基于化学学科认知障碍突破的中考复习教学实践* ——以“二氧化碳的性质”为例

分析学生对二氧化碳的3个典型学科认知障碍,以“二氧化碳的捕捉”为情境,通过“尝试捕捉二氧化碳”“谁在捕捉二氧化碳”“捕捉背后的原理”等3个主要环节,实现对学科认知障碍的突破,展示了一种新的中考复习教学思路。     

Measured and Predicted Solubility Phase Diagrams of Quaternary Systems LiBr-NaBr-MgBr2-H2O and LiBr-KBr-MgBr2-H2O at 298.15 K

The stable phase equilibria of quaternary systems LiBr-NaBr-MgBr₂-H₂O and LiBr-KBr-MgBr₂-H₂O at 298.15 K were studied by both experimental measurement(isothermal solution saturation method) and theoretical prediction(Pitzer model). The solubilities of the saturated solution have been determined experimentally and two stable phase diagrams and relevant water diagrams of the two quaternary systems were obtained. Results show that quaternary system LiBr-NaBr-MgBr₂-H₂O is hydrate II type as NaBr and NaBr·2H₂O coexistence. Its phase diagram consists of only one invariant point, four univariant curves, and five crystallization fields. The quaternary system LiBr-KBr-MgBr₂-H₂O is a complex type as the double salt KBr·MgBr₂·6H₂O formed. In addition to this double salt, the three single salts LiBr·2H₂O, KBr and MgBr₂·6H₂O also crystallize. In this paper, the solubilities of phase equilibria in above quaternary systems were also calculated by the Pitzer's electrolyte solution model. All the needed parameters can be obtained from the literature or be fitted by experimental data. On the Basis of the experimental and calculated results, the phase diagram of the quaternary system was plotted for comparison. It shows that the calculation results are consistent with the experimental ones.     

Surface of room temperature ionic liquid [bmim][PF6] studied by polarization- and experimental configuration-dependent sum frequency generation vibrational spectroscopy

Understanding and control of the surface properties such as molecular orientations are of great importance in numerous applications of ionic liquids. However, there remain discrepancies among the previous experimental and theoretical studies on the surface orientation and structures of room temperature ionic liquids(RTIL) systems. In this article, the orientation of 1-butyl-3-methylimidazolium([bmin]) cation at the air/liquid interface of a characteristic RTIL, 1-butyl-3-methylimidazolium hexafluorophosphate([bmim][PF6]), was investigated by the sum frequency generation vibrational spectroscopy(SFG-VS). Detailed polarization and experimental configuration analyses of the SFG-VS spectra showed the possibility of a small spectral splitting in the CH3 symmetric stretching region, which can be further attributed to the probable existence of multiple orientations for the interfacial [bmim] cations. In addition, the(N)–CH3 vibrations were absent, ruling out the prediction by several recent molecular dynamics simulations which state that portions of the [bmim] cations orient with a standing-up(N)–CH3 group at the ionic liquid surface. Hence, new realistic theoretical models have to be developed to reflect the complex nature of the ionic liquid surface.     

QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Surface of Ru/Fe2O3 catalysts used in water-gas shift reaction studied by auger electron spectrometry

Summary Carbon deposits on the surface ofRu/Fe₂O₃ catalysts used in the water-gas shift reaction have been investigated by Auger Electron Spectrometry. A correlation has been found between the thickness of the carbon deposit and the catalytic activity in WGSR. The carbon deposit covers the metallic active centers and blocks their contact with reagents. The dotting of the iron oxide support with sodium has been found to reduce the amount of carbon deposit. .      

Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

An Efficient Selective Oxidation of Alcohols with Potassium Permanganate Adsorbed on Aluminum Silicate under Solvent-free Conditions and Shaking

A new procedure for the selective oxidation of alcohols to the corresponding aldehydes and ketones with potassium permanganate supported on aluminum silicate at room temperature under solvent-free conditions and shaking is reported.     

Analysis on X-Ray Laser Generation with EM-Wave Wiggler

The possibility of realizing SASE Free Election Laser in x-ray waveband with EM-wave wiggler is studied in this paper. SASE effect including saturation length, saturation power and nonlinear process is explored through a 3-D simulation code. A utilization of seed light from laser plasma x-ray is also analyzed, which demonstrates the feature of shortening the interaction length for saturation. The results show that sizeable output power of x-ray laser would be generated with a middle energy electron beam.