A comparison of steady-state evoked potentials to modulated tones in awake and sleeping humans.

Steady-state evoked potential responses were measured to binaural amplitude-modulated (AM) and combined amplitude- and frequency-modulated (AM/FM) tones. For awake subjects, AM/FM tones produced larger amplitude responses than did AM tones. Awake and sleeping responses to 30-dB HL AM/FM tones were compared. Response amplitudes were lower during sleep and the extent to which they differed from awake amplitudes was dependent on both carrier and modulation frequencies. Background EEG noise at the stimulus modulation frequency was also reduced during sleep and varied with modulation frequency. A detection efficiency function was used to indicate the modulation frequencies likely to be most suitable for electrical estimation of behavioral threshold. In awake subjects, for all carrier frequencies tested, detection efficiency was highest at a modulation frequency of 45 Hz. In sleeping subjects, the modulation frequency regions of highest efficiency varied with carrier frequency. For carrier frequencies of 250 Hz, 500 Hz, and 1 kHz, the highest efficiencies were found in two modulation frequency regions centered on 45 and 90 Hz. For 2 and 4 kHz, the highest efficiencies were at modulation frequencies above 70 Hz. Sleep stage affected both response amplitude and background EEG noise in a manner that depended on modulation frequency. The results of this study suggest that, for sleeping subjects, modulation frequencies above 70 Hz may be best when using steady-state potentials for hearing threshold estimation.     

Estimation of multivariate binary density using orthogonal functions

In this paper, the authors studied certain properties of the estimate of Liang and Krishnaiah (1985, J. Multivariate Anal. 16, 162–172) for multivariate binary density. An alternative shrinkage estimate is also obtained. The above results are generalized to general orthonormal systems.     

Characterization of low molecular weight hydrocarbon oligomers by laser desorption/ionization time-of-flight mass spectrometry using a solvent-free sample preparation method.

A new solvent-free sample preparation method using silver trifluoroacetate (AgTFA) was developed for the analysis of low molecular weight paraffins and microcrystalline waxes by laser desorption/ionization time-of-flight mass spectrometry (LDI-TOFMS). Experiments show that spectral quality can be enhanced by dispersing AgTFA directly in liquid paraffins without the use of additional solvents. This preparation mixture is applied directly to the MALDI probe. Solid waxes could be examined by melting prior to analysis. The method also provides sufficiently reproducible spectra that peak area ratios between mono- and bicyclic alkane peaks indicated variations in the cycloalkane content of paraffin samples. Dehydrogenation of hydrocarbons observed during the desorption/ionization process was studied by analysis of alkane standards.     

Design of neutral, mono- or di-cationic water-soluble trihydrazidophosphoradamantanes

The versatile behavior of a trihydrazidophosphoradamantane allowing the synthesis of a variety of neutral, mono- or di-cationic water-soluble molecules of potential interest for biphasic catalysis is reported.     

A detailed study of the generation of optically detectable watermarks using the logistic map

A digital watermark is a visible, or preferably invisible, identification code that is permanently embedded in digital media, to prove owner authentication and provide protection for documents. Given the interest in watermark generation using chaotic functions a detailed study of one chaotic function for this purpose is performed. In this paper, we present an approach for the generation of watermarks using the logistic map. Using this function, in conjunction with seed management, it is possible to generate chaotic sequences that may be used to create highpass or lowpass digital watermarks. In this paper we provide a detailed study on the generation of optically detectable watermarks and we provide some guidelines on successful chaotic watermark generation using the logistic map, and show using a recently published scheme, how care must be taken in the selection of the function seed.     

Effects of annealing conditions on the electrical properties of Bi4-xNdxTi3O12 (x = 0.46) thin films processed at low temperature

Neodymium-substituted Bi₄Ti₃O₁₂ (BNdT) thin films were prepared by a chemical solution deposition technique on platinum- coated silicon substrates. All of the samples were annealed at the relatively low temperature of 600 °C by a rapid thermal annealing process in different atmospheres, such as O₂, air, and nitrogen, and vacuum. Irrespective of different annealing atmospheres, all of the BNdT thin films exhibit good ferroelectric properties, such as a saturated hysteresis loop, good fatigue endurance, and low leakage current density. A large remanent polarization (P_r) of ∼48 μC/cm² with an electric field of 240 kV/cm was observed from the BNdT thin film annealed in O₂ atmosphere. The BNdT thin films annealed in nitrogen and vacuum, at reduced oxygen partial pressures, exhibit smaller P_r than that annealed in oxygen. The difference of P_r of the BNdT thin films annealed in different atmospheres may originate from differences in the grain sizes and the number of oxygen vacancies. PACS 77.55.+f; 77.80.-e; 77.80.Fm; 81.15.-z     

Solid-phase epitaxy of CaSi2 on Si(1 1 1) and the Schottky-barrier height of CaSi2/Si(1 1 1)

Thin Ca films were evaporated on Si(1 1 1) under UHV conditions and subsequently annealed in the temperature range 200–650 °C. The interdiffusion of Ca and Si was examined by ex situ Auger depth profiling. In situ monitoring of the Si 2p core-level shift by X-ray photoemission spectroscopy (XPS) was employed to study the silicide formation process. The formation temperature of CaSi₂ films on Si(1 1 1) was found to be about 350 °C. Epitaxial growth takes place at T≥400 °C. The morphology of the films, measured by atomic force microscopy (AFM), was correlated with their crystallinity as analyzed by X-ray diffraction (XRD). According to measurements of temperature-dependent I–V characteristics and internal photoemission the Schottky-barrier height of CaSi₂ on Si(1 1 1) amounts to qΦ_Bn=0.25 eV on n-type and to qΦ_Bp=0.82 eV on p-type silicon.     

Compact integration operators for Fréchet-space-valued measures

Many operators in Banach spaces occur as the integration operator of a suitable vector measure; their compactness is completely described in [19]. However, many important spaces X in analysis (and integration operators in such spaces) do not fall into this scheme because X is not normable. Characterizing the compactness of integration operators in this setting is the aim of this note. The methods and techniques employed are quite different to the Banach space arguments used in [19].     

On the geometry of infinite cyclic subgroups

In this paper we construct an example of a word metric on an infinite cyclic subgroup. This example shows that subexponential distortion does not obstruct non-trivial growth of connected radii. This answers a question of Gromov [6]. The constructed metric has other pathological properies. Specifically, its asymptotic cone depends on the choice of ultrafilter and scaling sequence. The work has been partially supported by the Swiss National Science Foundation.     

Rigidity and finiteness under Ricci curvature and volume controls

Consider the class of closed Riemannian manifolds M of dimension dim(M) \geqq 3 \dim(M) \geqq 3 , Ricci curvature Ric(M) \geqq -(n - 1) \textrm{Ric}(M) \geqq -(n - 1) , diameter diam(M) < D and almost maximal volume. We show that the isomorphism types of fundamental groups characterize the diffeomorphism types of manifolds in such a class. In particular, it can be viewed as a generalization of the well-known Mostow‘s rigidity theorem and a finiteness theorem.