受激喇曼散射在掺铒光纤放大器中的影响

本文在分析了均匀掺杂分布式光纤放大器（d－EDFA）的基础上，提出了沿传输方向掺杂浓度单调下降（单变），和降升结合（两变）的两种渐变型分布式光纤放大器，并用传输方程研究了透明传输和最佳掺杂浓度下，受激喇曼散射对均匀、单变和两变型三种d－EDFA的各种特性的影响．     

Patterned uniformly orientated silicon nanocrystallite films and efficient field emission characteristics

Patterned uniformly (100)-orientated silicon nanocrystallite (SiNC) films were fabricated based on hydrogen ion implantation technique and typical electrochemical anodic etching method. The surface morphology and microstructure characteristics of the films were characterized by scanning electron microscopy, transmission electron microscopy, X-ray diffraction, and atomic force microscopy. The efficient field emission with low turn-on field of about 3.2 V/μm at current density of 0.1 μA/cm² was obtained. The emission current density from the SiNC films reached 1 mA/cm² under a bias field of about 11 V/μm. The experimental results demonstrate that the SiNC films have great potential applications for flat panel displays.     

Fuzzy集的基数

关于Fuzzy集的基数，[1]中曾对有限支集的Fuzzy集以及极苛刻条件下的无限Fuzzy集给出过一种定义。但是，正如本文将要指出的那样，该定义是不合理的。本文将从研究Fuzzy映射入手，给出Fuzzy集基数的一般性定义。基于这一定义，不但得到有关基数的大部分结论，而且有其自身的特殊性。     

1-甲基环氧乙烷-1-丙炔醚的结构测定及其核磁图谱

以¹H-NMR谱和¹³C双自旋回波的APT脉冲序列测定文献中尚未曾发表的化合物HC≡C-CH₂-O-C^CH₃-_O-CH₂文中计算了峰强度与脉冲间隔时间的关系,讨论了各谱线的相位并区分出-CH₃、-CH₂、-CH和季碳。     

HL－1装置中LHCD和等离子体参数的关系

本文研究了在ＨＬ－１托卡马克的不同放电阶段的低混杂波驱动特性。给出了驱动电流及驱动效率和等离子体参数，如电子平均密度ｎｅ、等离子体电流Ｉｐ及纵向磁场的关系。也给出和分析了波驱动和入射波功率的关系。在放电平段，对正反向驱动效率进行了研究和比较。     

快度中心区强子物质输运系数和粘滞流体演化

用Chapman-Enskog方法计算了相对论性重离子碰撞快度中心区产生的π介子物质的输运系数,并建立了相应的粘滞流体力学方程,进而讨论了粘滞对π介子物质演化过程的影响.结果表明,粘滞将减缓快度中心区π介子物质的冷却速度.     

Effect of carbon content on the microstructure and the cracking susceptibility of Fe-based laser-clad layer

The laser cladding of Fe-based alloys on a medium carbon steel substrate was performed using a CO₂ laser and Ar shielding gas that was blown into a molten pool. The microstructure and cracking susceptibility of the laser-clad layers were studied in terms of carbon additions. Results show that the small change of the carbon content in the alloy powders can obviously change the microstructure and properties of the layers. When the carbon content is in the range of 0.3–0.4 wt.%, the decrease of the carbon content in alloy powders will increase the hardness and toughness of the layers simultaneously under the same process parameters. As a result, crack-free coatings with high hardness can be obtained. As the carbon content increases from 0.2 wt.% to 0.4 wt.%, the segregation ratio of chromium increases, while the segregation ratios of nickel, manganese, and silicon first decrease and then increase. At the same time, a new designing principle concerning the composition and microstructure has been put forward, and the principal mechanisms of strengthening and toughening of the layers are fine-grain strengthening and low carbon martensitic phase transformation strengthening.     

A note on an SOR-like method for augmented systems

Golub et al. (2001, BIT, 41, 71–85) gave a generalizedsuccessive over-relaxation method for the augmented systems.In this paper, the connection between the SOR-like method andthe preconditioned conjugate gradient (PCG) method for the augmentedsystems is investigated. It is shown that the PCG method isat least as accurate (fast) as the SOR-like method. Numericalexamples demonstrate that the PCG method is much faster thanthe SOR-like method.     

氘－氚聚变等离子体中高能α粒子的诊断

本文对于用电荷交换方法或低杂波涨落的方法测量高能α粒子作了简短的评述，建议用核反应１３Ｃ（α，ｎ）１６Ｏ测量氘－氚聚变等离子体中的高能α粒子，并提出了一种减少杂质污染，增加穿透深度的方法。