Rainfalls during great Forbush decreases

Summary The changes of rainfall values during great Forbush decreases recorded by the low-latitudinal neutron monitor of Huancayo (47 events from 1956 through 1992) were examined. The data on precipitations were taken from the State of S?o Paulo and from the Amazonian region, Brazil. As a rule, the data from more than 50 meteorological stations were used for each events. The main result is the following: during strong decreases of cosmic-ray flux in the atmosphere (great Forbush decreases) the precipitation value is decreased. The effect of rainfall changes is seen more distinctly if wet seasons are considered.     

Application of a Heuristic Scheduling Rule for a Tyre Testing Department

This paper presents the development and application of a heuristic scheduling rule for the Testing Department of a tyre and rubber company. The company had set down five major objectives for this department: (1) minimize average flow-time; (2) maintain an average flow-time of less than two weeks; (3) maintain pre-set maximum individual test flow times; (4) assign a higher priority to important jobs; (5) maintain a balanced mix between truck and passenger tyres. A composite scheduling rule was designed to meet these objectives which contains the following four components: (a) slack-time per remaining operation; (b) shortest processing time; (c) an urgency factor to prioritize important jobs; (d) a balancing factor to enable a desired proportion between truck and passenger tyres. This composite rule is tested against the existing scheduling scheme used by the foreman and against the simple S.P.T. rule. The results are very encouraging.     

Use of capillary electrophoresis for characterisation of vinyl‐terminated Au nanoprisms and nanooctahedra

It is described a simple, rapid and efficient methodology to characterise and separate gold nanoprisms and nanooctahedra by capillary electrophoresis. This technique is suitable to distinguish between morphologies and it can be used as a powerful separation tool after a customised synthesis of both structures. This synthesis was carried out by amending two parameters, temperature and pH, and a sharp decrease was found in nanotriangles when temperature was increased from 70 up to 95°C. However, when the synthesis was performed at a given temperature, an increase in pH did not promote an important change in isolation of any structure until pH = 9.5, critical in the final morphology of the nanoparticle. Gold nanoprisms and nanooctahedra were successfully separated by capillary electrophoresis according to differences in charge‐to‐mass ratio of the morphologies. Final particle morphology was confirmed by transmission electron microscopy analysis. Under optimal working conditions, a mixture containing both shapes of gold nanoparticles was initially injected and two major peaks were obtained for each structure. Capillary electrophoresis allowed to study pH and temperature influence on both morphologies. It was inferred that the ratio between triangles and octahedra decreased to a great extent when increasing both temperature and pH.     

Thermal degradation mechanism for citalopram and escitalopram

Journal of Thermal Analysis and Calorimetry - Citalopram, [(R,S)-1-[3-(dimethylamino)propyl]-1-(4-fluorophenyl)-1,3-dihydroisobenzofuran-5-carbonitrile] hydrobromide and its S-isomer, escitalopram...     

Recent Progress on Manganese-Based Nanostructures as Responsive MRI Contrast Agents

Manganese-based nanostructured contrast agents (CAs) entered the field of medical diagnosis through magnetic resonance imaging (MRI) some years ago. Although some of these Mn-based CAs behave as classic T₁ contrast enhancers in the same way as clinical Gd-based molecules do, a new type of Mn nanomaterials have been developed to improve MRI sensitivity and potentially gather new functional information from tissues by using traditional T₁ contrast enhanced MRI. These nanomaterials have been designed to respond to biological environments, mainly to pH and redox potential variations. In many cases, the differences in signal generation in these responsive Mn-based nanostructures come from intrinsic changes in the magnetic properties of Mn cations depending on their oxidation state. In other cases, no changes in the nature of Mn take place, but rather the nanomaterial as a whole responds to the change in the environment through different mechanisms, including changes in integrity and hydration state. This review focusses on the chemistry and MR performance of these responsive Mn-based nanomaterials.     

Consecutive Supramolecular Polymerization of a Rylene-Based Twistacene

The synthesis and self-assembling features of twistacene 1 are reported. The supramolecular polymerization of 1 displays a consecutive pathway to afford slipped ( AggI ) and rotationally displaced ( AggII ) aggregates conditioned by the formation of intramolecularly H-bonded pseudocycles. In methylcyclohexane, both AggI and AggII are highly stable and the interconversion of the kinetically controlled AggI into the thermodynamically controlled AggII takes several weeks to occur. The utilization of toluene as solvent changes the energetic level for both aggregates and favors a faster conversion of AggI into AggII within a period of minutes. This conversion can be accelerated by the addition of seeds. Furthermore, concentration dependent kinetic studies demonstrate the consecutive character of the supramolecular polymerization of 1 .     

A quantitative thermal analysis of cyclists’ thermo-active base layers

It is well known that clothes used in sporting activity are a barrier for heat exchange between the environment and athlete, which should help in thermoregulation improvement. However, it is difficult to evaluate which top is best for each athlete according to the characteristics of the sport. Researchers have tried to measure the athlete’s temperature distribution during exercise at the base layers of tops with different approaches. The aim of this case study was to investigate the use of thermography for thermo-active base layer evaluation. Six new base layers were measured on one cyclist volunteer during a progressive training on a cycloergometer. As a control condition, the skin temperature of the same volunteer was registered without any layer with the same training. A training protocol was selected approximate to cycling race, which started from the warm-up stage, next the progressive effort until the race finished and at the end “cool-down” stage was over. In order to show which layer provided the strongest and weakest barrier for heat exchange in comparison with environment, the temperature parameters were taken into consideration. The most important parameter in the studies was the temperature difference between the body and the layers, which was changing during the test time. The studies showed a correlation between the ergometer power parameter and the body temperature changes, which has a strong and significant value. Moreover, the mass of every layer was checked before and after the training to evaluate the mass of the sweat exuded during the test. From this data, the layer mass difference parameter was calculated and taken into consideration as a parameter, which may correspond with the mean heart rate value from each training. A high and positive correlation coefficient was obtained between the average heart rate and the mass difference for the base layers. Thermal analysis seems to have a new potential application in the objective assessment of sports clothing and may help in choosing the proper clothes, which could support heat transfer during exercising and protect the body from overheating.

     

Introducing the Petasis Reaction for Late‐Stage Multicomponent Diversification,Labeling, and Stapling of Peptides

For the first time, the Petasis (borono‐Mannich) reaction is employed for the multicomponent labeling and stapling of peptides. The report includes the solid‐phase derivatization of peptides at the N‐terminus, Lys, and N^?‐MeLys side‐chains by an on‐resin Petasis reaction with variation of the carbonyl and boronic acid components. Peptides were simultaneously functionalized with aryl/vinyl substituents bearing fluorescent/affinity tags and oxo components such as dihydroxyacetone, glyceraldehyde, glyoxylic acid, and aldoses, thus encompassing a powerful complexity‐generating approach without changing the charge of the peptides. The multicomponent stapling was conducted in solution by linking N^?‐MeLys or Orn side‐chains, positioned at i, i+7 and i, i+4, with aryl tethers, while hydroxy carbonyl moieties were introduced as exocyclic fragments. The good efficiency and diversity oriented character of these methods show prospects for peptide drug discovery and chemical biology.     

Nanocomposites based on cationic polyelectrolytes and silver nanoparticles: Synthesis,characterization, molybdate retention and antimicrobial activity

The objective of this work was to synthesize nanocomposites based on cationic polyelectrolytes and silver nanoparticles using poly(N-vinylbenzyl-N-triethylammonium chloride) as polymer phase. For that, a nanostructured crosslinker was synthesized from silver nanoparticles (AgNPs) and acrylic acid. Molybdate retention properties of nanocomposites were studied in function of pH and ionic strength. In addition, their antimicrobial properties were evaluated against E. coli and S. aureus. It was evidenced that AgNPs can be stabilized using acrylic acid and that this material can be incorporated to the polymer phase during polymerization by free radical of cationic monomers. The effect of pH on retention of molybdate, by the nanostructured polymer, was significant only to low ionic strength (the order seen was pH 5.0 > pH 7.0 > pH 9.0 for 0.0% NaCl). Results suggest that the main interaction influencing the molybdate retention is electrostatic in nature. Finally, antimicrobial activity was enhanced by incorporation of polymerizable nanostructured crosslinker based on AgNPs.