Direct capillary electrophoretic determination of three chemotherapeutic drugs in human urine

Summary Capillary zone electrophoresis (CZE) has been used for direct determination of 6-thioguanine, methotrexate, and 5-fluorouracil in human urine, by use of a fused-silica capillary (60.2 cm×75 μm i.d.). Separation was performed after hydrodynamic injection for 7 s; the separation potential and capillary temperature were 25 kV and 35°C, respectively. A 45mm borate buffer solution (pH 9.2) was used as separation electrolyte. Under these conditions the analysis takes approximately 10 min and interday precision of migration times and corrected peak areas is satisfactory. A linear response over the concentration range 3.0–20.0 mg L¹ was observed for the three chemotherapeutic drugs in diluted human urine. Detection limits (s/n=3) for 6-thioguanine and methotrexate were approximately 1.60 mg L¹ in diluted human urine; that for fluorouracil was 2.60 mg L¹. A 2-ml volume of human urine was diluted with 2-mL of water and introduced directly into the electrophoresis system. CZE was shown to be a good method with regard to simplicity, satisfactory precision, and sensitivity. This method resulted in especially excellent recoveries for determination of methotrexate in all the different urine samples analysed (n=10).     

Hybridization and enzymatic extension of au nanoparticle-bound oligonucleotides

We have investigated the impact of steric effects on the hybridization and enzymatic extension of oligonucleotides bound to 12-nm colloidal Au particles. In these experiments, a nanoparticle-bound 12-mer sequence is hybridized either to its solution phase 12-mer complement or to an 88-mer template sequence. The particle-bound oligonucleotide serves as a primer for enzymatic extension reactions, in which covalent incorporation of nucleotides to form the complement of the template is achieved by the action of DNA polymerase. Primers were attached via-C(6)H(12)SH, -C(12)H(24)SH, and -TTACAATC(6)H(12)SH linkers attached at the 5' end. Primer coverage on the nanoparticles was varied by dilution with (5')HSC(6)H(12)AAA AAA(3'). Hybridization efficiencies were determined as a function of linker length, primer coverage, complement length (12-mer vs 88-mer), and primer:complement concentration ratio. In all cases, hybridization for the 88-mer was less efficient than for the 12-mer. Low primer surface coverage, greater particle-primer separation, and higher primer:complement ratios led to optimal hybridization. Hybridization efficiencies as high as 98% and 75% were observed for the 12-mer and 88-mer, respectively. Enzymatic extension of particle-bound primers was observed under all conditions tested; however, the efficiency of the reaction was strongly affected by linker length and primer coverage. Extension of primers attached by the longest linker was as efficient as the solution-phase reaction.     

Highly enantioselective Cu-catalysed asymmetric 1,4-addition of diphenylzinc to cyclohexenone

Highly enantioselective Cu-catalysed 1,4-addition of diphenylzinc to cyclohexenone has been achieved for the first time using a monodentate phosphoramidite ligand.     

Characterization of three agave species by gas chromatography and solid-phase microextraction-gas chromatography-mass spectrometry

Steam distillation (SD) extraction-solid-phase microextraction coupled to GC-MS was developed for the determination of terpenes and Bligh-Dyer extraction-derivatization coupled with GC for the determination of fatty acids such as ethyl esters were used. It was found that the three different Agave species have the same profile of fatty acids; the quantity of these compounds is different in each Agave variety. On the other hand, different terpenes were identified in the three Agave plants studied: nine in A. salmiana, eight in A. angustifolia and 32 in A. tequilana Weber var. azul.     

Amperometric multidetection with composite enzyme electrodes

The use of composite biosensors for multianalyte detection strategies is discussed. Graphite–Teflon rigid composite biosensors offer the possibility of coimmobilization of several enzymes by simple physical inclusion in the bulk of the electrode matrix with no covalent linkages. A novel trienzyme graphite–Teflon–glucose oxidase (GOD)–alcohol oxidase (AOD)–peroxidase (HRP)–ferrocene bisosensor yielded amperometric steady-state currents similar to those obtained with graphite–Teflon–GOD–HRP–ferrocene and graphite–Teflon–AOD–HRP–ferrocene electrodes for the same concentration of glucose and ethanol, respectively. The performance of the trienzyme biosensor for multianalyte detection was evaluated with the simultaneous determination of glucose and ethanol after separation by HPLC, in samples of sweet wine. The simultaneous analysis of several analytes in the same sample should imply that, with an adequate dilution, the concentration levels of the analytes can be included within the ranges of linearity of the corresponding calibration plots. The use of two composite biosensors in a parallel configuration, so that different analytes can be simultaneously detected with no need of chromatographic separation, is also discussed. The usefulness of this approach was evaluated by the simultaneous analysis of glucose and ethanol in sweet wine, and of glucose and lactic acid in red wine.     

Flow injection determination of bismuth in urine by successive retention of Bi(III) and tetrahydroborate(III) on an anion-exchange resin and hydride generation atomic absorption spectrometry

Bismuth as BiCl₄⁻ and BH₄⁻ ware successively retained in a column (150 mm × 4 mm, length × i.d.) packed with Amberlite IRA-410 (strong anion-exchange resin). This was followed by passage of an injected slug of hydrochloric acid resulting in bismuthine generation (BiH₃). BiH₃ was stripped from the eluent solution by the addition of a nitrogen flow and the bulk phases were separated in a gas–liquid separator. Finally, bismutine was atomized in a quartz tube for the subsequent detection of bismuth by atomic absorption spectrometry. Different halide complexes of bismuth (namely, BiBr₄⁻, BiI₄⁻ and BiCl₄⁻) were tested for its pre-concentration, being the chloride complexes which produced the best results. Therefore, a concentration of 0.3 mol l⁻¹ of HCl was added to the samples and calibration solutions. A linear response was obtained between the detection limit (3σ) of 0.225 and 80 μg l⁻¹. The R.S.D.% (n = 10) for a solution containing 50 μg l⁻¹ of Bi was 0.85%. The tolerance of the system to interferences was evaluated by investigating the effect of the following ions: Cu²⁺, Co²⁺, Ni²⁺, Fe³⁺, Cd²⁺, Pb²⁺, Hg²⁺, Zn²⁺, and Mg²⁺. The most severe depression was caused by Hg²⁺, which at 60 mg l⁻¹ caused a 5% depression on the signal. For the other cations, concentrations between 1000 and 10,000 mg l⁻¹ could be tolerated. The system was applied to the determination of Bi in urine of patients under therapy with bismuth subcitrate. The recovery of spikes of 5 and 50 μg l⁻¹ of Bi added to the samples prior to digestion with HNO₃ and H₂O₂ was in satisfactory ranges from 95.0 to 101.0%. The concentrations of bismuth found in six selected samples using this procedure were in good agreement with those obtained by an alternative technique (ETAAS). Finally, the concentration of Bi determined in urine before and after 3 days of treatment were 1.94 ± 1.26 and 9.02 ± 5.82 μg l⁻¹, respectively.     

Preferred conformers of proteinogenic glutamic acid

The molecular shape of proteinogenic glutamic acid has been determined for the first time. Vaporization of the solid amino acid by laser ablation in combination with Fourier transform microwave spectroscopy made possible the detection of five different structures in a supersonic jet. These structures have been identified through their rotational and (14)N quadrupole coupling constants. All conformers show hydrogen bonds linking the amino and alpha carboxylic group through N-H···O═C (type I) or N···H-O (type II) interactions. In three of them there are additional hydrogen bonds established between the amino group and the carboxylic group in the gamma position. Entropic effects related to the side chain have been found to be significant in determining the most populated conformations.     

Photochemically induced fluorescence investigation of aβ-cyclodextrin: Azure A inclusion complex and determination of analytical parameters

The photooxidation of Azure A and fluorescence properties of Azure A and its photoproduct have been investigated in aqueous media and in the presence of-cyclodextrin (-CD). The fluorescence intensity of the complex formed between the photoproduct and -CD was found to be three times higher than that of the uncomplexed Azure A photoproduct. A complex formation constant of 110±40 M^–1 was calculated using the Benesi-Hildebrand treatment of the fluorescence emission data. Although the stoichiometry of the Azure A photoproduct: -CD complex was found to be 1: 1, it seems that the Azure A structure is only partially included. Calibration graphs were plotted for the free Azure A photoproduct and the photogenerated product included in -CD. The analytical parameters and quantification limits were determined.     

Isotactic poly(propylene‐co‐1‐pentene‐co‐1‐hexene) terpolymers: Synthesis,molecular characterization,and evidence of the trigonal polymorph

Terpolymers based on propylene with 1‐pentene and 1‐hexene as comonomeric units are satisfactorily synthesized using a metallocene catalyst. Thus, several terpolymers are prepared with distinct overall compositions in comonomers as well as three different 1‐pentene/1‐hexene ratios at a given composition to evaluate the influence on polymerization activity, intrinsic viscosity, and microstructural details. The new trigonal δ polymorph is observed in those quenched terpolymers with a global content in comonomers of about 14 mol %, independently of the ratio between both comonomers. However, preliminary results indicate a profound influence of that ratio on the crystallization rate. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2013, 51, 3251–3259     

An Investigation of Inclusion Complexes of Cyclodextrins with Phenylurea Herbicides by Photochemically-Induced Fluorescence. Analytical Applications

The effect of -cyclodextrin (-CD) and hydroxypropyl--cyclodextrin (HP--CD) upon the photochemically-induced fluorescence (PIF) properties of four phenylurea herbicides, including linuron, diuron, isoproturon and neburon has been studied. Photochemical conversion of these nonfluorescent herbicides into strongly fluorescent photoproducts was shown to occur in -CD and HP--CD aqueous media. The influence of pH, UV irradiation time and photoproduct stability on the fluorescence intensity was also investigated. In addition, the stoichiometry and formation constants of the complexes formed between herbicides and -cyclodextrin (-CD) or 2-hydroxypropyl--cyclodextrin (HP--CD) were determined. The formation constant values, ranging from 184 ± 40 to 1498 ± 245 M^-1, were calculated by applying the iterative nonlinear regression (NLR) approach to the PIF data. Linear calibrations graphs were established in the interval 1–12 g/mL, for diuron, linuron and neburon. The IUPAC limits of detection ranged between 580 and 700 ng/mL, according to the compound. Application to the analysis of phenylurea herbicides in spiked river water was also described.