The orientation-selective growth of LaNiO3 films on Si(100) by pulsed laser deposition using a MgO buffer

Highly (100)-oriented, (110)-oriented and polycrystalline LaNiO₃ (LNO) films were successfully prepared on Si(100) using an oriented MgO film as a buffer. It was somewhat surprising to find that that the orientation relation between the LNO film and the corresponding MgO buffer was: LNO(100)\MgO(110), LNO(110)\MgO(111) and LNO(polycrystalline)\MgO(100). The crystalline quality of the LNO films was shown to be sensitive to the preparation conditions of the MgO buffer. The film surface was very smooth, without micrometer-sized droplets being observed. All LNO films were of metallic conductivity, with a room-temperature resistivities of approximately 250, 280 and 420 μΩ cm for the (110)-oriented, (100)-oriented and polycrystalline LNO, respectively. Received: 2 April 2001 / Accepted: 23 October 2001 / Published online: 3 June 2002     

Ground-state properties of LiV2O4 and Li1-xZnx(V1-yTiy)2O4

We present susceptibility, microwave resistivity, NMR and heat-capacity results for Li_1-xZn_x(V_1-yTi_y)₂O₄ with 0 ? x ? 0.3 and 0 ? y ? 0.3. For all doping levels the susceptibility curves can be fitted with a Curie-Weiss law. The paramagnetic Curie-Weiss temperatures remain negative with an average value close to that of the pure compound Θ≈ - 36 K. Spin-glass anomalies are observed in the susceptibility, heat-capacity and NMR measurements for both type of dopants. From the temperature dependence of the spin-lattice relaxation rate we found critical-dynamic behavior in the Zn doped compounds at the freezing temperatures. For the Ti-doped samples two successive freezing transitions into disordered low-temperature states can be detected. The temperature dependence of the heat capacity for Zn-doped compounds does not resemble that of canonical spin glasses and only a small fraction of the total vanadium entropy is frozen at the spin-glass transitions. For pure LiV₂O₄ the spin-glass transition is completely suppressed. The temperature dependence of the heat capacity for LiV₂O₄ can be described using a nuclear Schottky contribution and the non-Fermi liquid model, appropriate for a system close to a spin-glass quantum critical point. Finally an ( x / y , T )-phase diagram for the low-doping regime is presented. Received 16 March 2001 and Received in final form 30 October 2001     

Expansion of monomer units in poly(ethylene terephthalate) molecules under conditions of thermal and zero-point atomic vibrations

The temperature dependence of the expansion ?_C of trans conformers of the carbon skeleton of macromolecules in crystallized and amorphous poly(ethylene terephthalate) (PET) due to zero-point and thermal atomic vibrations is investigated by IR spectroscopy. It is found that the thermal expansion coefficient β_C jumpwise increases at the characteristic temperatures T _t and T _b. This increase is associated with the crossover from the quantum to classical statistics of torsional and bending vibration modes. The quantum and classical contributions to the expansion ?_C are determined for each mode. The quantum and classical contributions of the torsional vibrational mode in the amorphous polymer are approximately 1.5 times larger than those in the crystallized polymer. This effect is caused by an increase in the anharmonicity of torsional vibrations in the amorphous polymer.     

Stability of steady nonisothermal flow in a vertical layer with permeable boundaries in the microconvection model

The problem of the stability of steady convective viscous incompressible fluid flow in a vertical layer with boundaries at different temperatures is considered in the presence of transverse blowing through the layer. The complete spectral problem is solved for a silicon melt. The neutral curve is constructed and the critical Grashof number is found. The numerical calculations show that the presence of transverse blowing significantly affects the flow stability. As compared with the Oberbeck-Boussinesq model, in the microconvection model the instability develops at lower wavenumbers.     

Changes in the kurtosis parameter of super-Gaussian beams passing through a spherically aberrated lens

Based on the Collins formula and irradiance moments definition, the propagation of the kurtosis parameter of super-Gaussian beams through a spherically aberrated lens is studied. Detailed numerical results are given. It is shown that, as compared with aberration-free super-Gaussian beams, the profile of spherically aberrated super-Gaussian beams can be leptokurtic, mesokurtic or platykurtic, depending on the aberration and propagation distance. The results for the spherically aberrated Gaussian beams can be dealt with as a special case treated in this paper. Finally, the advantage of our method is pointed out.     

CdSe和ZnO量子点的拉曼光谱研究

本文介绍了用拉曼光谱研究CdSe和ZnO两种Ⅱ Ⅳ族量子点材料的结果,对拉曼峰进行了指认。观察到的光学声子峰位的移动被认为是由量子限制效应引起。     

Analysis of tunable diode-laser spectra of Q(J,0) lines in CH3F near 1475 cm using a multispectrum fitting technique

We have analyzed the methyl fluoride ^RQ(J,0)Q branch lines located near 1475 cm⁻¹ using a simultaneous multi-spectrum fitting technique. In this analysis we have used previously recorded diode-laser data in which we collected many data points covering only one or two Q branch lines in a particular run. The analysis consists of simultaneously fitting 57 spectra collected with numerous pressure and path length conditions for all absorption lines. The data are concatenated to create one continuous spectrum of the Q branch. We have determined the intensity and self-broadened widths at 296 K for 23 ^RQ(J,0) lines.     

Matrix perturbation theory for driven three‐level systems with damping

We investigate the dynamics of the Λ system driven by two resonant laser fields in presence of dissipation for coupling strengths where the rotating‐wave approximation starts to break down. This regime is characterised by Rabi frequencies being approximately equal or smaller than the field frequencies. A systematic procedure to obtain an expansion for the solution of the Bloch evolution equations of the system is presented. The lowest contribution results to be the well‐known rotating‐wave approximation. The method is based on a semi‐classical treatment of the problem, and its predictions are interpreted fully quantum mechanically. The theory is illustrated by a detailed study of the disappearance of coherent population trapping as the intensities of the fields increase.     

Comparison of two models for managing reliability growth during product design

Relying on reliability growth testing to improve system designis neither usually effective nor efficient. Instead it is importantto design in reliability. This requires models to estimate reliabilitygrowth in the design that can be used to assess whether goalreliability will be achieved within the target timescale forthe design process. Many models have been developed for analysisof reliability growth on test, but there has been much lessattention given to reliability growth in design. This paperdescribes and compares two models: one motivated by the practicalengineering process; the other by extending the reasoning ofstatistical reliability growth modelling. Both models are referencedin the recently revised edition of international standard IEC61164. However, there has been no reported evaluation of theirproperties. Therefore, this paper explores the commonalitiesand differences between these models through an assessment oftheir logic and their application to an industrial example.Recommendations are given for the use of reliability growthmodels to aid management of the design process and to informproduct development.