AES investigations of the iron surface composition after laser irradiation under atmospheric conditions

The laser induced modification of iron surfaces with atmospheric species was investigated by means of Auger electron spectroscopy (AES) and scanning electron microscopy (SEM). Different laser systems were used for irradiating iron samples in a wide range of the laser processing parameters up to small foci and ultra short pulses.A nitriding of iron connected with an oxidation of the near surface region was observed in the wavelength range between 193 nm and 10.6 m using large foci (0.1 cm²) and short pulses (10...1400ns). In case of small foci (7·10^–6cm²) with ns-pulses (50 ns) an enrichment of the iron melt with nitrogen and an advanced oxidation of the surrounding area of the laser spot were detected. When using shorter pulses (200 fs, 40 ps) no indications for a nitriding were found.     

Electrical and infrared dielectrical properties of silica aerogels and of silica-aerogel-based composites

In this contribution we have studied the key electrical parameters of silica aerogels and of silica-aerogel-based composites, namely the dielectric constants , the dielectric losses tan (at 1 kHz), and the breakdown fields E _b (at 50 Hz). For low-density bulk silica aerogels we find =1.25 and tan =0.0005. E _b is about 500 kV/cm in quasi-homogeneous fields, and of the order of MV/cm in strongly inhomogeneous fields. The dielectric constants of partially densified aerogels increase linearly with density; their dielectric losses are relatively large and their breakdown fields are comparativiely low. The same results are found for aerogels in the form of settled materials, i.e. aerogel granules and powders in air. Acrylate-based aerogel composites with volume fractions larger than 70% have low dielectric constants but their losses are at least 10 times higher than those of low-density aerogels. These materials sustain high local fields in the MV/cm region, while in quasihomogeneous fields, breakdown occurs at about 100 kV/cm. Based on the present results and the interplay with other physical properties (low mechanical resistance, low thermal conductivity, adsorption of water, etc.), silica aerogels and silica aerogel-acrylate-based composites are predicted to have a low potential for electrical insulation.     

Mixing automorphisms of compact groups and a theorem of Schlickewei

Summary We prove that every mixing ^d by automorphisms of a compact, connected, abelian group is mixing of all orders.Oblatum 5-II-1992The second author gratefully acknowledges support from NSF grant DMS-91-03056 at the Ohio State University     

On the size of a maximal partial spread

We show that a maximal partial spread inPG(3,q) is either a spread or has at most lines. This implies that it is not possible to cover all points but the points of a Baer-subspace by lines.     

Synthesen von Heterocyclen, 72. Mitt.: 4-Phenyl-3,4-dihydro-carbostyrile aus α-Cyanzimtsäureamiden

Zusammenfassung Bei der Reaktion vonSchiffschen Basen mit Cyanacetylchlorid entstehen über labile Addukte -Cyanzimtsäure-anilide, die in Gegenwart von AlCl₃ zu Derivaten des 3-Cyan-4-phenyl-3,4-dihydrocarbostyrils reagieren. Aus diesen kann durch Verseifung die Cyangruppe eliminiert werden.

---

The reaction of azomethines with cyanoacetyl chloride leads via instable adducts to -cyanocinnamic anilides, which with AlCl₃ undergo cyclisation to derivatives of 3-cyano-4-phenyl-3,4-dihydrocarbostyrils. The cyano group in these compounds can be removed by hydrolysis and decarboxylation.

---

---

Herrn KollegenO. Hromatka, Wien, mit den besten Wünschen zum 60. Geburtstag.     

A variable concept for the preparation of branched glycosyl phosphatidyl inositol anchors

A variable concept for the synthesis of branched glycosyl phosphatidyl inositol (GPI) anchors was established. Its efficiency could be shown by the successful synthesis of the GPI anchor of rat brain Thy-1 and of the scrapie prion protein both in the water soluble 1c and lipidated form 1a. Retrosynthesis led to building blocks 2-6 of which 5 could be further disconnected to building blocks 7-9. Trichloroacetimidate 5 was built up in a straightforward manner starting from glycosyl acceptor 9 using known glycosyl donors 7 and 8. The carbohydrate backbone was then assembled by glycosylation of pseudodisaccharide acceptor 6 with donor 5. To ensure high stereoselectivity and good yields in the glycosylation reactions, anchimeric assistance was employed. Successive deprotection and introduction of the various phosphate residues gave the fully protected GPI anchors. Catalytic hydrogenation and acid-catalyzed cleavage of the Boc protecting groups afforded the target molecules, which could be fully structurally assigned.     

Organopolysiloxanes as Chemically Sensitive Coatings for Optical Fibers

Various types of UV-curable organically modified siloxanes have been synthesized by the sol-gel method with the aim of fabricating chemically sensitive coatings for silica optical fibers. The refractive index of the coating material can be tailored in the range from 1.46 to 1.56 and sensitivity towards CO2 is achieved by incorporation of amino groups. The interaction of the cured layers with CO2 or with hydrocarbons has been studied in immersion experiments. Both the reaction of CO2 with incorporated amino groups and the penetration of hydrocarbons into the layer induce changes of the light absorption coefficient and the refractive index of the coating which are detected by measuring the output light intensity from the fiber.