Comprehensive chemical derivatization for gas chromatography-mass spectrometry-based multi-targeted profiling of the major phytohormones

In the present investigation we report selection of the N-methyl-N-(tert.-butydimethylsilyl)trifluoroacetamide (MTBSTFA) reagent as the most comprehensive derivatization protocol among 17 tested reactions covering trifluoroacetylation, pentafluorobenzylation, methylations, and trimethylsilylations. MTBSTFA allowed easy and robust tert.-butyldimethylsilyl derivatization of 1-aminocyclopropane-1-carboxylic acid, indole-3-acetic acid, (+/-)-jasmonic acid, salicylic acid, (+/-)-abscisic acid, meta-topolin, and trans-zeatin. Detection limits as analysed by selected ion monitoring quadrupole GC-MS were 0.2, 0.01, 1.0, 0.02, 0.3, 0.3, and 0.9 pmol of injected substance, respectively. Analysis of gibberellic acid A3, trans-zeatin riboside and (+/-)-abscisic acid-beta-D-glucopyranosyl ester was best when coupled by splitting extracts and trimethysilylation. The MTBSTFA derivatization protocol was optimised, and validated. The preparation was insensitive to 2% residual water and to < or = 1 day storage at room temperature. The final scheme was highly reproducible and successfully applied to extracts from approximately 300 mg (fresh mass) of tobacco (Nicotiana tabacum) root and Arabidopsis thaliana seedling.     

New approach to calibrating conductivity meters in the low conductivity range

There is currently a major issue with the calibration of conductivity meters used for high purity water: the lack of availability of a reference material or reference methods for low conductivity ranges (conductivity below 1 S cm^–1 at 25.0 °C, resistivity >1 M cm at 25.0 °C). This paper describes the current status of conductivity measurements in high purity water. A new and improved approach, currently being investigated, should allow us to make the calibration of conductivity meters used for low conductivity ranges traceable to the SI.Milipore, Milli-Q and Elix are registered trademarks of Millipore Corporation.     

Composition and morphology of stack emissions from coal and oil fuelled boilers

Instrumental neutron activation analysis (INAA) together with scanning electron microscopy (SEM) have been used in the study of fly ash from large electric power and heating plants. Two basic kinds of fly ash originating either from brown coal or heavy-oil combustion can be characterized both by morphology and trace element composition. INAA technique used consisted of both short (1 min) and long (2 h) activations to ensure the determination of 30–40 elements in each fly ash sample. The average composition and determination limits obtained by INAA for coal fly ash produced in several electric power plants burning two kinds of brown coal have been compared with those obtained for fly ash originating from heating plants burning heavy-oil. Coal fly ash showed much higher concentrations of many elements especially of Sc. La, Th, Cs, Ce, Sm, Rb and Al in comparison with oil fly ash. On the other hand, the latter contained relatively high concentrations of V and Ni. The results of INAA of fly ash samples can be used for the projection of efficient separating devices and for the evaluation and prediction of contamination levels in the vicinity of large emission sources.     

Oxidative dearomatization of phenols and anilines via lambda(3)- and lambda(5)-iodane-mediated phenylation and oxygenation

Treatment of 2-methylphenols with chloro(diphenyl)-lambda(3)-iodane led to their regioselective dearomatizing 2-phenylation into cyclohexa-2,4-dienone derivatives via a proposed ligand coupling reaction. In the same vein of investigation, treatment of 2-methylanilines with the lambda(5)-iodane 2-iodoxybenzoic acid IBX reagent led to their regioselective dearomatization into previously undescribed ortho-quinol imines.     

Determination of enantiomeric excess and degree of hydrogenation in the enantioselective hydrogenation of ketopantolactone

Summary A new gas chromatographic method for the simultaneous determination of the degree of hydrogenation of ketopantolactone and the enantiomeric excess of pantolactone does not require any derivatisation.

---

Bestimmung von Enantiomerenüberschuß und Hydriergrad bei der enantioselektiven Hydrierung von Ketopantolacton (Kurze Mitt.)

Zusammenfassung Zur Bestimmung des Hydriergrads von Ketopantolacton und des Enantiomerenüberschusses von Pantolacton wird ein neues gaschromatographisches Verfahren eingesetzt, das keine Derivatisierung erfordert.

     

Deprotonation-electrophile trapping of terminal epoxides

Organolithium-induced deprotonation of terminal epoxides in the presence of appropriate diamine ligands allows trapping with a range of electrophiles, yielding functionalised di- and tri-substituted epoxides in good yields and with control of stereochemistry at the epoxide.     

Radioanalytical quality control of11C,18F and123I-labelled compounds and radiopharmaceuticals

Radiochemical quality control using high performance high pressure liquid chromatography and, to some extent, gas chromatography is described for a variety of carrier-free¹¹C-,¹⁸F-and¹²³I-labelled compounds and radiopharmaceuticals. The particular problems associated with the handling of carrier-free compounds labelled with short-lived radionuclides are outlined, and chromatographic data are given for the separation and purification of such products.     

Laser-excited molecular flourescence spectrometry for the determination of traces of nonmetals : Part 1. determination of traces of fluoride,chloride and bromide based on diatomic molecules in a graphite furnace

For the determination of flouride, chloride and bromide, a suitable metal ion is added in a modified graphite tube atomizer. After drying and ashing, the substances are vaporized and diatomic molecules between the metal and nonmetal are formed. These molecules are excited by a pulsed dye laser and the resulting fluorescence is measured. At constant metal concentration, the fluorescence is proportional to the halide concentration. The diatomic molecules used are MgF, InCl and AlBr. The detection limits are 11 pg of fluoride, 15 pg of chloride and 70 pg of bromide in the 10-μl injections, corresponding to 6 x 10^?8 mol l^?1 fluoride, 4 x 10^?8 mol l^?1 chloride and 9 x 10^?8 mol l^?1 bromides.     

Determination of polycyclic aromatic sulfur heterocycles (PASH) in diesel fuel by high performance liquid chromatography and photodiode-array detection

An oxidation method (sulfone method) for the determination of polycyclic aromatic sulfur heterocycles (PASH) in diesel fuel is presented. The aromatic fraction of a diesel fuel, isolated by solid phase extraction, is oxidized under controlled conditions with hydrogen peroxide. The oxidation products, mainly methylated dibenzosulfone, are determined and quantified directly, without further clean-up, by HPLC with photodiode-array detection.