Coordination Behavior of Sterically Protected Phosphaalkenes on the AuCl Moiety Leading to Catalytic 1,6‐Enyne Cycloisomerization

Mes*‐substituted 2,3‐dimethyl‐1,4‐diphosphabuta‐1,3‐diene, 1,2‐diphenyl‐3,4‐diphosphinidenecyclobutene, 2,2‐bis(methylsulfanyl)‐1‐phosphaethene, and 3,3‐diphenyl‐1,3‐diphosphapropenes (Mes*=2,4,6‐tri‐tert‐butylphenyl) were employed as P ligands of gold(I) complexes. The (E,E)‐2,3‐dimethyl‐1,4‐diphosphabuta‐1,3‐diene functioned as a P2 ligand for digold(I) complex formation with or without intramolecular Au–Au contact, which depends on the conformation of the 1,3‐diphosphabuta‐1,3‐diene. The 1,2‐diphenyl‐3,4‐diphosphinidenecyclobutene, which has a rigid s‐cis P?C? C?P skeleton, afforded the corresponding digold(I) complexes with a slight distortion of the planar diphosphinidenecyclobutene framework and intramolecular Au–Au contact. In the case of the 2,2‐bis(methylsulfanyl)‐1‐phosphaethene, only the phosphorus atom coordinated to gold, and the sulfur atom showed almost no intra‐ or intermolecular coordination to gold. On the other hand, the 1,3‐diphosphapropenes behaved as nonequivalent P2 ligands to afford the corresponding mono‐ and digold(I) complexes. Some phosphaalkene–gold(I) complexes showed catalytic activity for 1,6‐enyne cycloisomerization without cocatalysts such as silver hexafluoroantimonate.     

Photoinduced desorption of sulfur from gold nanoparticles loaded on metal oxide surfaces

We now report photoinduced sulfur desorption from the surfaces of Au nanoparticles loaded on metal oxides. This reaction occurs in water at ordinary temperature and pressure. Nanometer-sized Au particles have been formed on the surfaces of various metal oxides by deposition-precipitation (Au/oxides). Elemental sulfur (S8) is selectively adsorbed on the Au nanoparticle surfaces of Au/oxides in an atomic state at a coverage of (theta) 1/3. Irradiation (lambdaex > 300 nm) of the sulfur adsorbed Au/anatase TiO2 in water has led to reductive desorption of the sulfurs at room temperature. Electrochemical measurements using Au/oxides indicate that the driving force for this reaction is the photoinduced upward shift of Fermi energy of the metal oxide-supported Au nanoprticles. This study will open up a novel and wide application of heterogeneous photocatalysis for thermal catalysts.     

Aqueous Titanate Sols from Ti Alkoxide-α-Hydroxycarboxylic Acid System and Preparation of Titania Films from the Sols

Aqueous titanate sols were prepared by reactions of titanium tetraisopropoxide (TIP) with -hydroxycarboxylic acids in water. IR and Raman spectra, and elemental analyses of the precipitates obtained from the sols revealed that the carboxylates were chelated to titanium but the Ti species were polymerized to form a cluster that had a colloidal nature. Spin-coating of titania (TiO₂) thin films from these sols was also examined. Interestingly, it was found that (004) preferentially oriented anatase films with refractive index of 2.54 were obtained from TIP-lactic acid-NH₃ (1:1:1, molar ratio) aqueous sol. This crystallographic orientation was characteristic of the TIP-lactic acid-NH₃ (1:1:1) system, and was not affected by the kinds of substrates used and the heating rate of the film. TEM observation indicated that small anatase grains had already formed at 200°C. Therefore, the crystallographic orientation might depend strongly on the structure of the chemical species of the precursor solutions.     

Electrochemical formation of stable ferrocene anion and the formal rate constant of the ferrocene0/− electrode

A reversible cyclic voltammogram for the one-electron reduction of ferrocene in 1,2-dimethoxyethane is recorded under experimental conditions that enable the ferrocene anion to exist for a few minutes. The formal rate constant of the ferrocene^0/? electrode, determined by cyclic voltammetry at ?45°C, ca. 10^?3 cm s^?1, is in striking contrast with that of ferrocene^+/0, > 10^?1 cm s^?1. The distortion of the ferrocene molecule caused by reduction may be a reason for this difference in electron-transfer rate.     

Application of preparative high-speed counter-current chromatography for separation of methyl gallate from Acer truncatum Bunge

Preparative separation of methyl gallate in leaves extract of Acer truncatum Bunge was conducted using high-speed counter-current chromatography (HSCCC) with a solvent system composed of ethyl acetate-ethanol-water at volume ratios of 5:1:5 (v/v/v). In a single operation, 57.5 mg of methyl gallate was obtained from 120 mg of the extract. HPLC analyses of the counter-current chromatography (CCC) fraction revealed that the methyl gallate was having over 97% purity. Its structure was identified by 1H NMR and 13C NMR.     

Radiation-induced solid-state polymerization of trioxane under high pressure

The in-source polymerization of trioxane in the solid state was investigated over a wide range of temperature and pressure, i.e., from 30 to 140°C and up to 7000 kg/cm², respectively. In the polymerization that was carried out slightly below the melting point under pressure, the higher the pressure, the higher the rate of polymerization. It was confirmed that the maximum rate of solid-state polymerization of trioxane occurs near the melting points, even under elevated pressure. The rate of polymerization decreased with increasing pressure at constant temperature. The shape of the time–conversion curves may be classified into two types, i.e., one which is typical of high pressure and low temperature, and the other which is typical of low pressure and high temperature. Changes in the shape of the conversion—intrinsic viscosity curves occurred coincidentally. Thus, three regions for the different “polymerization characteristic” were determined as functions of polymerization temperature and pressure. Explanations are given for the above-mentioned polymerization characteristic.     

SERS and FT-IR studies of CO adsorbed on underpotential deposited Ag/Pt electrodes

CO adsorbed on UPD and OPD (under- and overpotential deposited) Ag layers on a Pt electrode surface was studied by SERS and IRRAS in conjunction with cyclic voltammetry. Electrochemical activation of a uniform UPD Ag adlayer produced Ag clusters on the Pt electrode as well as bare Pt sites. The strong adsorption of CO on the UPD Ag/Pt electrode compared with a bulk Ag electrode is explained by the influence of the substrate Pt atoms. The degree of electron back-donation to CO increases the degree of lower frequency shifts of CO on the electrodes in the order Pt electrodes < monolayer Ag/Pt < multilayer Ag/Pt.     

A new-type photoreaction of a carbonyl compound: Part 2. Photoinduced ω-bond dissociation in p-halomethylbenzophenone studied by time-resolved EPR technique and laser flash photolysis

Photodissociation of the carbon-X (X = Br and Cl) bonds in p-bromo- and p-chloromethylbenzophenone (BMBP and CMBP) in solution were investigated by time-resolved EPR and laser flash photolysis techniques. BMBP and CMBP were found to undergo ω-bond cleavage to yield the p-benzoylbenzyl radical (BBR) at 295 K, and the quantum yields (Φ_BBR) were determined. The CIDEP signal originated from BBR formed upon decomposition of CMBP was obtained while that for BMBP was absent. By using triplet sensitization of acetone, the efficiencies (_BBR) of the CX bond fission in the triplet states of BMBP and CMBP were determined. The agreement between the Φ_BBR and _BBR values for CMBP indicates that the CCl bond dissociation occurs only in the triplet state. In contrast to CMBP, the cleavage of the CBr bond in BMBP upon direct excitation was concluded to be the event only in the excited singlet state without triplet formation, whereas the triplet state was also reactive for ω-bond dissociation. The rate of CBr bond dissociation seemed to be greater than that of intersystem crossing from the S₁ to the T₁ state. Schematic energy diagrams of the excited states of BMBP and CMBP were shown, and the reaction profiles were discussed from the viewpoint of the CX bond enthalpies.     

Reaction of carboxamide with Cu2Oisonitrile complex; formation of a new chelated copper(I) complex

Reaction of carboxamides with Cu₂O in the presence of t-butyl isocyanide gave new chelated copper(I) complexes, which probably are formed by the insertion of t-butyl isocyanide into the coppernitrogen bond of copper(I) amide isonitrile complexes, which were initially produced from the carboxamides and Cu₂Ot-butyl isocyanide complex. The same chelated copper(I) complexes were prepared more readily by the reaction of the corresponding N-trimethylsilyl-carboxamides with Cu₂Ot-butyl isocyanide complex. Reactions of the copper(I) complexes thus obtained with alkylating agents, such as alkyl halides, alkyl tosylates and triethyloxonium tetrafluoroborate, also were described.