Highly soluble and optically transparent poly (ether imide)s based on 2,6‐ or 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and aromatic bis(ether amine)s bearing trifluoromethyl groups

Two series of novel fluorinated poly(ether imide)s (coded IIIA and IIIB ) were prepared from 2,6‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride, respectively, with various trifluoromethyl‐substituted aromatic bis(ether amine)s by a standard two‐step process with thermal or chemical imidization of the poly(amic acid) precursors. These fluorinated poly(ether imide)s showed good solubility in many organic solvents and could be solution‐cast into transparent, flexible, and tough films. These films were nearly colorless, with an ultraviolet–visible absorption edge of 364–386 nm. They also showed good thermal stability with glass‐transition temperatures of 221–298 °C, 10% weight loss temperatures in excess of 489 °C, and char yields at 800 °C in nitrogen greater than 50%. The 2,7‐substituted IIIB series also showed better solubility and higher transparency than the isomeric 2,6‐substituted IIIA series. In comparison with nonfluorinated poly (ether imide)s, the fluorinated IIIA and IIIB series showed better solubility, higher transparency, and lower dielectric constants and water absorption. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5909–5922, 2006     

Preparation of AgBiVMoO/-Al2O3 Catalysts for the Partial Oxidation of Propane

A novel mixed sol method was developed for the preparation of supported catalysts. Analyses by means of XRD and BET show that a 40%AgBiVMoO/γ-Al2O3 catalyst prepared by this method possessed high specific surface area and high dispersion of the active phase. As a result, high acrylic acid selectivity of 8.5% was obtained when the catalyst was used in the reaction of propane partial oxidation to acrylic acid in a fixed-bed reactor.     

传感法研究固态钢中镧活度

本文采用LaF3单晶固体电解质测量了473～1223K温度范围内钢中镧的活度.两个平行样品的活度值符合很好,并且LaF3单晶的起始工作温度约为880K.     

Template synthesis in the nickel(II)–thiocarbohydrazide–propanone triple system

The complexing process proceeding in the Ni^II–thiocarbohydrazide (H₂N–H–NC(=S)–NH–NH₂)–propanone triple system in EtOH solution and nickel(II)hexacyanoferrate(II) gelatin-immobilized matrix has been studied. It has been found that in the first case, template synthesis leading, as a minimum, to formation of three coordination compounds of Ni^II with (N,N,S,S)-donor tetradentate ligands having NiL¹, NiL² and NiL³compositions where L¹ is 4,6,6-trimethyl-2,3,7,8-tetraazanonen-3-di(thiohydrazide)-1,9, L² is 4,6,6,12-tetrametyl-1,9-dithio-2,3,7,8,10,11-hexaazatridekadien-3,11-hydrazide-1 and L³ is 2,8,10,10,16-pentamethyl-5,13-dithio-3,4,6,7,11,12,14,15-octaazaheptadekatrien-2,7,15 is observed, whereas in the gelatin-immobilized matrix, a complexing process in the system considered does not occur.     

Organic phase conversion of bulk (wurtzite) ZnO to nanophase (wurtzite and zinc blende) ZnO

We describe the all-organic phase conversion of bulk commercial ZnO in the wurtzite modification to sub-30 nm ZnO that we find to be partially in the zinc blende [, a=4.568(3) Å] modification. The conversion involves refluxing ZnO in 2,4-pentanedione (acetylacetone) at 413 K to form the zinc 2,4-pentanedionate, which is decomposed by heating at 573 K in an appropriate high-temperature solvent such as dibenzylether to form nanophase ZnO. This nanophase, partially zinc blende ZnO can also be obtained in a single step by heating commercial zinc 2,4-pentanedionate in refluxing dibenzylether. Thermodiffractometry suggests that the conversion of zinc blende ZnO to wurtzite ZnO commences near 650 K.     

Chain-transfer constant of fluoroalcohols

Chain transfer constants of some fluoroalcohols [HCF₂(CF₂)_n?1CH₂OH, n = 2, 4, 6] in the catalyzed polymerization of vinyl acetate, styrene, acrylonitrile, and methyl methacrylate at 60°C have been evaluated by a method based on degree of polymerization. Since fluoroalcohols are normally nonsolvents for polymers, a homogeneous reaction phase is maintained by carrying out the polymerization in benzene (except in case of acrylonitrile, where no solvent was used). The transfer constants vary, depending on the reactivity as well as the polarity of the radicals, in the following order: vinyl acetate > styrene > methyl methacrylate > acrylonitrile. Of the three fluoroalcohols studied, the transfer constants increase with the increasing value of n. The results have been interpreted in terms of polar structure contribution in the transition state of the transfer reactions.     

Chemische Vitamin D<Subscript>3</Subscript>-Bestimmung in Lebertran

The different aspects of Vitamin D₃ determination and the data reported in the literature are discussed. The spectrophotometric determination of Vitamin D₃ in cod-liver oil is carried out after the alkaline saponification, extraction of unsaponified parts, precipitation of accompanying sterols and the column- and thin-layer chromatographic purification and separation of vitamin D₃ on 40 cm plates from other vitamins. The dyestuff α-naphtholbenzein is suited well as standard substance for the better location and identification of vitamin D₃ zone on the thin-layer plate. The results obtained from the chemical method were checked through the simultaneous biological determination.     

Controlled synthesis and photoluminescence properties of ZnS nanowires and nanoribbons

Rapid synthesis of wurtzite ZnS nanowires and nanoribbons has been achieved by a simple thermal evaporation of ZnS powder onto Si substrate in the presence of Au catalyst. A vapor-liquid-solid process is proposed for the formation of the ZnS nanostructures. The flow rate of the inert carrier Ar gas along with the temperature play an important role in defining the morphology of the ZnS nanostructures. The morphological change of the ZnS nanostructures and their growth sequence were studied through scanning electron microscopy. Room-temperature photoluminescence measurements showed intense blue emission at approximately 398 nm from both the nanowires and the nanoribbons.     

STUDIES ON CHARGE TRANSFER POLYMERIZATION——POLYMERIZATION OF ACRYLONITRILE INITIATED WITH PHENYL HYDRAZINE AND ITS DERIVATIVES

The photopolymerization of acrylonitrile (AN) initiated with phenyl hydrazine (PHZ) and its derivatives has been studied. The initiator exponent and monomer exponent were determined from the kinetic investigation to be 0.66th and 2.1th respectively and the overall activation energy was 33.4KJ/mol for the PHZ-AN system. Spectral analysis and other data indicate that a charge transfer complex between PHZ as a donor and AN as an aceeptor is formed. The initiation mechanism was proposed.