Application of differential electrolytic potentiometry for detection in flow injection analysis

The applicability of differential electrolytic potentiometry as a detection system in flow injection analysis is investigated. A computer-controlled injector which delivers precise volumes of sample solutions in a reproducible manner was developed. Conditions such as current density employed, the concentrations of the solutions used and the flow rate were optimized. Chloride in water was determined by means of this system. The relation between chloride concentration and the measured signal was found to be Nernstian for solutions of concentrations above 6 μg ml⁻¹ chloride. For solutions below this concentration, the relation is linear.     

Cation behavior at an artificial cell interface: binding distinguished by ion hydration energetics and size

The unique molybdenum oxide-based nucleophilic porous capsule/artificial cell [{(MoVI)MoVI5O21(H2O)6}12{MoV2O4(SO4)30}]72-, according to an X-ray crystallographic study, traps [Al(H2O)6]3+ complexes above the pores while interacting with the latter via hydrogen bonds; this is supported by 27Al NMR studies of the interaction of the capsule with hydrated Al3+ cations in aqueous solution.     

Substitutional carbon defects in silicon: A quantum mechanical characterization through the infrared and Raman spectra

The infrared (IR) and Raman spectra of eight substitutional carbon defects in silicon are computed at the quantum mechanical level by using a periodic supercell approach based on hybrid functionals, an all electron Gaussian type basis set and the CRYSTAL code. The single substitutional C _s case and its combination with a vacancy (C _sV and C _sSiV) are considered first. The progressive saturation of the four bonds of a Si atom with C is then examined. The last set of defects consists of a chain of adjacent carbon atoms C, with i = 1–3. The simple substitutional case, C _s, is the common first member of the three sets. All these defects show important, very characteristic features in their IR spectrum. One or two C related peaks dominate the spectra: at 596 cm⁻¹ for C _s (and C _sSiV, the second neighbor vacancy is not shifting the C _s peak), at 705 and 716 cm⁻¹ for C _sV, at 537 cm⁻¹ for C and C (with additional peaks at 522, 655 and 689 for the latter only), at 607 and 624 cm⁻¹, 601 and 643 cm⁻¹, and 629 cm⁻¹ for SiC, SiC, and SiC, respectively. Comparison with experiment allows to attribute many observed peaks to one of the C substitutional defects. Observed peaks above 720 cm⁻¹ must be attributed to interstitial C or more complicated defects.     

Calculating slow-motional electron paramagnetic resonance spectra from molecular dynamics using a diffusion operator approach

A number of groups have utilized molecular dynamics (MD) to calculate slow-motional electron paramagnetic resonance (EPR) spectra of spin labels attached to biomolecules. Nearly all such calculations have been based on some variant of the trajectory method introduced by Robinson, Slutsky and Auteri (J. Chem. Phys. 1992,96, 2609-2616). Here we present an alternative approach that is specifically adapted to the diffusion operator-based stochastic Liouville equation (SLE) formalism that is also widely used to calculate slow-motional EPR line shapes. Specifically, the method utilizes MD trajectories to derive diffusion parameters such as the rotational diffusion tensor, diffusion tilt angles, and expansion coefficients of the orienting potential, which are then used as direct inputs to the SLE line shape program. This approach leads to a considerable improvement in computational efficiency over trajectory-based methods, particularly for high frequency, high field EPR. It also provides a basis for deconvoluting the effects of local spin label motion and overall motion of the labeled molecule or domain: once the local motion has been characterized by this approach, the label diffusion parameters may be used in conjunction with line shape analysis at lower EPR frequencies to characterize global motions. The method is validated by comparison of the MD predicted line shapes to experimental high frequency (250 GHz) EPR spectra.     

Ultraviolet-B radiation effects on the structure and function of lower trophic levels of the marine planktonic food web

The impact of UV-B radiation (UVBR; 280-320 nm) on lower levels of a natural plankton assemblage (bacteria, phytoplankton and microzooplankton) from the St. Lawrence Estuary was studied during 9 days using several immersed outdoor mesocosms. Two exposure treatments were used in triplicate mesocosms: natural UVBR (N treatment, considered as the control treatment) and lamp-enhanced UVBR (H treatment, simulating 60% depletion of the ozone layer). A phytoplankton bloom developed after day 3, but no significant differences were found between treatments during the entire experiment for phytoplankton biomass (chlorophyll a and cell carbon) nor for phytoplankton cell abundances from flow cytometry and optical microscopy of three phytoplankton size classes (picoplankton, nanoplankton and microplankton). In contrast, bacterial abundances showed significantly higher values in the H treatment, attributed to a decrease in predation pressure due to a dramatic reduction in ciliate biomass (approximately 70-80%) in the H treatment relative to the N treatment. The most abundant ciliate species were Strombidinium sp., Prorodon ovum and Tintinnopsis sp.; all showed significantly lower abundances under the H treatment. P. ovum was the less-affected species (50% reduction in the H treatment compared with that of the N control), contrasting with approximately 90% for the other ones. Total specific phytoplanktonic and bacterial production were not affected by enhanced UVBR. However, both the ratio of primary to bacterial biomass and production decreased markedly under the H treatment. In contrast, the ratio of phytoplankton to bacterial plus ciliate carbon biomass showed an opposite trend than the previous results, with higher values in the H treatment at the end of the experiment. These results are explained by the changes in the ciliate biomass and suggest that UVBR can alter the structure of the lower levels of the planktonic community by selectively affecting key species. On the other hand, linearity between particulate organic carbon (POC) and estimated planktonic carbon was lost during the postbloom period in both treatments. On the basis of previous studies, our results can be attributed to the aggregation of carbon released by cells to the water column in the form of transparent exopolymer particles (TEPs) under nutrient limiting conditions. Unexpectedly, POC during such a period was higher in the H treatment than in controls. We hypothesize a decrease in the ingestion of TEPs by ciliates, in coincidence with increased DOC release by phytoplankton cells under enhanced UVBR. The consequences of such results for the carbon cycle in the ocean are discussed.     

Floating and sustained-release characteristics of effervescent tablets prepared with a mixed matrix of Eudragit L-100-55 and Eudragit E PO

The aim of this study was to evaluate the influence of Na-bicarbonate as an effervescent agent on the floating and sustained-release characteristics in 0.1 M HCl of tablets made of Eudragit E PO (EE) and/or Eudragit L-100-55 (EL) as matrix formers at different EE:EL weight ratios: 0:100, 25:75, 50:50, 75:25, and 100:0. The tablets were made by direct compression utilizing metronidazole as a model drug. Effervescent tablets with 50EE/50EL (w/w) showed the best floating and sustained drug release properties in the dissolution medium. The corresponding noneffervescent tablets were nonfloating and showed significantly faster drug release. Effervescent tablets with single polymers showed an immediate drug release pattern. These results were explained by Fourier-transform infrared spectroscopy and elemental analysis, which showed strong evidence of interpolyelectrolyte complexation between EE and EL when they were exposed to 0.1 M HCl as an effervescent hybrid matrix, but not as a noneffervescent hybrid matrix. The role of Na-bicarbonate in allowing EE-EL complexation during dissolution was explained as due to raising the pH around EL particles for sufficient polymer ionization and ionic-interaction with the ionized EE.     

Corrosion inhibition of iron in hydrochloric acid using pyrazole

The corrosion and corrosion inhibition of iron in HCl solutions in the absence and presence of pyrazole (PA) were investigated by potentiodynamic polarization and electrochemical impedance spectroscopy (EIS). Changes in impedance parameters (R_ct and C_dl) were indicative of the adsorption of PA on the iron surface. The adsorption of PA is found to obey Langmuir adsorption isotherm. The study suggests that this compound is an anodic inhibitor.     

Bioactive isocoumarins from a terrestrial Streptomyces sp. ANK302

Four isocoumarins have been isolated from the terrestrial Streptomyces sp. ANK302, namely 6,8-dimethoxy-3-methylisocoumarin (1), 6,8-dihydroxy-3-methylisocoumarin (2), 6,8-dihydroxy-7-methoxy-3-methylisocoumarin (3), and 6,7,8-trimethoxy-3-methylisocoumarin (4). Compound 1 is a new naturally-occurring isocoumarin, and 2 was isolated as a new bacterial product. The structures 1-4 were deduced from high resolution mass, 1D and 2D NMR spectra and by comparison with related compounds from the literature. Compound 2 showed a strong zoosporicidal activity at a concentration of 5 microg/mL against a phytopathogenic oomycete, Plasmopara viticola, and 1 was active against     

Kinetic catalytic determination of trace levels of iodide based on the oxidation of basic dyes with hydrogen peroxide monitored potentiometrically using simple PVC electrodes

Four sensitive catalytic potentiometric methods have been developed for trace levels determination of iodide based on its catalytic effects on the oxidation of four dyes: viz. variamine blue (VB), rhodamine B (RB), methylene blue (MB) and malachite green (MG), with H₂O₂ in H₃PO₄ medium at 25 ± 0.5 °C. The catalyzed reaction rates were estimated potentiometrically by monitoring the potential of the corresponding dye-PVC ion selective electrodes. To select the optimized reaction conditions offering the highest sensitivity of the method, parallel studies were carried out on each dye catalyzed reaction including: the effect of reactant concentration, reaction medium and temperature. The working calibration curves were linear over the concentration range from 0.32 to 2.54 mg L⁻¹ iodide for VB method and from 3.2 to 12.7 mg L⁻¹ for other ones. The tolerance limits of more than 20 interfering species were listed indicating the high selectivity of the method. Trace iodide in edible salt and pharmaceutical samples was determined without the need for separation or preconcentration procedures.