Investigating generation mechanisms of tyre/road noise by speed exponent analysis

The purpose of this study is to clarify the influence of air-pumping related noise sources on typical tyre/road noise. The aim is to increase the understanding of noise generation mechanisms and catalyse the development of existing tyre/road noise simulation tools. The speed dependency of measured and simulated tyre/road noise is analysed and the results show that a large part of the noise can be explained by a high speed exponent traditionally connected with air-pumping mechanisms. Surprisingly, this is also the case for rough road surfaces which are expected to mainly generate noise by tyre vibrations. It is also found that vehicle wind noise may have a strong influence on the pass-by noise and care must be taken when analysing measurement data of quiet tyre/road combinations. Even simulated tyre/road noise shows higher speed exponents than what is anticipated without the inclusion of any type of air-pumping mechanism in the model. It is concluded that it is unfeasible to separate noise created by tyre vibrations from noise created by air-pumping with a speed exponent analysis due to the overlap in the speed exponents connected with the different generation mechanisms.     

XANES speciation of mercury in three mining districts – Almadén,Asturias (Spain), Idria (Slovenia)

The mobility, bioavailability and toxicity of mercury in the environment strongly depend on the chemical species in which it is present in soil, sediments, water or air. In mining districts, differences in mobility and bioavailability of mercury mainly arise from the different type of mineralization and ore processing. In this work, synchrotron‐based X‐ray absorption near‐edge spectroscopy (XANES) has been taken advantage of to study the speciation of mercury in geological samples from three of the largest European mercury mining districts: Almadén (Spain), Idria (Slovenia) and Asturias (Spain). XANES has been complemented with a single extraction protocol for the determination of Hg mobility. Ore, calcines, dump material, soil, sediment and suspended particles from the three sites have been considered in the study. In the three sites, rather insoluble sulfide compounds (cinnabar and metacinnabar) were found to predominate. Minor amounts of more soluble mercury compounds (chlorides and sulfates) were also identified in some samples. Single extraction procedures have put forward a strong dependence of the mobility with the concentration of chlorides and sulfates. Differences in efficiency of roasting furnaces from the three sites have been found.     

Spin Label Studies of the Hemoglobin–Membrane Interaction During Sickle Hemoglobin Polymerization

An enhanced hemoglobin–membrane association has been previously documented in sickle cell anemia. However, it is not known how this interaction is modified during the hemoglobin S polymerization process. In this work, we use a model of reconstituted erythrocytes from ghost membranes whose cytoskeleton proteins had been previously labeled with the 4-maleimido Tempo spin label, and that were subsequently resealed with hemoglobin S or A solutions. Using electron paramagnetic resonance spectroscopy, we studied the time dependence of the spectral W/S parameter, indicative of the conformational state of cytoskeleton proteins (mainly spectrin) under spontaneous deoxygenation, with the aim of detecting the eventual effects due to hemoglobin S polymerization. The differences observed in the temporal behavior of W/S in erythrocytes reconstituted with both hemoglobins were considered as experimental evidence of an increment in hemoglobin S–membrane interaction as a result of the polymerization process of hemoglobin S under spontaneous deoxygenation.     

Strain-driven morphology of Si1-xGex islands grown on Si(100)

A study has been carried out on the morphology and structure of three-dimensional (3D) SiGe islands grown by molecular beam epitaxy (MBE) on Si(100) substrates. Samples of Si1-xGex alloys have been prepared to investigate the effects either of the alloy composition or of the growth temperature. Atomic force microscopy (AFM) evidenced the growth of 3D islands and transmission electron microscopy (TEM) demonstrated wetting layer growth on Si(100), independently on the deposition conditions. Energy dispersive spectroscopy (EDS) micro-analyses carried out on cross-sections of large Si1-xGex islands with defects allowed a measurement of the Ge distribution in the islands. To the best of our knowledge, these have been the first experimental evidences of a composition change inside SiGe islands. The interpretation of the experimental results has been done in terms of strain-enhanced diffusion mechanisms both of the growing species (Si and Ge) and of small islands.     

Nanoparticle electrostatic loss within corona needle charger during particle-charging process

A numerical investigation has been carried out to examine the electrostatic loss of nanoparticles in a corona needle charger. Two-dimensional flow field, electric field, particle charge, and particle trajectory were simulated to obtain the electrostatic deposition loss at different conditions. Simulation of particle trajectories shows that the number of charges per particle during the charging process depends on the particle diameter, radial position from the symmetry axis, applied voltage, Reynolds number, and axial distance along the charger. The numerical results of nanoparticle electrostatic loss agreed fairly well with available experimental data. The results reveal that the electrostatic loss of nanoparticles increases with increasing applied voltage and electrical mobility of particles; and with decreasing particle diameter and Reynolds number. A regression equation closely fitted the obtained numerical results for different conditions. The equation is useful for directly calculating the electrostatic loss of nanoparticles in the corona needle charger during particle-charging process.     

Modelling of optical absorption of silver NP’s produced by UV radiation embedded in mesostructured silica films

Hexagonal mesostructured films containing silver ions were obtained by sol–gel method. Brij 58 was used to produce channels into the film, which house these ions. The films were exposure to UV radiation to produced silver metallic nanoparticles. The presence of the metallic nanoparticles was determined by infrared spectroscopy and optical absorption. Besides, these nanoparticles and core–shell structures of silver–silver oxide nanoparticles were identified by high-resolution transmission electronic microscopy. From these measurements, the obtained size range for silver nanoparticles was 6.1 nm. The absorption spectrum located at 440 nm was modelled and well fitted with the Gans theory considering refractive index higher than the one coming from host matrix. This index is explained because the silver oxide shell modifies the local surrounding medium of the metallic nanoparticles.     

Evolution of first-order sidebands from multiple FWM processes in HiBi optical fibers

The generation of two idler waves inside a high birefringent (HiBi) optical fiber through three four-wave mixing (FWM) processes is studied theoretically. The coupled-equations for the field amplitudes are derived and analytically solved, in the co-polarized and orthogonal polarization schemes. The obtained solutions take into account the delayed Raman response of the medium. The polarization sensitivity of the generation of the idler waves is analyzed. Results show that the stimulated Raman scattering does not change the efficiency of the idler wave generation in the co-polarized scheme, whereas in the orthogonal polarization scheme that nonlinear process decreases the efficiency of the four-wave mixing processes. Results also show that this set of multiple four-wave mixing processes is physically quite different from the typical single or dual pump four-wave mixing configurations. Findings show that the power transfer from the pumps to the idler fields can lead to a monotonous growth, or a periodic evolution of the sidebands along the fiber. Results show that the process efficiency varies greatly with the angle between the two pump polarizations.     

The need to measure low-energy antineutrinos (<Emphasis Type="Italic">E</Emphasis><Subscript><Emphasis Type="Italic">⊻</Emphasis></Subscript><0.782 MeV) from the Sun

Measurements are needed of low-energy antineutrinos generated by possible neutron decay at the core of the Sun. The measurement will test the validity of a proposal that solar luminosity, solar neutrinos, and the outpouring of H⁺ ions from the solar surface are the products of a chain of reactions triggered by neutron emission from the solar core. Inverse β decay of 87-d ³⁵S, induced by capture of low-energy antineutrinos on ³⁵Cl, is a likely candidate for this measurement.     

Experimental investigation of superconductivity in 2H-NbSe2 single crystal

The basic quantities characterizing the superconducting behaviour of pure 2H-NbSe₂ single crystals have been determined from specific heat measurements, performed between 0.3 and 10 K in magnetic fields up to 55 KG. When Ti impurities are added, changes are observed both in the superconducting parameters and in the onset of charge density waves, strengthening the idea that a connection exists between the two phenomena.     

A contribution to the global formulation of the higher-order Poincaré-Cartan form

The global formulation of the higher-order Poincaré-Cartan form for Lagrangian field theories in the calculus of variations is re-examined in terms of the theory of lifts of tensor fields on a manifold to its higher-order prolongated jet bundles.Partially supported by CNPq, Brazil, Proc. MA 30.1115/79.