Eigenvalue equalization filtered-x algorithm for the multichannel active noise control of stationary and nonstationary signals

The FXLMS algorithm, which is extensively used in active noise control, exhibits frequency dependent convergence behavior. This leads to degraded performance for time-varying and multiple frequency signals. A new algorithm called the eigenvalue equalization filtered-x least mean squares (EE-FXLMS) has been developed to overcome this limitation without increasing the computational burden of the controller. The algorithm is easily implemented for either single or multichannel control. The magnitude coefficients of the secondary path transfer function estimate are altered while preserving the phase. For a reference signal that has the same magnitude at all frequencies, the secondary path estimate is given a flat response over frequency. For a reference signal that contains tonal components of unequal magnitudes, the magnitude coefficients of the secondary path are adjusted to be the inverse magnitude of the reference tones. Both modifications reduce the variation in the eigenvalues of the filtered-x autocorrelation matrix and lead to increased performance. Experimental results show that the EE-FXLMS algorithm provides 3.5-4.4 dB additional attenuation at the error sensor compared to normal FXLMS control. The EE-FXLMS algorithm's convergence rate at individual frequencies is faster and more uniform than the normal FXLMS algorithm with several second improvement being seen in some cases.     

Sub-harmonic response from polymer-shelled contrast agents with a 40-MHz excitation

There is a growing interest in using acoustic contrast agents with high-frequency ultrasound (> 15 MHz) in order to better visualize microcirculation. Experiments were performed with polycaprolactone-shelled agents (POINT Biomedical, San Carlos, CA) having mean diameters of 0.56, 1.1, and 3.4 mum. The agents were heavily diluted in filtered water and injected through a 200 mum channel into the focal zone of a 40-MHz transducer that had a focal length of 12 mm and an outer diameter of 6 mm. Backscatter signals from single agents were digitized using tone bursts of 5 to 20 cycles at peak-negative pressures of 0.6 to 6.3 MPa. 1000 valid single-bubble backscatter events at each exposure condition were digitized and then analyzed for 20-MHz subharmonic content. The data showed that the subharmonic response was initiated between 5 and 10 cycles and the likelihood of a subharmonic event increased as the number of cycles increased. A subharmonic backscatter response was most likely at 3.9 MPa for the 3.4 mum agent and 1.7 MPa for the 0.56 and 1.1 mum agents. The increased pressure for subharmonic activity for larger agent was consistent with its larger size.     

Some rules forS(-2k) dipole sums?

Stieltjes conditions and the ratio test provide necessary but not sufficient conditions onS(-2k) dipole sums. If the dipole sums are accurate the associated [n, n –1] Padé approximant provides a better representation of (), the frequency-dependent dipole polarizability, than a truncated series expression and, in addition, should bound () below. It is shown how constraints on the dipole sums effect the form of the [2,1] Padé approximant and an additional constraint is derived that ensures the analyticity of the approximant on 0 < ₁. There then follows a discussion of the reliability of available literature dipole sum values for small molecules containing H, C, N and O.     

Deformation gradients for continuum mechanical analysis of atomistic simulations

We present an expression developed for calculating an atomic-scale deformation gradient within atomistic simulations. This expression is used to analyze the deformation fields for a one-dimensional atomic chain, a biaxially stretched thin film containing a surface ledge, and a FCC metal subject to indentation loading from a nanometer-scale indenter. The analyses presented show that the metric established here is consistent with the continuum mechanical concept of deformation gradient (which is known to have a zero curl for compatible deformations) in most instances. However, our metric does yield non-zero values of curl for atoms near loaded geometric inhomogeneities, such as those that form the ledges themselves and those beneath or adjacent to the indentation contact region. Also, we present expressions for higher order gradients of the deformation field and discuss the requirements for their calculation. These expressions are necessary for linking atomistic simulation results with advanced continuum mechanics theories such as strain gradient plasticity, thereby enabling fundamental, atomic-scale information to contribute to the formulation and parameterization of such theories.     

Familial aggregation of early-onset myocardial infarction

Although ischemic heart disease tends to cluster in families, previous studies have reported a modest (2-fold increased risk) to strong (10-fold increased risk) contribution of family history to the explanation of disease occurrence. The authors assessed the familial aggregation of early-onset myocardial infarction in 11,307 adults aged <65 years who participated in the Third National Health and Nutrition Examination Survey. Logistic regression was used to obtain odds ratios (ORs) and 95% confidence intervals (CIs). A parental history was more common in those with (n = 237) than in those without (n = 11,070) a myocardial infarction (19.8 vs. 7.9%, p < or = 0.01). Adults with a parental history were also more likely to have multiple risk factors for cardiovascular disease (OR for four or five risk factors compared with none: 2.9, 95% CI: 1.4, 6.3). After multivariate adjustment, the likelihood of myocardial infarction was more than three times greater among adults with a parental history than among those without (95% CI: 1.7, 6.7). A maternal history of myocardial infarction was strongly associated (OR = 6.1, 95% CI: 2.1, 17.4) with an increased likelihood of myocardial infarction, and a paternal history was associated with a 3-fold (95% CI: 1.5, 6.3) increased likelihood of myocardial infarction after adjustment for cardiovascular disease risk factors. These results suggest a familial aggregation of early-onset myocardial infarction and show that family history is strongly associated with cardiovascular disease risk factors.     

Genetics in primary care: a USA faculty development initiative

The Genetics in Primary Care (GPC) project is a USA national faculty development initiative with the goal of enhancing the training of medical students and primary care residents by developing primary care faculty expertise in genetics. Educational strategies were developed for the project by an executive committee with input from an advisory committee, comprising individuals with primary care, medical education and genetics expertise. These committees identified the key issues in genetics education for primary care as (1) considering inherited disease in the differential diagnosis of common disorders; (2) using appropriate counseling strategies for genetic testing and diagnosis, and (3) understanding the implications of a genetic diagnosis for family members. The group emphasized the importance of a primary care perspective, which suggests that the clinical utility of genetic information is greatest when it has the potential to improve health outcomes. The group also noted that clinical practice already incorporates the use of family history information, providing a basis for discussing the application of genetic concepts in primary care. Genetics and primary care experts agreed that educational efforts will be most successful if they are integrated into existing primary care teaching programs, and use a case-based teaching format that incorporates both clinical and social dimensions of genetic disorders. Three core clinical skills were identified: (1) interpreting family history; (2) recognizing the variable clinical utility of genetic information, and (3) acquiring cultural competency. Three areas of potential controversy were identified as well: (1) the role of nondirective counseling versus shared decision-making in discussions of genetic testing; (2) the intrinsic value of genetic information when it does not influence health outcomes, and (3) indications for a genetics referral. The project provides an opportunity for ongoing discussion about these important issues.     

Total Synthesis of β-Bulnesene and 1-Epi-β-bulnesene by Intramolecular Photoaddition

dl-β-Bulnesene (1) and dl-1-epi-α-bulnesene (15) have been synthesized starting from the bromide 4 (Schemes 2 and 3). In the key step 9→10 the bonds of the final product were formed by an intramolecular photoaddition. The synthesis was completed by the fragmentation 12→14 and the Wittig reaction 14→15+1 .     

Application of Pitzer's equations on the system HCl+MnCl2+H2O at various temperatures. V.

Activity coefficients of hydrochloric acid in mixed solutions of manganous chloride at twelve ionic strengths, from 0.1 to 5.0 mole-kg^–1, were obtained from emf measurements of cells without liquid junction at five temperatures from 5 to 45°C. The data were interpreted in terms of the simple and convenient Pitzer treatment. Activity coefficients for manganous chloride in the mixtures were also derived using Pitzer's equations. Hydrochloric acid follows Harned's rule fromI=0.1 to 3.0 mole-kg^–1, as concluded by Downes, whereas quadratic terms are warranted fromI=3.5 to 5.0 mole-kg^–1. Contrary to Downes' conclusion, Harned's rule clearly does not hold true for manganous chloride at most ionic strengths.     

Manganese‐Catalyzed Hydrofunctionalization of Alkenes

The manganese‐catalyzed hydrosilylation and hydroboration of alkenes has been developed using a single manganese(II) precatalyst and reaction protocol. Both reactions proceed with excellent control of regioselectivity and in high yields across a variety of sterically and electronically differentiated substrates (25 examples). Alkoxide activation, using NaO^tBu, was key to precatalyst activation and reactivity. Catalysis was achieved across various functional groups and on gram‐scale for both the developed methodologies with catalysts loadings as low as 0.5 mol %.