Generation of UV laser light by stimulated Raman scattering in D2, D2/Ar and D2/He using a pulsed Nd:YAG laser at 355nm

A pulsed Nd:YAG laser at 355nm is used to pump Raman cell filled with D_2, D_2/Ar and D_2/He. With adequately adjusted parameters, the maximum photon conversion efficiency of the first-order Stokes light (S_1, 396.796nm) reaches 33.33% in D_2/Ar and the stability of S_1 in pure D_2 is fairly high, the energy drift being less than 10% when the pump energy drifts in the range of 5%. The conversion efficiency and stability, which are functions of the composition and pressure of the Raman medium and the energy of pump laser, are investigated. The result has been used to optimize the laser transmitter system for a differential absorption lidar system to measure NO_2 concentration profiles.     

环境对MgB_2氧化过程中MgO晶须生长形状的影响

用扫描电镜研究了在 Mg B2 氧化过程中环境对 Mg O晶须生长形状的影响。仅有 Mg B2 时 ,在 80 0℃左右空气气氛中 ,可生长出纳米尺寸的 Mg O晶须。若把 Mg B2 添加到氧化铝陶瓷基体中 ,则生长成竹节状晶须。Mg O晶须生长形状的差别可能是由于氧浓度以及位错等因素造成的。     

Low Cost, High Efficiency, Gain Flattened L Band EDFA Using FBGs as C Band Seed Generators

A low cost, coolerless 980nm diode pumped, gain flattened L band EDFA with fast transient control, high pump efficiency and gain clamping effect was realized by using FBGs as C band seed generators.     

电致发光色纯性增强的硅基有机微腔

报道了硅基有机微腔的电致发光（EL）.该微腔由上半透明金属膜、中心有源多层膜和多孔硅分布Bragg反射镜（PS DBR）组成.半透明金属膜由Ag（２０nm）构成，充当发光器件的负电极和微腔的上反射镜.有源多层膜由Al (1 nm) / LiF(05 nm) /Alq3/Alq3:DCJTB/NPB/CuPc/ITO/SiO2组成，其中的Al/LiF为电子注入层，ITO为正电极，SiO2为使正、负电极电隔离的介质层.该PS DBR是采用设备简单、成本低廉且非常省时的电化学腐蚀法用单晶Si来制备的；该PS 关键词： 电化学腐蚀 电致发光 窄峰发射 硅基有机微腔     

70K温区混合工质分凝分离循环节流制冷机实验研究

混合工质节流制冷机正在许多方面获得越来越广泛的应用。文中设计了一种新型的混合工质分凝分离循环 ,建立了实验系统 ,并在 70 K温区进行了实验。实验结果表明 ,节流制冷机可以达到 6 5 .3K的低温 ,并在 72 K温度提供 1W的制冷量 ,输入功率为 5 0 0 W。     

Spectral Anomalies in the Fraunhofer Diffraction Pattern

We study the spectral characteristics theoretically and experimentally in the Fraunhofer diffraction pattern formed by the diffraction of a spatially coherent, polychromatic light through a slit. It is found that the spectrum in some diffraction directions close to the singular direction is redshifted, compared to the spectrum of the incident polychromatic light, and blueshifted in other directions, and splits into two lines at the singular direction. We show that the experimental results are consistent with the theoretical expectations.     

Study on the Binding Characteristic of S-Naproxen Imprinted Polymer and the Interactions between Templates and Monomers

S-naproxen imprinted polymer was prepared with acrylamide as a functional monomer, 1,4-butanediyl diacrylate as a new kind of crossliner, and 2,4,6-trimethylbenzoylphenyl-phosphinic acid ethyl ester as photoinitiator. Their UV and IR spectra were applied to study the interactions between the template and the monomer. Binding experiments showed that the S-naproxen imprinted polymer had better recognition capability for the template than that of a blank polymer. The adsorption distribution coefficient KD of S-naproxen on molecularly-imprinted polymer was 153.2 g/mL, and the separation factor was 1.95 when the initial concentration of substrate was 2.0 mmol/L. Scatchard curves suggested that there were two classes of binding sites in the imprinted polymer and only one class in the blank polymer. Computer simulation using Hyperchem showed the existence of the interactions between the template and the functional monomer as well as the models of the complexes formed by the template and the monomer.     

On the hysteresis of vortex shedding in a periodically-varying flow

Efforts are made to explore the hysteresis characteristics of vortex shedding in a pipe flow, whose velocity varies periodically in time. Results obtained show that during acceleration of the flow, the vortex strength tends to be stronger, whereas during deceleration of the flow, the situation is reversed. As reconstructed from the velocity signals measured at a point in the flow field, the shed vortex arrays appear to possess uneven vortex strengths in response to periodically-varying incoming flows. Furthermore, in the hysteresis range, the streamwise spacings between the vortices appear to be unequal.     

Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

Living polymerization of styrene initiated by mercaptan/ε‐caprolactam

The bulk polymerization of styrene initiated by ?‐caprolactam (CL) and n‐dodecyl mercaptan (RSH) has been explored. This novel polymerization system shows living characteristics. For example, the molecular weight of the resulting polymers increases with conversion, and the system has the ability to form diblock copolymers and so forth. The polymer chain end contains thiol and lactam structures, which we have investigated with Fourier transform infrared, ¹H NMR, and ¹³C NMR techniques. Electron spin resonance spectra and theoretical calculations by the Hartree–Fock methods have been used to examine the mechanism. The results reveal that the initial polymerization starts from thiol via a chain‐transfer reaction, and the propagation proceeds by the insertion of a monomer between the terminal group and the intermediate structure of lactam. Finally, the polymerization kinetics have been examined. The polymerization rate varies linearly with the concentration of CL and RSH, and this confirms the mechanism. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4976–4993, 2004