Multiferroic TbMnO3 nanoparticles

We report on the synthesis of TbMnO₃ nanoparticles by chemical co-precipitation route and their structural, chemical bonding, magnetic and dielectric properties. It is shown that the interesting multiferroic properties of this system as reflected by the concurrent occurrence of magnetic and dielectric transitions are retained in the nanoparticles (size∼40 nm). However, the nanoparticle constitution and properties are seen to depend significantly on the calcination temperature. While the nanoparticles obtained by calcination at 800 °C correspond very well with the reported properties of single phase TbMnO₃ (all the key magnetic and dielectric features near 7, 27 and 41 K, albeit with reduced dielectric constant) the nanoparticles obtained by calcination at 900 °C develop a Tb deficient skin which softens the transitions, reducing the dielectric constant further.     

Structural investigations of metal clusters by HREM

Silver clusters grown by the inert gas aggregation technique have been investigated by HREM. Undistorted cuboctahedra and icosahedra together with twinned particles have been observed. Three types of nucleation and growth mechanisms are proposed which can explain the observed particle structures. The untwinned large particles are created by the coalescence of liquid- like small clusters. The twins are produced by the coalescence of solid subunits.     

CO laser stabilization using the optogalvanic Lamb-dip

Frequency stabilization of the CO laser using a CO lamb-dip is achieved in the range from 5.0–6.3 m. The CO saturation signal is obtained from a low-pressure discharge in absorption and is detected using optogalvanic, detection. The frequency stability and reproducibility has been verified to be better than 100 kHz; this is an improvement of more than one order of magnitude compared with locking techniques using CO laser gain profiles.Alexander von Humboldt Awardee from National Bureau of Standards, Boulder, Colorado, USA     

Preparation of 1-ferrocenyl-2-methyl-1-propylamine,a highly effective chiral template in asymmetrically induced synthesis

The 1-ferrocenyl-2-methyl-1-propylamine (2a)is the most effective chiral template in asymmetrically induced peptide synthesis by stereoselective four component condensation (4CC). Two routes for the synthesis of this amine via its N,N-dimethyl derivative (12a) an described. One route involves the conversion of 12a into the corresponding azide 14a by treatment with methyl iodide/sodium azide in diglyme/water and subsequent reduction of the azide. The preferred other route consists of treating 12a with thioglycolic acid/formic acid to yield the carboxymethylmercapto derivative 9a and transformation of the latter into 2a with aqueous ammonia/ammonium chloride/mercuric chloride. Some related reactions are also discussed.     

Chiral recognition and separation of beta2-amino acids using non-covalently molecularly imprinted polymers

Non-covalently molecularly imprinted polymers (MIPs) for beta2-amino acids were prepared for the first time. N-(2-chlorobenzyloxycarbonyl)-(R)-beta2-homophenylalanine (N-2-ClZ-(R)-beta2-HPhe) was imprinted with methacrylic acid (MAA) and/or 4-vinylpyridine (4-VPy) as the functional monomers, with ethylene glycol dimethacrylate (EDMA) as the cross-linker. The MIPs made with different ratios of MAA:4-VPy were studied in HPLC mode. The results show that MIPs made with 4-VPy yielded the best chiral separation factor (alpha= 1.86) for the template molecule. The importance for an efficient separation of pi-stacking interactions between the MIPs and the template molecule is demonstrated. Racemates of Z-alpha-amino acids and beta-amino acid analogues of the template were either not or poorly resolved by the MIPs, thus demonstrating the close three-dimensional complementarity of the MIPs' recognition sites with the template.     

Photoreactivation of RNA in UV-irradiated insect eggs (Smittia sp., Chironomidae, Diptera) II. Evidence for heterogeneous light-dependent repair activities

Abstract. Two biological effects of UV radiation upon Smittia eggs are observed, both of which seem to be associated with the formation of pyrimidine dimers in the RNA (largely ribosomal) of the eggs. While irradiation of the anterior pole region causes the formation of an aberrant segment pattern (double abdomen induction), irradiation of entire eggs leads to an arrest of their development (inactiva-tion). Both UV effects are photoreversible with different action spectra of the photoreactivating light. A dose rate dependence of the photoreactivation can be observed after both UV effects. The saturating dose rate is about 6 W/m² (at 440 nm) after UV induction of double abdomens. Upon UV inactivation, the saturating dose rate level for the photoreactivating light is much higher, and a single light flash causes both a considerable biological reactivation and the disappearance of about 7 × 10⁹ pyrimidine dimers from the total RNA per egg. The results indicate the presence of heterogeneous light-dependent repair activities acting upon UV induced pyrimidine dimers in the RNA of the eggs.     

Hollow colloidal particles obtained by nano-extrusion in the presence of phospholipids

Using nano- and microsize extrusion, a simple synthetic procedure of preparing hollow monodispersed colloidal particles dispersed in an aqueous phase was developed. Hydrophobic styrene monomer containing 2-hydroxy-2-methyl propiophenone photoinitiator was forced into desired diameter membrane channels and stabilized by the hydrophobic regions of a liposome obtained from 1,2-dilauroyl-phosphocholine phospholipid in an aqueous phase. Such moieties exposed to 254-nm UV radiation polymerize monomers in the hydrophobic zone of the liposome, thus resulting in reinforced hollow vesicles. The size of such particles is controlled by the size of the membrane channels in the extruder and may vary from a few nanometers to micrometers, thus allowing the synthesis of monodisperse hollow colloidal spheres.     

Gaseous alkyne ions

Using the relative abundance of metastable ions, collisional activation spectra, field ionization kinetic measurements, isotopic labelling, appearance energy and kinetic energy release data, it is shown that linear alkyne radical cations with more than six carbon atoms do not isomerize to equilibrating structures prior to decomposition. At the shortest ion lifetimes the molecular ions of linear alkynes decompose mainly by simple β-bond fission which allows an unequivocal localization of the triple bond. At medium ion lifetimes fragmentation occurs predominantly via a McLafferty rearrangement, while at long ion lifetimes competing alkyl losses prevail. These alkyl losses occur via cyclic intermediates leading to thermochemically stable cycloalkenyl ions. All these reactions occur with a high specificity with respect to the carbon and hydrogen atoms involved and are preceded by little or no hydrogen exchange reactions.     

Release and formation of surface-localized ionic clusters (SLICs) into phospholipid rafts from colloidal solutions during coalescence

Stimuli-responsive behavior of phospholipids in the presence of ionic surfactants utilized in synthesis of MMA/nBA colloidal particles was investigated. Utilizing 1-myristoyl-2-hydroxy-sn-glycero-phosphocholine (MHPC) phospholipid, and sodium dioctyl sulfosuccinate (SDOSS) surfactant as dispersing media in H(2)O, narrow unimodal particle size distributions of methyl methacrylate (MMA)/n-butyl acrylate (nBA) copolymers were synthesized. The particle diameters were 154 nm when a SDOSS/MHPC mixture was used and 161 nm using MHPC as the only surface-stabilizing species. When such colloidal dispersions are exposed to 1.7, 3.3, and 6.7 mM aqueous CaCl(2) and KCl electrolyte solutions, surface-localized ionic clusters are generated at the film-air interface that may serve as lipid rafts composed of crystalline phases of MHPC deposited on poly(MMA)/nBA films. These studies illustrate that it is possible to control release and morphology developments of surface phospholipid rafts on artificial surfaces.     

Atomic structure of Beta-tantalum nanocrystallites.

The structural properties of beta-phase tantalum nanocrystallites prepared by room temperature magnetron sputter deposition on amorphous carbon substrates are investigated at atomic resolution. For these purposes spherical aberration-corrected high-resolution transmission electron microscopy is applied in tandem with the numerical retrieval of the exit-plane wavefunction as obtained from a through-focus series of experimental micrographs. We demonstrate that recent improvements in the resolving power of electron microscopes enable the imaging of the atomic structure of beta-tantalum with column spacings of solely 0.127 nm with directly interpretable contrast features. For the first time ever, we substantiate the existence of grain boundaries of 30 degrees tilt type in beta-Ta whose formation may be well explained by atomic agglomeration processes taking place during sputter deposition.