Microsensor Chip Integrated with Gold Nanoparticles‐Modified Ultramicroelectrode Array for Improved Electroanalytical Measurement of Copper Ions

This paper presents a microsensor chip integrated with a gold nanoparticles‐modified ultramicroelectrode array (UMEA) as the working electrode for the detection of copper ions in water. The microsensor chip was fabricated with Micro‐Electromechanical System technique. Gold nanoparticles were electrodeposited onto the surface of UMEA at a constant potential of ?0.3 V. The ratio d/R_b of interelectrode spacing (d) over the individual electrode’s radius (R_b) was investigated to improve the electrochemical performance. The UMEA with a d/R_b of 20 showed the best hemispherical diffusion mode, resulted in fast response time and high current response. The gold nanoparticles increased the active surface area of UMEA by not changing the geometries of UMEA, and the current response was increased further. Incorporating the optimized characteristic of UMEA and gold nanoparticles, the microsensor showed a good linear range from 0.5 to 200 µg L^?1 of copper ions in the acetate buffer solutions with the method of square wave stripping voltammetry. Compared with the gold nanoparticles‐modified disk electrode, the gold nanoparticles‐modified UMEA showed higher sensitivity (0.024 µA mm^?2 µg^?1 L) and lower limit of detection (0.2 µg L^?1). Water samples from river water and tap water were analyzed by the microsensor chip with recovery ranging from 100.7 % to 107.8 %.     

Gadolinium(III)‐Hydroxy Ladders Trapped in Succinate Frameworks with Optimized Magnetocaloric Effect

Two kinds of inorganic gadolinium(III)‐hydroxy “ladders”, [2×n] and [3×n], were successfully trapped in succinate (suc) coordination polymers, [Gd₂(OH)₂(suc)₂(H₂O)]_n ? 2n H₂O ( 1 ) and [Gd₆(OH)₈(suc)₅(H₂O)₂]_n ? 4n H₂O ( 2 ), respectively. Such coordination polymers could be regarded as alternating inorganic–organic hybrid materials with relatively high density. Magnetic and heat capacity studies reveal a large cryogenic magnetocaloric effect (MCE) in both compounds, namely (ΔH=70 kG) 42.8 J kg^?1 K^?1 for complex 1 and 48.0 J kg^?1 K^?1 for complex 2 . The effect of the high density is evident, which gives very large volumetric MCEs up to 120 and 144 mJ cm^?3 K^?1 for complexes 1 and 2 , respectively.     

Preparation of ZnO colloids by aggregation of the nanocrystal subunits

Colloidal ZnO particles with narrow size distribution were prepared via a sol-gel process by base-catalyzed hydrolysis of zinc acetate. The morphology of ordered arrays of the particles was recorded by SEM. SEM also reveals that these uniform particles were composed of tiny ZnO subunits (singlets) sized of several nanometers. The size of the singlets, which is confirmed by X-ray diffraction and UV-vis absorption spectra, increases as the aging time is prolonged. The size-selective formation of colloids by aggregation of nanosized subunits is proposed to consist of two-stage growth by nucleation of nanosized crystalline primary particles and their subsequent aggregation into polycrystalline secondary colloids. The aggregates are all spherical because the internal rearrangement processes are fast enough. The ZnO colloids, i.e., the aggregates, tend to self-assemble into well-ordered hexagonal close-packed structures. Room-temperature photoluminescence was characterized for green and aged ZnO.     

Synthesis and characterization of an intermediary of new heat-resistant energetic materials

<正>Nitration of 4,4'-biphenyldicarboxylic acid(BPDC) was studied and an aromatic carboxylic acid containing two nitro groups was synthesized and characterized through elemental analysis and IR spectra.Crystal structure of DNBPDC(DNBPDC=2,2'- dinitro-4,4'-biphenyldicarboxylic acid) was determined by X-ray single crystal diffraction and the thermal decomposition was carried out through DSC and TG-DTG analyses.     

水热沉淀法制备掺铁二氧化钛中空球及其光催化性能

 以碳球为模板剂, 采用水热沉淀法制备了不同配比掺 Fe 的 TiO2 (Fe-TiO2) 中空球, 并运用 X 射线粉末衍射、扫描电子显微镜、元素分析能谱、红外光谱和热重等方法对其进行了表征. 结果表明, 中空球为锐钛矿相, 大小为 0.5~3.20 ?m, 壳层厚度为 30~60 nm, 比表面积为 150~300 m2/g. 随着 Fe 掺杂量的增加, 中空球在可见光区的吸收强度逐渐增加. 光催化降解实验表明, 掺 Fe 后, TiO2 中空球的可见光催化活性升高, 其中 0.5% Fe-TiO2 在 80 min 内降解亚甲基蓝超过 75%. 同时还讨论了光催化机制.     

含硫醚结构均苯型聚酰亚胺的合成及表征

以4,4′-二氨基二苯硫醚(SDA)和均苯四酸酐(PMDA)为原料,通过溶液缩聚法-热酰亚胺/化学酰亚胺化的方法制备了一种含硫醚结构均苯型聚酰亚胺.利用高级旋转流变仪建立了在线跟踪反应进程的方法,采用热失重分析仪研究反应条件对热酰亚胺化及化学酰亚胺化法的影响,这些方法的建立为进一步制备高性能的聚酰亚胺提供有效的实验手段.采用小角激光光散射法、红外光谱、元素分析、接触角仪、DSC等方法对聚合物的结构与性能进行表征.结果显示,硫醚结构的引入,可有效改善聚合物薄膜的表面性能,其与铜箔之间的粘附功明显大于传统聚酰亚胺,在无胶挠性线路板应用方面显示出较好的应用前景.所获聚合物的Mw为(6.7±1.6)×104,分解温度均高于560℃;DSC的结果显示所制备的两种酰亚胺化聚合物均具有较高的玻璃化转变温度,相比之下,化学酰亚胺化更有利于获得高酰亚胺化程度的聚合物,产物的玻璃化转变温度也更高.     

Ru-La_2O_3/γ-Al_2O_3催化剂合成、表征及CO选择氧化

采用浸渍法制备系列Ru-La2O3/γ-Al2O3复合氧化物催化剂,通过XRD、H2-TPR、CO-TPR、XPS、BET等方法对催化剂进行表征,考察La2O3的加入量、预处理方法对催化剂上CO选择氧化性能的影响.结果表明,110-170℃时Ru1La6/Al2O3催化剂上CO转化率达到99%以上,氧气利用率达55.7%以上.和Ru/Al2O3相比,Ru1La6/Al2O3催化剂在较低温度具有高活性,活性温度区间变宽.适量La2O3的加入促进了活性组分在载体表面分散,提高了催化剂的活性.经氢气预处理的Ru1La6/Al2O3催化剂活性最佳,催化剂上Ru物种结合能降低,表面钌物种活性位增多,且表面晶格氧浓度增大,更有利于CO气体在催化剂表面上的氧化反应.     

Liquid Chromatographic Assay of Peptides Activity with Inhibiting Angiotensin Converting Enzyme

A rapid, simple and interference-free method was developed to evaluate the inhibitory activity of hydro-lyzed peptides from egg white protein against the angiotensin-converting enzyme. The total reaction volume was 60 μL, saving the cost. The assay was based on a HPLC separation and quantification of the synthetic substrate hip-puryl-L-histidyl-L-leucine and its hydrolyzed product―hippuric acid; the separation was performed on a C 18 column eluted by a mobile phase of acetonitrile/water(0.5% TFA) at a volume ratio of 25:75. At a signal to noise ratio(S/N) of 10, the detective limit of the quantitation of hippuric acid was (0.4600±0.0097) μmol/L. The standard curve shows a linear response with a slope of 49488 and a correlation coefficient of 0.9995. The assay was adequate for the study of ACE inhibition by Captopril and peptides derived from food protein, and showed a very good correlation with the previous methods.     

Brφnsted酸性离子液体催化合成长链脂肪酸甲酯

本文合成了以1-丁基-3-甲基咪唑为阳离子,HSO4-、H2PO4-和BF4-为阴离子的Brφnsted酸性离子液体,并以长链脂肪酸与甲醇的酯化反应考察了这些Brφnsted酸性离子液体的催化性能。实验结果表明,1-丁基-3-甲基咪唑硫酸氢根鎓盐([bmim][HSO4])离子液体具有很高的催化活性,当n(醇)∶n(酸)∶n(离子液体)=6∶1∶0.25,反应温度为70℃,不分水酯化反应2h,长链脂肪酸甲酯的产率可达到93.4%以上,选择性达到100%;且产物酯与离子液体分离容易;离子液体经干燥处理后可以循环使用5次以上,催化活性没有明显降低。     

内置多孔介质卷式反应器富燃制氢实验研究

设计了一个新型内置多孔介质卷式制氢反应器,进行了天然气/空气预混气在当量比1.25~2.50,总流量60 L/min~120 L/min条件下的富燃实验,研究其自热重整制氢的燃烧特性。结果表明,富燃情况下可实现自维持燃烧,自稳定响应时间较快;反应器Swiss-roll结构的有效预热与中心多孔介质的蓄热,可提高反应温度至1 600 K以上,实现超绝热富燃制氢;固定流量条件下,甲烷的转化效率与能量利用率随着当量比的变化而改变。实验中,氢气生成率与能量利用率分别为30%~57%、50%~84%。流量为120 L/min,当量比为2.0时,尾气中H2浓度达22%,氢气生成率为57%,能量利用率为68%。