Echolocation click sounds from wild inshore finless porpoise (Neophocaena phocaenoides sunameri) with comparisons to the sonar of riverine N. p. asiaeorientalis

Acoustic signals from wild Neophocaena phocaenoides sunameri were recorded in the waters off Liao-dong-wan Bay located in Bohai Sea, China. Signal analysis shows that N. p. sunameri produced "typical" phocoenid clicks. The peak frequencies f(p) of clicks ranged from 113 to 131 kHz with an average of 121+/-3.78 kHz (n=71). The 3 dB bandwidths delta f ranged from 10.9 to 25.0 kHz with an average of 17.5+/-3.30 kHz. The signal durations delta t ranged from 56 to 109 micros with an average 80+/-11.49 micros. The number of cycles N(c) ranged from 7 to 13 with an average of 9+/-1.48. With increasing peak frequency there was a faint tendency of decrease in bandwidth, which implies a nonconstant value of f(p)/delta f. On occasion there were some click trains with faint click energy presenting below 70 kHz, however, it was possibly introduced by interference effect from multiple pulses structures. The acoustic parameters of the clicks were compared between the investigated population and a riverine population of finless porpoise.     

Inversionless gain enhancing due to Doppler broadening in a closed lambda-type system

An analysis is made of the effect of Doppler broadening on gain without inversion (GWI) from different aspects in a closed lambda-type three-level system with an incoherent pump. It is shown that, regardless of the driving field being on resonance or not, for the counter- or co-propagating of the probe and driving fields (PDF), GWI does not monotonically decrease or increase with increasing Doppler width. Except for the case of counter-propagating PDF with off-resonance driving field, at a suitable Doppler width one can obtain a gain maximum value much larger than that without Doppler broadening; especially in the situation of the resonant driving field, the co-propagating geometry leads to a larger GWI. In addition, for the counter-propagating geometry, when Doppler width is larger enough, GWI oscillation occurs, and the oscillation amplitude and region increase with increasing Doppler width. These conclusions are very different from that obtained in previous investigation (Lukin {\it et al}, {\it Laser Phys.} {\bf 6} 436 (1996)).     

Nano liquid-metal fluid as ultimate coolant

We proposed for the first time the concept of the nano liquid-metal fluid, aiming to establish an engineering route to make the highest conductive coolant. Using several widely accepted theoretical models for characterizing the nano fluid, the thermal conductivity enhancement of the liquid-metal fluid due to addition of more conductive nano particles was predicted. Further, the effects of particle size, cluster of nano particle, solid-like layer due to adsorption, volume fraction and particle types were evaluated. Having the highest conductivity, being electromagnetically drivable, the liquid metal with low melting point is expected to be an idealistic base fluid for making super conductive solution which may lead to the ultimate coolant in a wide variety of heat transfer enhancement area.     

Improving nucleation in the fabrication of high-quality 3D macro-porous copper film through the surface-modification of a polystyrene colloid-assembled template

A new approach is developed to the fabrication of high-quality three-dimensional macro-porous copper films. A highly-ordered macroporous copper film is successfully produced on a polystyrene sphere (PS) template that has been modified by sodium dodecyl sulfate (SDS). It is shown that this procedure can change a hydrophobic surface of PS template into a hydrophilic surface. The present study is devoted to the influence of the electrolyte solution transport on the nucleation process. It is demonstrated that the permeability of the electrolyte solution in the nanochannels of the PS template plays an important role in the chemical electrodeposition of high-quality macroporous copper film. The permeability is drastically enhanced in our experiment through the surface modification of the PS templates. The method could be used to homogeneously produce a large number of nucleations on a substrate, which is a key factor for the fabrication of the high-quality macroporous copper film.     

Preparation and characterization of a poled nanocrystal and polymer composite PbTiO3/PEKc film for electro-optic applications

Composite thin films of PbTiO₃ nanocrystals and high-transparency PEKc polymer for applications in electro-optical devices were prepared using the spin coating technique. The size of the PbTiO₃ nanocrystals was estimated to be 30–40 nm using a transmission electron microscope. The transmission technique, a simple method for measuring the electro-optic coefficients of poled composite polymer films was developed. The electro-optic coefficient γ₃₃ of poled PbTiO₃/PEKc composite polymer films was measured to be 18.34 pm  V^-1 at 633 nm under room temperature. The index at 633 nm and the dielectric constant at 100 kHz under room temperature were determined to be 1.65248 and 7.32, respectively. The figure of merit F₂=n⁷γ²/ε was estimated to be 1546, showing very good electro-optical properties. Received: 5 February 2002 / Accepted: 12 March 2002 / Published online: 19 July 2002 RID="*" ID="*"Corresponding author. Fax: +852/2788-7791, E-mail: eeytc@cityu.edu.hk     

Measurement of aerosol size distribution functions by wavelength-multiplexed laser extinction

Previous work on the measurement of aerosol size distribution functions (SDFs) by laser extinction mainly relied on light sources from a relatively narrow wavelength range. This paper investigates the potential advantages of extending the extinction method to a general wavelength-multiplexed laser extinction (WMLE) concept by incorporating an arbitrary number of laser sources from a wider wavelength range. This extension improves the sensitivity of SDF measurements over wider aerosol diameter ranges and enables a stable algorithm to invert the extinction data to obtain SDFs. These advantages are illustrated by an example WMLE scheme employing wavelengths in the spectral range from 0.25 to 10μm to measure SDFs of water aerosols. Application of this approach to other aerosol systems is also considered. The WMLE scheme was found to provide stable determination of a variety of SDFs with Sauter mean diameters ranging from sub-micron to about 10μm. The sensitivity of such determinations was evaluated to reveal the optimum applicable range of the wavelengths employed. The analyses performed here provide theoretical background and motivation for practical applications of the WMLE concept.     

双层金属锥形扁壳的非线性热稳定性

本文提出有关双层金属锥形扁壳在均匀温度场作用下的非线性稳定性的一般理论.将双层壳体的基本方程简化为与经典壳体理论相似的形式,通过比拟,以作用于锥形扁壳边界上的均匀分布的相当边界力矩来替换温度效应,采用修正迭代法求解.文中给出了临界跳跃力矩曲线.它对于工程上各种仪表弹性元件的设计具有一定的参考价值.     

类金钢石非晶碳薄膜的光吸收和光致发光研究

我们用激光轰击石墨靶成功地制备出类金刚石无氢非晶碳薄膜.测量了光学吸收、光致发光及其随入射光强度的变化关系.结果表明,这种薄膜具有类金刚石的性质,光学带隙在1.67-2.25eV,发光在可见光区呈宽带结构.低激发强度下发光强度超线性变化,而在高激发强度下则为线性发光.我们用非成对载流子复合的模型对结果给出了合理的解释.用带尾态饱和的模型解释了发光峰值随激发光强增加而蓝移的现象.     

Structured mirror array for two-dimensional collimation of a chromium beam in atom lithography

Direct-write atom lithography,one of the potential nanofabrication techniques,is restricted by some difficulties in producing optical masks for the deposition of complex structures.In order to make further progress,a structured mirror array is developed to transversely collimate the chromium atomic beam in two dimensions.The best collimation is obtained when the laser red detunes by natural line-width of transition 7S3 → 7P40 of the chromium atom.The collimation ratio is 0.45 vertically(in x axis),and it is 0.55 horizontally(in y axis).The theoretical model is also simulated,and success of our structured mirror array is achieved.     

Pulsed microwave damage trend of bipolar transistor as a function of pulse parameters

In the present paper we conduct a theoretical study of the thermal accumulation effect of a typical bipolar transistor caused by high power pulsed microwave (HPM), and investigate the thermal accumulation effect as a function of pulse repetition frequency (PRF) and duty cycle. A study of the damage mechanism of the device is carried out from the variation analysis of the distribution of the electric field and the current density. The result shows that the accumulation temperature increases with PRF increasing and the threshold for the transistor is about 2 kHz. The response of the peak temperature induced by the injected single pulses indicates that the falling time is much longer than the rising time. Adopting the fitting method, the relationship between the peak temperature and the time during the rising edge and that between the peak temperature and the time during the falling edge are obtained. Moreover, the accumulation temperature decreases with duty cycle increasing for a certain mean power.