Synthesis and Characterization of Titanium-doped Ordered Mesoporous Alumina

Titanium-doped ordered mesoporous alumina with specific structural properties has been prepared by the evaporation induced self-assembly sol-gel method. The results show that the doped titanium helps to stabilize the ordered mesoporous alumina material without influencing the ordered mesoporosity. The textural properties of the obtained sample are related to the amount of doped titanium. When the molar ratio of aluminum to titanium(n(Al)/n(Ti)) is controlled as 10.2, the titanium-doped ordered mesoporous alumina exhibits high surface area(up to 218 m2 g-1), large pore volume(0.42 cm3 g-1) and narrow pore diameter(6.1 nm) after treating at 900 ℃, showing high thermal stability. Moreover, the obtained sample calcined at 900 ℃ still maintains ordered mesoporous structure and exhibits high thermal stability.     

激光剥蚀电感耦合等离子体质谱在涂料重金属分析中的应用

将激光剥蚀进样技术(LA)与ICP-MS检测器联用,并将这一新技术应用在涂料重金属元素的检测上,通过优化LA和ICP-MS参数,并采用双气流校正技术,以13C、103Rh为双内标,有效地改善了信号强度和稳定性,同时对Hg的记忆效应进行研究,最终建立了LA-ICP-MS法测定涂料中Cr、As、Cd、Sn、Sb、Hg、Pb元素的定量分析方法,样品测定结果与湿法消解ICP-OES法基本吻合。     

Addendum to: Fabrication and characterization of graphene derived from SiC

<正>Addendum to:Science China:Physics,MechanicsAstronomy,2013,56(12):2386–2394doi:10.1007/s11433-013-5348-2The legends of the following Figures should be as follows:Figure 3 AFM morphologies and Raman spectra of a EG on a 2 inch SiC(0001)measured at five representative regions.(a)AFM Morphology reproduced from ref.[14]with permission from Science China Press and Springer publishing,(b)Raman spectra.Figure 6 SEM images of the VAGS.(a)Cross-section image of the VAGS;(b)and(c)are the top view images of the as-grown VAGS and the VAGS after top graphene layer removed reproduced from ref.[16]with permission from Wiley-VCH publishing.     

Ab initio calculations on the ground and excited states of InI

Potential energy curves (PECs) of the ground and the low-lying excited states of the InI molecule are computed using the internally contracted multireference singles and doubles configuration interaction with the Davidson correction (ic-MR-CISD + Q) method based on the relativistic effective core potentials (RECPs). The spectroscopic constants are obtained, including the excitation energy (T _e), the equilibrium bond distance (R _e), the dipole moment (μ_e) and the vibrational constants (ω_e and ω_e). Finally, we predict the transition dipole moments, the radiative lifetimes, and the Franc-Condon factors for the transitions of A³Π₀+ ? X¹Σ₀ ⁺ and B³Π^l ? X¹Σ₀ ⁺,. The results reveal that A³Π₀+ and B³Π_l are long-lived states with the lifetimes being of the order of microseconds.     

具有双荧光发射的螺吡喃的合成与性质研究

设计合成了未见文献报道的含有双官能团的螺吡喃类化合物1,通过红外光谱、核磁共振氢谱、碳谱和高分辨质谱对其结构进行了确证。紫外可见吸收光谱表明化合物在有机溶剂中的光致变色性良好;化合物的乙醇溶液在365 nm光激发时产生双荧光发射,分别为闭环体和开环体所对应的的荧光峰。本文首次从场效应角度推测了螺吡喃吲哚林N原子上含有极性基团时开环体稳定的原因。     

Hypercoal对不同炼焦煤炭化改质作用的显微镜研究

Hypercoal(HPC)被作为一种添加剂加入到两种性质不同的炼焦煤中,以探讨其对炼焦煤炭化的改质作用。通过偏光显微镜以及扫描电镜观测炭化产物的组织结构变化。结果表明,添加剂的用量以及粒径对炼焦煤炭化改质作用的大小与原料煤的煤质有关,对焦煤改质时要求添加剂颗粒的粒径较大;而对弱黏结性煤改质时,添加剂粒径较小且添加量较多更有利于黏结和熔融作用。通过添加HPC可改善焦煤因过度膨胀造成的不均匀孔隙结构,而且孔的数量与孔径减小,孔壁增厚;添加剂在炭化过程中产生的胶质体促进了弱黏结性煤的黏结和熔融,改善了炭化产物的结构。实验还考察了原料中水分、成型压力等因素对炭化产物结构的影响。结果表明,煤中水分会在炭化产物中产生特殊的孔隙结构,而成型压力对炭化改质作用则因原料煤质不同而不同。     

聚刚果红修饰电极直接测定槐米中芦丁

采用电化学聚合法制备了聚刚果红膜修饰电极,应用循环伏安法研究芦丁在该修饰电极上的电化学行为。实验表明,聚刚果红修饰电极对芦丁具有良好的电催化作用,在5.0×10-8～8.0×10-6 mol/L浓度范围内,芦丁的差示脉冲伏安峰电流与其浓度呈良好的线性关系,检测限为2.0×10-8 mol/L。该法可用于槐米中芦丁的直接测定。     

液体聚异戊二烯的合成与应用研究进展

固态橡胶具有较高的分子量、强度及伸长率,在工业和日常生活中均得到广泛应用.然而,固态橡胶黏度较高,在应用中往往必须引入添加剂.而液体聚异戊二烯是一种液态橡胶,可以作为固态橡胶的软化剂;得益于其特殊的形态和性能,液体聚异戊二烯可望在多方面得到应用.对液体聚异戊二烯的合成与应用进行了评述.