Analysis of polycyclic aromatic hydrocarbons extracted from air particulate matter using a temperature programmable injector coupled to GC–C–IRMS†

Compound specific isotopic analysis (CSIA) can provide information about the origin of analysed compounds – in this case, polycyclic aromatic hydrocarbons (PAHs). In the study, PAHs were extracted from three dust samples: winter and summer filter dust and tunnel dust. The measurement was performed using the method validated in our laboratory using pure, solid compounds and EPA 610 reference assortment.

CSIA required an appropriate clean-up method to avoid an unresolved complex in the gas chromatographic analysis usually found in the chromatography of PAHs. Extensive sample clean-up for this particular matrix was found to be necessary to obtain good gas chromatography–combustion–isotope ratio mass spectrometry analysis results. The sample purification method included two steps in which the sample is cleaned up and the aliphatic and aromatic hydrocarbons are separated.

The concentration of PAHs in the measured samples was low; so a large volume injection technique (100 μl) was applied. The δ_VPDB ¹³C was measured with a final uncertainty smaller than 1 ‰. Comparison of the δ_VPDB ¹³C signatures of PAHs extracted from different dust samples was feasible with this method and, doing so, significant differences were observed.     

Effects of Microstructural Defects on Ion-Irradiated Type-316 Stainless Steel

Microstructure defects play a very important role in the swelling of irradiated stainless steel. This work is a parametric study of the effects of microstructural defects on the swelling of ion-irradiated steel. For simplicity, vacancy loop effects were neglected. Cold working was found to play a complicated role in the swelling behavior. On one hand, it increase the bias to interstitial absorption due to the increase in dislocation density. On the other hand, it decreases the total flux of point defects to voids by the decrease of the point defect concentrations. Grain size has also a strong effect on swelling. It was found that large gain sizes produces higher swelling and vise versa, i.e. the larger the surface of grain boundaries the less the irradiation-produced swelling. Similar effects were found for precipitates.     

Kinetic parameters,collision rates,energy exchanges and transport coefficients of non-thermal electrons in premixed flames at sub-breakdown electric field strengths

The effects of an electric field on the collision rates, energy exchanges and transport properties of electrons in premixed flames are investigated via solutions to the Boltzmann kinetic equation. The case of high electric field strength, which results in high-energy, non-thermal electrons, is analysed in detail at sub-breakdown conditions. The rates of inelastic collisions and the energy exchange between electrons and neutrals in the reaction zone of the flame are characterised quantitatively. The analysis includes attachment, ionisation, impact dissociation, and vibrational and electronic excitation processes. Our results suggest that Townsend breakdown occurs for E/N = 140 Td. Vibrational excitation is the dominant process up to breakdown, despite important rates of electronic excitation of CO, CO₂ and N₂ as well as impact dissociation of O₂ being apparent from 50 Td onwards. Ohmic heating in the reaction zone is found to be negligible (less than 2% of peak heat release rate) up to breakdown field strengths for realistic electron densities equal to 10¹⁰ cm^?3. The observed trends are largely independent of equivalence ratio. In the non-thermal regime, electron transport coefficients are insensitive to mixture composition and approximately constant across the flame, but are highly dependent on the electric field strength. In the thermal limit, kinetic parameters and transport coefficients vary substantially across the flame due to the spatially inhomogeneous concentration of water vapour. A practical approach for identifying the plasma regime (thermal versus non-thermal) in studies of electric field effects on flames is proposed.     

Synthesis and Characterization of Pressure and Temperature Dual‐Responsive Polystyrene Microbeads

A facile approach to the synthesis of pressure and temperature dual‐responsive polystyrene (PS) microbeads with controlled sizes via dispersion polymerization is described. Three different luminophors are selected and directly introduced into the reaction system and thus incorporated into the resultant PS microbeads during polymerization. By manipulating the reaction conditions, including concentrations of the initiator and monomer, polarity of the reaction medium, and injection rate for the monomer, uniform PS microbeads with sizes ranging from 1 to 5 μm are obtained. When a light source centered at 365 nm is used to excite all the luminophors in the PS beads, three distinct and resolvable emission peaks corresponding well with the luminophors are observed. By taking advantage of their sensitive responses to both pressure and temperature, the PS beads can be utilized for quantitative measurements of these two stimulations simultaneously. The PS beads loaded with multiple luminophors have the ability to serve as building blocks for the fabrication of novel sensing and imaging devices and therefore provide a promising strategy for the study of aerodynamics.     

Light reflection from finite conductors with a Gaussian random roughness using Kirchhoff and geometric optics approximations

A comparison between exact solutions and two approximate models, Kirchhoff approximation (KA) and geometric optics approximation (GOA), for reflection from random Gaussian rough conductive metallic surfaces for three regimes of correlation length in both cases of polarization TM and TE has been reported. The phenomenon of excitation of surface plasmons (SPs) has been shown only at TM polarization for KA. The domains of validity of both approximate models have been quantified. It is shown that accuracy and efficiency of any approximate method depended of various parameters: surface roughness, polarization, SPs effects, wavelength, and surface materials. KA is efficient for weakly rough surfaces with correlation length greater than wavelength, but when rms height increases GOA is more suitable than KA. Excitation of SPs is observed only at TM-polarized light, only for weakly rough surfaces with correlation length less than wavelength using KA and not GOA.     

Cooperative interaction between π-hole and single-electron σ-hole interactions in O2S···NCX···CH3 and O2Se···NCX···CH3 complexes (X = F,Cl, Br and I)

Ab initio calculations are performed to analyse the cooperative effects between π-hole and single-electron σ-hole interactions in O₂S···NCX···CH₃ and O₂Se···NCX···CH₃ complexes, where X = F, Cl, Br and I. These effects are investigated in terms of geometric and energetic features of the complexes, which are computed by UMP2/aug-cc-pVTZ(-PP) method. Our results indicate that the shortening of the each π-hole bond distance in the complexes is dependent on the strength of the σ-hole interaction. The maximum and minimum energetic cooperativity values correspond to the most and least stable complexes studied in the present work. The cooperativity between both types of interaction is chiefly caused by the electrostatic effects. The topological analysis, based on the quantum theory of atoms in molecules, is used to characterise the interactions and analyse their enhancement with varying electron density at bond critical points.