down to 70 m have been attained for excitation. Hydroxyl radicals were detected up to pressures of 7.5 bar at engine speeds of 500 rpm. An upper limit of 300 m for the flame front thickness was obtained from line intensity profiles.     

Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

Mixtures of charged colloid and neutral polymer: influence of electrostatic interactions on demixing and interfacial tension

The equilibrium phase behavior of a binary mixture of charged colloids and neutral, nonadsorbing polymers is studied within free-volume theory. A model mixture of charged hard-sphere macroions and ideal, coarse-grained, effective-sphere polymers is mapped first onto a binary hard-sphere mixture with nonadditive diameters and then onto an effective Asakura-Oosawa model [S. Asakura and F. Oosawa, J. Chem. Phys. 22, 1255 (1954)]. The effective model is defined by a single dimensionless parameter-the ratio of the polymer diameter to the effective colloid diameter. For high salt-to-counterion concentration ratios, a free-volume approximation for the free energy is used to compute the fluid phase diagram, which describes demixing into colloid-rich (liquid) and colloid-poor (vapor) phases. Increasing the range of electrostatic interactions shifts the demixing binodal toward higher polymer concentration, stabilizing the mixture. The enhanced stability is attributed to a weakening of polymer depletion-induced attraction between electrostatically repelling macroions. Comparison with predictions of density-functional theory reveals a corresponding increase in the liquid-vapor interfacial tension. The predicted trends in phase stability are consistent with observed behavior of protein-polysaccharide mixtures in food colloids.